Question about 2003 Saturn L-Series

Open Question

How to program the BCM on 2003 saturn l200 - 2003 Saturn L-Series

Posted by Anonymous on

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 10865 Answers

SOURCE: WHERE IS THE FUEL PUMP LOCATED IN A 2003 SATURN L200

Hello. The fuel pump on this car is located within the fuel tank. Joe

please mark my answer as very helpful. thank you.

Posted on Apr 23, 2010

Ad
  • 1 Answer

SOURCE: bcm installation for saturn l series

The estimate for my 2000 Saturn LS-1 was around $500.00. I would suspect it should be around this much for your wagon since it is basically identical regarding the BCM. It is easy to get to the BCM so a relatively mechanically savvy person could change it on your own but it has to be programmed which will require the mechanic anyway.

The problem is that apparently, since Saturn has been dissolved the BCM's are getting hard to come by. The dealer is unable to order one for my car. You may have more luck with a 2003.

Posted on Jul 17, 2010

  • 21 Answers

SOURCE: relay switch for ac is not working in my 2003 L200

Should be a electrical box under thehood labeled fuses and relays. Locate the fan relay by looking at the diagram underthe box and change it out, It unplugs.

Posted on Jul 24, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to replace BCM on Saturn 2003 L200


You take it to the dealer ! Need's to be programmed .

Body Control Module (BCM) Programming/RPO Configuration

The body control module (BCM) must be programmed with the proper RPO configurations. The BCM stores the information regarding the vehicle options and if the BCM is not properly configured with the correct RPO codes, the BCM will not control all of the features properly. Ensure that the following conditions exist in order to prepare for BCM programming:
• The battery is fully charged.
• The ignition switch is in the ON position.
• The data link connector (DLC) is accessible.
• All disconnected modules and devices are reconnected before programming.
To setup a new BCM, use the Tech 2 in conjunction with the Saturn Service Stall System . Refer to Service Programming System (SPS) in Programming.
If the BCM fails to accept the program, perform the following steps:
• Inspect all BCM connections.
• Verify that the scan tool has the latest software version

Feb 15, 2017 | Mitsubishi L200 Cars & Trucks

1 Answer

How can I reset the BCM on a 2003 Saturn L200?


disconnect battery cable for a few minutes. diagnose bcm power supply circuitry and wiring.

Mar 15, 2015 | Saturn Cars & Trucks

2 Answers

Were is the BCM of a Saturn ion 2003 transmission manual


Above the glove box. It's attached above it.

Feb 25, 2015 | 2003 Saturn ION

1 Answer

My 2003 L200 Saturn fuel pump quit working at 100010 mile. The garage has replaced it 2 times now in the last 100 miles. They have no idea what is causing it. It is now out again.


You will need it at a shop that can run diagnostics on saturns. I sure hope you can find an independent shop, and not have to take it to a GM dealership, who like people with big fat wallets.
You will need probably a high end scanner to scan the body control module. I think, but not positive, that the bcm has a hand in fuel pump control.
Go here and post your question. There is a tech there called saturntech who can answer all Saturn questions.http://www.2carpros.com/makes/saturn/l200.
Or go there and search. they do answer free questions. They also have a donation program to keep the site up and going, but do not require donations.

Jul 30, 2013 | Cars & Trucks

1 Answer

Just had 03 l200 bcm repaired at aes how do i get it to work now


Any PCM, BCM, or ignition switch assembly that's replaced requires what's described as a Passlock re-learn procedure to synchronize the three subassemblies for proper operation. This either takes place at Saturn or during a 30-minute DIY procedure in three 10-minute cycles. The procedure is basically to leave the ignition ON for 10-minutes, cycling the ignition OFF and then ON for another 10-minutes and once more until repeated three times, never starting at any time. After the third cycle the ignition can be turned to start the engine to confirm that all components have successfully been synchronized. A failure to start means an incorrect re-learn procedure was done and needs to be repeated all over again. The security light will flash during the process and eventually turn off altogether as indication of successful re-learing security codes for any new part replaced. What isn't changed are the VIN and mileage that Saturn equipment can do. The security system is divided into three parts; the ignition switch sensors, the PCM, and the BCM. Any one of these subassemblies being replaced requires the BCM to relearn the new replacement part otherwise you'll just have a dead engine unable to run. New BCM's come as blanks that Saturn address' with their Techtool II with VIN and mileage copied from the failed BCM. 'Field' BCM's removed from vehicles still retain VIN and mileage that can only be changed by Saturn. There may be other programmed accessories that have to considered to be compatible to the original one removed for replacement.

key remotes

Replacing the BCM will require the remotes to be reprogammed. The problem is that you need a scan tool with the proper software to perform the programming. Here is the procedure for reprogramming if you have access to a tool. If not you should put a call into a local garage that does diagnostic work or the dealer. If it were just a battery change you could resync without programming.

Jul 14, 2012 | 2003 Saturn L-Series

1 Answer

My 2001 L200 Saturn has body control module problems. The mechanic just had it reprogrammed at a Chevy dealership, but he didn't replace the BCM. We've had it back for a couple of days, and so far, it...


reprograming is very common, this is done all the time even with newer cars, some times cars new newer or diffrent programing installed in them and dealer is the only one that can do it unless someone has a dealer scan tool.As far as replacing it would depend on the problem and i think the dealer would of told them the computer was bad. hope this helps.

Sep 18, 2010 | 2001 Saturn SL

1 Answer

How fix fuel gage on 2003 saturn l200


either the fuel sender in the gas tank is bad or the bcm is bad,most likely sender

Sep 22, 2009 | 2003 Saturn L-Series

1 Answer

Bcm installation for saturn l series


The estimate for my 2000 Saturn LS-1 was around $500.00. I would suspect it should be around this much for your wagon since it is basically identical regarding the BCM. It is easy to get to the BCM so a relatively mechanically savvy person could change it on your own but it has to be programmed which will require the mechanic anyway.

The problem is that apparently, since Saturn has been dissolved the BCM's are getting hard to come by. The dealer is unable to order one for my car. You may have more luck with a 2003.

Jun 19, 2009 | 2003 Saturn Lw 4dr Wagon

1 Answer

2003 Saturn Ignition and Security System Troubles


Sorry to say but it's probably the BCM (body control module) that's going in her car. The BCM controls everything inside your car, from the gauges, locks, daytime running lamps, ABS... and yes the security system. I have a 2003 L200 which had the same problem and I had to replace the BCM at some cost ($400-$600) depending on where you go. The L-Series Saturns seem to have a problem with their BCMs and it seems that it's pretty prevalent. Unfortunately it will only get worse as time goes on and it's not something that you can do yourself as it needs to be programmed by the dealer. You also will need to get your remotes reprogrammed as well with the new BCM. Hope this helps.

Nov 24, 2008 | 2003 Saturn L-Series

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

359 people viewed this question

Ask a Question

Usually answered in minutes!

Top Saturn Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8274 Answers

Are you a Saturn Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...