Question about 2004 Isuzu Ascender
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
i assume that you have a trailer light attachment installed at the rear of the vehicle somewhere around the tow hitch,turn on your head lights,obtain a volt meter and check D.C. voltage on the pigtail,ground the black lead to clean frame metal and check the pins on the plug with the red lead,one of them should be live 12v dc.that will be your trailer running lights,theother will be brake lights,you will have to have someone hold trheir foot on the brake to test it,dont assume the trailer is ok. verify voltage at the connector on the vehicle first,if you have 12 v,there the trailer has the problem,or if it hasnt been used in a long time the connector may need to be cleaned,as far as the fuse goes depending how it was installed,could be several choices,set your meter on continuity and check all fuses,you dont have to phisically remove each one,if you look close there are two small contact points on both sides of the amp rating number,most likely you will have two or three fuse panel locations,primary is under dash drivers side ,secondary panels and relays located in engine compartment under hood on fender walls black plastic box w/cover,,also may be on the sides of the dash board,can only see when the door is open ,or behind the ashtray in the center console,replace any fuses that are blown,be aware of the plug configuration on the car to the trailer,and that the ground wire on the car side of the plug is also the ground lead on the trailer connector, wires may have got mixed up during repair,happens to the best of us once in a while,clean ground connections are very important on trailers,old rusty wires and scerws should be removed wire brushed and reinstalled,or replaced if needed,then sealed with varnaloc,or spray paint,to protect them,hope this helps you.aloha from maui todd0708
Posted on Oct 01, 2009
Tips for a great answer:
Mar 01, 2015 | 2003 Isuzu Ascender
Jan 20, 2015 | 2003 Isuzu Ascender
Sep 29, 2014 | 2005 Isuzu Ascender
Apr 18, 2014 | 2005 Isuzu Ascender
Apr 17, 2014 | 2005 Isuzu Ascender
Nov 05, 2013 | 2003 Isuzu Ascender
Sep 07, 2013 | Cars & Trucks
Dec 23, 2012 | 2003 Isuzu Ascender
May 22, 2017 | 2003 Isuzu Ascender
Jan 31, 2010 | 2004 Isuzu Ascender
50 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: