Question about 2001 Jeep Cherokee

1 Answer

Problem with new automatic gearbox

Gearbox replaced as lost 3rd&4th gear now problem between 4th&5th gear and reverse car lurches

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 112 Answers

Your gear linkages are refitted in the wrong way.

Posted on Jan 26, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The Pacifica will not shift past 4th gear. It shifts normally through 1st, 2nd, 3rd, and 4th gear. Their is no high reeving RPS, no clunking, no lurching. It will just not shift past 4th gear.


is there an OD button that might have been pressed .if it has lots of miles on it it could be needing a flush job . last one I got done was around 100.00 at jiffy lube.

Nov 12, 2015 | 2005 Chrysler Pacifica

1 Answer

2003 chevrolet cavalier, manual transmission lost 2nd, 4th and reverse but still has 1st, 3rd and 5th gears.


Sounds like one of the levers inside the transmission is either broken or otherwise disengaged. Remove the shifter to see if you can see any obvious reason.

Aug 25, 2012 | 2003 Chevrolet Cavalier

1 Answer

Hi i have lost 2nd,4th and reverse gears could you tell me what is wrong i still have 1st,3rd and 5th gears and how i can fix this thanks


The linkage arms inside the gearbox are defective - the only way to fix that is to take out the gearbox from the car, dismantle it completely and replace the linkage arms, a very long and complicated job that can be done only by a repair shop and it will be expensive.

Apr 29, 2011 | 1990 Isuzu Spacecab

1 Answer

5th gear went out yesterday when u put it in 5th its 3rd gear. Then today reverse 1st and 2nd went out. Reverse 1st and 5th is 3rd and 2nd and 4th both is 4th gear


time to put a new tranny in that jet most of the time it costs to much to repair it then replace it i have done may tranny rebuilds and replacements to me i would just tell you to replace it at least you will get a better warrentee and stuff

Feb 27, 2011 | 1988 Volkswagen Jetta

2 Answers

Took a bolt out of top of gearbox thinking it was


The trans may need to be diassembled to fix. Manual transmissions dont have filters.

Jul 24, 2010 | 1999 Isuzu Rodeo

1 Answer

Tranny problem 1st gear wont work really and its hard to get 2nd gear but 3rd,4th,and 5th work fine plus reverse works fine. do i need to replace the clutch? or is it sumthing else that wont let me get in...


There is problem in the gearbox.The sincronizers for a first & second gear are on the same gearswitch.Need to change them.Forget about the clutch.

May 16, 2010 | 1998 Volkswagen Jetta

1 Answer

My ford focus tdi 2003 cant select 1st,3rd or 5th gears.


Car is in limp in mode unless you have the tools to work on automatic transmission you will need to take it to a transmission shop. Of course you can check oil level but I suspect you have other issues.

Mar 26, 2010 | 2003 Ford Focus

1 Answer

I HAVE A SLIGHT PURRING SOUND FROM THE ENGINE... WHEN I PUT THE CLUTCH IN IT STOPS... ALSO WHEN IM IN 1ST, 2ND AND 3RD GEAR WHEN IM ACCELERATING THERE ISNT A GOOD SOUND FROM IT!! BUT ITS FINE IN 4TH AND...


This would be most likely the first noise of a wearing input shaft bearing. It will only get louder, and eventual failure of the bearing will probably mean catastrophic gearbox failure. It stops when you put your foot on the clutch because the gearbox stops spinning then, and it is quiet in 4th and 5th because there is no side loading (as there is in 1st, 2nd, and 3rd) on the failing bearing. It wouldn't matter what sort of car it was, the gearbox should be overhauled as soon as possible.

Sep 25, 2009 | 2005 Suzuki Swift

1 Answer

1st, 3rd & 5th gear


how about the 4th gear?

if its fine in the 4th gear, its your transmission. if you have automatic I would try to replace the auto trany computer if you could find it at the wrecking yard.

Aug 14, 2009 | 2003 Hyundai Santa Fe

1 Answer

Only 3rd and 4th gears available - 1998 jetta


im not telling you what to do because it could be a bad transmission and an easy fix but I cant tell without looking at it , but if its a hard fix just go to a reliable junkyard and get another

Aug 11, 2009 | 1997 Volkswagen Jetta

Not finding what you are looking for?
2001 Jeep Cherokee Logo

Related Topics:

53 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...