Question about 1996 Chrysler Town & Country

1 Answer

1996 town and country van not starting

My van had been jerking and the rmps would go up and down, but just after about 10 min. of driving it. Then it would be fine. Then it started dieing every once and awhile. Now it died and won't start, it is getting gas but no fire. Someone told me it was the computer, but that cost alot so i was wondering if it could be something else?

Posted by on

  • sharon4865 Feb 07, 2009

    Got the computer and now it is running. But it still is acting up -- doing the jerking and rmps go up and down?

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

I had same problem and it was the computer my mechanic orderd on line out of Michigan only 96 computer for town and country will fit it total cost was258.00

Posted on Jan 23, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 1996 Chrysler 3.8. town and country mini van


The oil pressure light probably came on when the engine stopped.
You would have lost your power accessories then too.
Someone will need to figure out if you have lost fuel to the injectors and/or spark to the plugs to know where to look for the problem.

Jul 23, 2012 | 1996 Chrysler Town & Country

1 Answer

2003 Chrysler town & country limited


First try and change the fuel filter. this also happened on a van i worked on. I cahnged the filter and it runs fine now.

Nov 16, 2011 | 2003 Chrysler Town & Country

1 Answer

My van is a 1996 chrysler town & country ; i was driving and it shuts off and then i turn the key and it started but after that went to the store just just fine when came back to the van to start it...


Have the codes read. This will start you in the right direction. Quit taking advice from people who are guessing. The van died , the check engine light is on. read the codes and then we can help. Unless you want me to guess also.

Aug 08, 2011 | 1996 Chrysler Town & Country

1 Answer

When I drive my 1996 town and country chrysler van and I push the gas down the car loses power. It makes a loud banging sound. Sometimes it will start to go a little and **** really hard and then you can...


Has the service engine soon light come on ?

This could be caused by a lot of different things, don't replace parts until you know for sure what the problem is otherwise you will just be throwing your money away,

If the service engine soon light IS on then go to auto zone and have them get the codes, on your year you may have to have them turn the ignition key on and off five times, then count the number of flashes of the service engine soon light and then look up the codes in a haynes repair manual for your specific vehicle.

Mar 29, 2010 | 1996 Chrysler Town & Country

1 Answer

1996 town & country van front heater blower


you will need to start by checking fuse,then power to motor,then blower motor resistor

Jan 29, 2010 | 2005 Chrysler Town & Country

1 Answer

Possible transmission out not sure


When was the last time you had transmission oil changed and the tranny pan removed and the tranny filter changed? If never, this is your starting point.

The problem with these vans is that the tranny pan is at about a 20 degree angle under the transmission near the driver front tire. The problem with this design is that these pans eventually begin to leak at the lowest point of the pan, and over time you will not notice the ATF loss. Most likely your ATF level or cleanliness/viscosity may be bad.
Don't cry 'TRANSMISSION' until you get your tranny serviced (ATf oilc change, new tranny filter, clean magnets, clean pan, clean tranny).

Sep 10, 2009 | 1996 Chrysler Town & Country

1 Answer

I was driving the van and it just shut off.


Our mechanic replaced the fuel sensor in our van and solved this problem.

Apr 09, 2009 | 1996 Chrysler Town & Country

1 Answer

All the accessories are dead on my 1996 town & country .


this problem is caused by a defective BCM (body control module)

Apr 03, 2009 | 1996 Chrysler Town & Country

1 Answer

1996 CHRYSLER TOWN & COUNTRY TRANS AXLE PROBLEM.


i had same toublre on 96 plymouth output speed senor my wont shift out of second

Dec 06, 2008 | 1996 Chrysler Town & Country

Not finding what you are looking for?
1996 Chrysler Town & Country Logo

Related Topics:

321 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

chargerhp
chargerhp

Level 3 Expert

813 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...