Question about 1999 Chrysler 300M

3 Answers

Heater motor runs on high continuously on 1999 Chrysler 300M

Fan motor runs on high regardless of switch position. Climate control can be turned off and fan will continue on high. I've been told by dealer that its a replaceable ''resister type'' module which they had in stock but couldn't tell me where its located that I might replace it. Any ideas on where this is located and how to go about replacing it?

Posted by on

  • Anonymous Feb 12, 2009

    i have the same problem without a solution

  • Anonymous Feb 26, 2009

    Heater motor runs on high, continuously, on the automatic mode of the climate control system. Cannot find the location of th blower motor control module.

×

3 Answers

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 2 Answers

You need blower resister

Posted on Jan 19, 2009

  • Doug Meloche
    Doug Meloche Jan 19, 2009

    i believe its behind the glovbox in the centre

×

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

The module is under the bottom of the glove box.remove the bottom cover below glove box.the resister is beside the blower motor.it has 2 screws holding it in,then it just slides out

Posted on Jan 11, 2013

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

I had the same problem on my 1999 LHS of blower runing on high. This seller has them for only $58 on eBay andstates that he sells a lot of them offering the reasons and problems to look for. Worked great. His is heavy duty.
http://stores.ebay.com/SPEEDOMETER-SALES-AND-SERVICE?_trksid=p4340.l2563

Posted on Jun 07, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

I have new blower motor. it dosen't stop running


Could be a bad blower motor resistor,mounted by the blower.

Sep 28, 2016 | 2002 Dodge Ram Pickup 1500

1 Answer

Have a 2009 liberty, climate fan runs on high always, doesn't reduce speed. Also vent positions won't change direction of air


IF FAN RUNS ON HIGH ONLY AND STOPS ON ALL OTHER SPEEDS THE FAN CONTROLLER (REOSTAT) IS BAD,THE VENT POSITIONS IS A BAD SWITCH ON DASH OR BAD ACUATOR MOTOR ON VENT DOORS

Nov 19, 2014 | 2009 Jeep Liberty

1 Answer

Why wont my a/c or heater fan come on?


When the blower works only on the high setting its usually a bad blower resistor which is right near the blower motor. now you say it would always blow high regardless of the fan speed setting that would indicate probably the climate control unit or a connector problem somewhere. finally it not working at all may be the climate control unit or connection went bad even further. it might have a blown fuse or a bad blower motor in addition to the climate control unit or connector problem .check for power and ground at the blower motor. the power is supplied from fuses and may have a relay also. the ground is supplied from the climate control unit and goes through the resistor to control the fan speed. good luck

Oct 30, 2011 | 1997 Lincoln Continental

3 Answers

I have a 2002 Elantra. Yestreday the lower fan speeds on the air conditioner fan stopped working (positions 1,2,3). The High speed (position 4) works. Any ideas how to correct?


The blower motor resistors or fan switch itself are defective.
High speed has no resistors B+ goes straight to blower motor.

Jun 03, 2010 | 2000 Hyundai Elantra

1 Answer

Climate control switch does not work in lower modes only in high.


The pontiacs have an issue with the ignition switch, I have a 2001 grand prix that did the same. The ac fan would only work on 5 and the headlights would go off if on 1-4 replace the switch and all is fine.

Jun 02, 2009 | 2003 Pontiac Grand Prix

1 Answer

Blower fan does not work on low or medium only on high. Lx model has auto climate control. wondering if it is blower motor, blower resister, or control (bad contacts). All buttons work on climate control....


Sounds like the problem is more with the blower motor assembly itself. The blower motor have micro-proccers built itnto them which comunicate with the control heads and do the actual regulating of the fan motor. Dealers have computers with diagnostic software which allows them to monitor what is happening in the eletronic controls of the vehicle. Electronic diagnostics without the diagnostic software makes it very diffecult to pinpoint the actual item causing the problem.

Jan 01, 2009 | Hyundai Motor 2003 Sonata

1 Answer

No air/heat from Vents in 89 delta 88


1996 olds lss .no heat from vents which seem blocked.The fan runs

Dec 19, 2008 | 1989 Oldsmobile Delta 88

Not finding what you are looking for?
1999 Chrysler 300M Logo

580 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

71231 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22059 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7001 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...