Question about 2004 Nissan Armada

Open Question

How to install a oil pump for a nassan armada 2004

I want to install my oil pump for a 2004 nassan armada suv, but need some type of instruction in taking the oil pump out and putting the oil pump back in. My pressure gauge keep reading high for oil when turn on and I keep hearing a funny sound when I turn on the engine. I need to know how to install pump and sensor to high and low pressure gauge also.

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

jschoon77
  • 55 Answers

SOURCE: Nissan armada Tire Pressure Sensor Stays on

I have replaced lots of Tire Pressure Monitor (TPM) sensors due to dead batteries. The batteries are not replaceable, so you have to replace the whole sensor, which is part of the valve stem.

You will have to take your vehicle to your local dealer because they have to use CONSULT-II, the Nissan scan tool, to program the new sensor to the vehicle.

These sensors usually run in the $100 range.


Hope this is helpful!!!


Nissan Scope Technician- 10+ years experience in Nissan dealership

Posted on Nov 11, 2008

dennymulford
  • 1055 Answers

SOURCE: oil pressure needle at H

sounds like an oil pressure sening unit un plug it whilf its running and see if the gauge goes too zero,if not then the prob is the gauge, the sending unit is only about 15.00 at auto zone and easy too put in

Posted on Jan 28, 2009

CPU solution
  • 164 Answers

SOURCE: Oil pressure gauge reads high all the time when

even when you first start it? if so its def a bad gauge you may want to have someon look at it... if it does it after several min then you could either have a bad gauge still or even something wrong internally your best bet is to have it checked! hope this helps

Posted on Jan 09, 2010

  • 566 Answers

SOURCE: 2004 nissan maxima...can hear the abs pump while

hi from uk the only thing i would be concerned about at this moment is the grinding when brakes applied ? this sounds very much like your brake pads are very low and most likely worne to the point of damage(grinding metal to rotor contact) is the sound you hear also the abs will sense this and due to unbalance of braking to each wheel abs will operate however i would have thought your car may have low pads warning indicator light system fitted but may not ? may i suggest considering age and possible high milage of your car ? if you have not had pads inspected recently? you do so asap b4 you drive any distance especially at speed ?

Posted on Feb 27, 2010

Ironfist109
  • 3018 Answers

SOURCE: My 2005 Nissan Armada is

  • Well it could be a bad oil pump or a bad Oil Sending Unit. If you have an oil pressure gauge you can pull the sending unit and stick the pressure gauge in there and see what the reading is. I would thing 60PSI would be suitable.
  • I believe this Oil Sending Unit is on the front (possibly the back) of the oil pan.
  • Just remove the connector and put a wrench (or a deep socket) and twist it out and replace with a new one.
  • Make sure the oil filter is snug and not leaking as well.
  • Check your oil level too and make sure it is properly filled.
  • Good luck and thank you for using FixYa.

Regards, Tony

Posted on Jun 13, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2004 Nissan Armada wont grab a gear


I'm assuming automatic transmission. Check your fluid level immediately. If low(hopefully the issue) add required fluid, start vehicle and idle a minute to pump fluid back through system and try putting in gear again. If this solves the issue then you most likely have a leak some where. If fluid level is ok, you will need to see a transmission specialist.

Aug 07, 2015 | 2004 Nissan Armada

1 Answer

Camshaft for nassan quest 3.5 car shutdown while


Replace the timing belt. Remove the head and replace the bent valves. While you are at it replace the cam shaft oil seals and the crank shaft oil seal and the idler pulley and hydraulic adjuster and the job will last another 100.000 miles

Oct 30, 2013 | Cars & Trucks

1 Answer

What are some cause of oil flow restictions


Assuming the crankcase is full of oil, I doubt the cooler would cause a drop in pressure. Only a small percentage of oil flows thru the cooler.
It could be the pump or strainer, but could also be worn bearings.
The first thing you should do is have the pressure checked with a mechanical gauge to make sure your electric gauge is correct.

Jan 11, 2013 | 2005 Nissan Armada

2 Answers

2004 nissan armada want start like out of fuel


Check you fuel pump relay. located on IPDM marked as ECM relay in the picture. Just change places of ECM RELAY and FOG LAMP relay and try to start. If it starts change the ECM relay. good luck
2004-nissan-armada-want-start-like-out-gl0xs2s0pqcfqvyesya4nbi0-3-0.jpg

Jul 07, 2012 | 2004 Nissan Armada

1 Answer

2005 nissan armada oil gauge


no,,, fluctuations mean =low oil pressure,oil level low,oil old or too thin viscotly,oil pump loosing or not develloping the correct pressure
pressure release valve spring weakened

Jul 06, 2010 | 2005 Nissan Armada

1 Answer

The oil pressure gage is on high


oil pressure sensor is stuck or maybe oil pump is clogged.

Feb 05, 2010 | 2004 Nissan Armada

1 Answer

Change oil


Set parking brake and use jack stands if you raise the vehicle.
1. Remove engine front undercover.
2. Warm up engine. This is need for the oil to flow freely when draining.
3. With engine stopped loosen oil filler cap and then remove drain plug.
4. Drain oil into a drain pan.
5. Install drain plug with new washer. Tighten to 25 ft-lb.
6. Remove oil filter using a filter wrench.
7. Make sure the surface is free of foreign materials.
8. Apply engine oil to the seal and install your new Nissan filter. Tighten filter 2/3 turn after contact with surface or 13 ft-lb.
9. Refill engine with 6 quarts of oil.
10. Start engine and check for leaks.
11. Stop engine and check oil level and add to the full line.
12. Reinstall engine front undercover.

Dec 20, 2009 | 2004 Nissan Armada

Not finding what you are looking for?
2004 Nissan Armada Logo

Related Topics:

109 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

713 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...