Question about Cars & Trucks

1 Answer

Does a 93 cutlass supreme have a blenddoor

My car heater operates on vacume hoses

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

Yes but its a pain to get at its up under the dash and that should still run with a cable

Posted on Jan 04, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 321 Answers

SOURCE: 1995 cutlass supreme transmission

It physically will fit and bolt up,but there are many different ratio,and drive and driven sprocket tooth counts,different final drive ratios,all monitored by the computer with electronic speed sensors.If the trans from the 95 has a different ratio than the 93,the computer will set gear ratio error codes,and possibly put the trans in a failsafe mode,stuck in 2nd or 3rd gear.On the transmission case,down by where the passenger side axle would go in,is a thin metallic tag,maybe 2"x 3",and it has bar codes,and also a series of numbers and letters.The numbers and letters,large cap,are the final drive gear ratio code.They should match on the two transmissions in question.

Posted on Jul 31, 2008

muttandjeff
  • 359 Answers

SOURCE: 93 olds cutlass . oil pressure gauge when started car todaygauge did not moveoil level fineruns perfectguage just at low end of guage

2 things come to mind check the negative terminal of battery and the ground wire connected to engine location varies where they connect these but will always originate from neg on battery a quick check to see if you have a proper ground connection is to take one booster cable and connect to neg post on battery and connect the other end to the engine on clean metal (be sure to keep clear of moving parts ) start engine and see if you have pressure on gage if so you must clean ground connection to engine .if this does not correct possible bad sending unit in side of block with one wire connected to it . caution ** temperature sending unit look similar so make sure with one you are taking out

Posted on Dec 23, 2008

  • 7 Answers

SOURCE: Automobile cooling fan problem.

There are two relays for the cooling fans, one or both may be bad.
With the engine running and the AC on, the fan should be running.
With the engine hot the fan should cycle. I believe the relays are mounted on the drivers side front fender on that model.

Posted on Sep 24, 2009

arauzvictor1
  • 466 Answers

SOURCE: 1986 Oldsmobile Cutlass Supreme vacuum hose

Ok sent you this the engine you have to specify that engine has to help you. Thanks2c36ea6.jpg

Posted on Mar 24, 2010

Testimonial: "good job getting info. and real quick too"

  • 1024 Answers

SOURCE: location of fuel filter on 93 oldsmobile cutlass

under the car in rear

9460f94.gif

Posted on Mar 29, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Heater wont warm up on 93 cutlass supreme


If the heater hoses are getting hot, and the radiator is full of coolant, it could be a faulty blend door under the dash.

Jan 03, 2013 | 1993 Oldsmobile Cutlass Supreme

1 Answer

Heat wont work in my 93 cutlass supreme, blower works, just no heat.


Make sure there is antifreeze in the radiator and then try replacing you heater core.

Dec 29, 2010 | 1993 Oldsmobile Cutlass Supreme

1 Answer

Rear spark plugs how to get. to them 93 olds cutlass supreme


You have to disconnect the air duct, remove the recovery bottle and place aside with removing any hoses. Remove the torque strut to engine bolts. Push the struts out of the way then use a pry bar to rotate the engine forward. You can put the pry bar in the passenger side bracket for leverage. Then use a ratchet strap to hold the engine in place.

Jul 16, 2010 | 1993 Oldsmobile Cutlass Supreme

1 Answer

Need a transverse spring for 1194 cutlass supreme


that's what most people call it, go to the local salvage yard get one off a 92-93-94 olds, chev luminia

Mar 17, 2010 | 1995 Oldsmobile Cutlass Supreme

2 Answers

Repair 1994 oldsmobile cutlass supreme thermostat


There's a slight anti freeze smell when you turn the heater on. All fuild r full just wander if the heater core leaking. nothing wet inside the car just a smell

Dec 14, 2009 | 1994 Oldsmobile Cutlass Supreme

1 Answer

95 Cutlass Supreme Fan only blows on lower vent


It's been awhile but I think the doors are vacum operated

Aug 25, 2009 | 1995 Oldsmobile Cutlass Supreme

1 Answer

1996 Olds Cutlass Supreme 3.4, over revving intermittently when in Park.


first thing is to check for vacum leaks. Those motors are very tempermental with vacum leaks. check the plenum area... if they are original then they are suspect.

Jun 19, 2009 | 1995 Oldsmobile Cutlass Supreme

1 Answer

Air will not get hot


Try flushing the heater core with a garden hose.

Mar 14, 2009 | 1994 Oldsmobile Cutlass Supreme

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

13 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...