Question about 1992 Volvo 240

1 Answer

Engine swap What is the Bosch unit on the driver side fender panel of my my 1992 240 just forward of the coil ?It is square, has wires going in the back side and a lot of metal hoses going down to the frame. I am planning to put this engine into a 1991 Volvo, and wonder if I am going to use this unit , because the 191 model does not have one.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 31 Answers

No you will not need that. that is the abs unit.

Posted on Jan 19, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Fuel pump relay 1989 dodge ram charger le 150


its on the driver side in the engine compartment on the side fender looks square with a electrical wire going into it... there's two similar, one is for the a/c i believe the relay is about inch squared ...i hope this helps

Oct 15, 2014 | 1989 Dodge Ramcharger

1 Answer

Temp gauge peaks on 1993 dodge spirt


I have similar problem in that my rad cooling fan won't run when hooked up to temp sending unit. Sending unit works okay, displaying what seems like proper temps on inside gauge, rising & falling with engine temp. However, my fan does NOT turn on when wire unplugged from sending unit. Tested fan motor with 12v applied directly & it runs fine, so motor okay.

Haynes manual identified a faulty cooling fan relay (in a situation with your symptoms), which is mounted on the drivers side fender of the engine compartment with 1 other on a support bracket (2 others on same bracket if you have ABS), facing forward toward headlight (NOT nearby ones that are parallel to fender, which has 3 relays on a support bracket). This should work in your case, but didn't in mine.

Several of these close-together relays have the same # on them, so you could swap 2, to see if this is your problem, since normally 2 or 3 relays wouldn't fail at same time. To be sure, I bought a new generic relay of proper # from local auto parts store -- about $10-12 I think -- and installed it in the right place but fan still didn't work. Swapped the 2 relays next to each other (there are only 2 on my forward-facing bracket), both with same #, and still no go.

I'm TOTALLY STUMPED on mine, but yours should work with a functioning relay of proper #. Let me know how it goes.

If anyone has suggestions for my related problem, I'm all ears!

Jun 20, 2014 | 1993 Dodge Spirit

1 Answer

Need the firing order for a 2006 Suzuki Forensa


ok there is no cap on a 2006 2.0 it has a coil pack and the computer sends the ground signal to fire the coils the coils are fired 2 at a time 2 and 3 then 1 and 4,,together,, passenger side of the engine is number 4 driver side is 1,,, coil should be wired as it is marked on the coil.if u r standing in front on the driver side fender and the coil is mounted in place..then the right further most side starts number 4 then 1 then 2 then 3

May 26, 2012 | Suzuki Forenza Cars & Trucks

2 Answers

Where do I locate the flasher unit in the 1998 Hyundai excel hatchback?


the flasher unit is usually under the dash on the drivers side, it may be a square or round unit about 2" long with a connector plug on to.....hope this helps......cheers.

Jun 26, 2011 | 1989 Hyundai Excel Hatchback

1 Answer

Backfire- just replaced plugs and wires and now have a backfire, need wiring diagram to make sure replacement was correct switched from champion platinum plugs to bosch 2 platinum and bosch wires


Cylinders 1-3-5 are on the back side of the engine. Cylinder 1 is the passenger side and cylinder 5 is the drivers side.

Cylinders 2-4-6 are on the front of the engine. Cylinder 2 is on the passenger side and cylinder 6 is on the drivers side.

The coil pack will have the cylinders labeled at each post.

Oct 01, 2010 | 2002 Chrysler Town & Country

2 Answers

Wheres th ignition coil @ on a 96 mazda 626,4 cyl.?


The ignition coil is located in the Distributor. It not a separate piece.

Feb 12, 2010 | 1996 Mazda 626

2 Answers

1990 jeep cherokee starts but when you let off the key it dies already replaced thi ign switch


the fuel pump runs on 2 diffierint circuts. one when the key is engaging the starter motor when you are starting the engine, and the other is to power the fuel pump after you release the key when the engine is running. there is a resistor on the drivers side on top of the inner fender that you can over ride with a jumper wire to check. if it needs to be replace its about $5.00. (its a ceramic thing about 2 inches long and bout 3/4 inches square.

Nov 07, 2009 | 1990 Jeep Cherokee Limited

3 Answers

Fuel pump not working, were is the relay?


it is in the power distribution box under the hood, on top of the driver side fender. you will notice that the A/C has the same type of relay. Just be careful with the swapping. Thanks

Oct 16, 2009 | 1993 Dodge Caravan

1 Answer

COIL?


90 to 98 legacy (mine is a 98) coil should be the square-ish black unit with two sparkplug wires coming off laterally from each side--------sitting right on top of engine--middle of the silver colored alloy intake manifold--just behind alternator.
...The low voltage wire leads plug into the passenger side of the coil unit--covered with the flexible black protector--within which are 3 wires. Likely can tap here.

Aug 08, 2009 | 1992 Subaru Legacy

2 Answers

2002 Mustang blowing PCM fuses


with all due RESPECT to You Are NOT AT WITS end Most People Don't Know To Take the first step You Did Electrical Can Make you Think you Are at Wits End That's All You Got this<<<
The Wire That Shows Continuity and Blows the Fuse & what Component it Controls are the Problem YES Open The Harness There Could Be A Potentual FIRE in there Open it to Be sure it has not Damaged any other Wires and or anything Hasnt Damaged IT ALSO. This Does Not end here so Don't Rate Me Unless You Find this Truely Helpfull Let Me Know You FIND
ANY MODIFICATION TO STOCK WIRING HAS THE POTENTUAL TO DESTROY A VEHICLE IF IT IS NOT DONE CORRECTLY SO BE SUSPICIOUS OF ADDONS Rate Me As Fair As You Feel. Good luck

Feb 11, 2009 | 2002 Ford Mustang

Not finding what you are looking for?
1992 Volvo 240 Logo

Related Topics:

101 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volvo Experts

yadayada
yadayada

Level 3 Expert

63801 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Mark Jones

Level 2 Expert

76 Answers

Are you a Volvo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...