Question about Cars & Trucks

1 Answer

When you put it in reverse it wont stay in gear it wants to pop out and grind and clunk but it will try to go backwords alitte bit

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Cars & Trucks Master
  • 937 Answers

If the kickstand switch stays/fails open, with the bike in gear it will die ... Do you hear the fuel pump spin up when you turn on the bike? ... up... if they have clean them up, check the gaps and try again.----------------------------------------------------------------------------------------
porsche piwis cable

Posted on Jan 04, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 84 Answers

SOURCE: 1996 jetta trekk no reverse

Sounds like you'll need a new reverse gear set. Not really an easy fix you have to remove and open the transmission. If you have too much metal in the oil you might need a new transmission seeing it probally already damaged much more like other syncros or bearings inside.

Posted on Oct 31, 2008

  • 1 Answer

SOURCE: popping or grinding noise when placed in reverse

check the rear dif.

Posted on Nov 24, 2008

  • 14036 Answers

SOURCE: my 92 honda accord will not go into 1st 3rd or 5th gear

check shift fork adjustment. make sure you bleed the slave cylinder.also check shift cable adjustment.

Posted on Apr 11, 2009

  • 462 Answers

SOURCE: have a 97 tahoe when put in reverse transfer case

There is a snap ring at the back of the transfer case that breaks. It can be fixed without removing the transfer case. Remove the rear driveline and the small housing at the back of the case. The snap ring holds the bearing in place.

Posted on Aug 23, 2009

TDISLine
  • 1874 Answers

SOURCE: 1997 jetta with manual transmission. for some

Check up and adjust the transmission cable, shift rod, and selector fork of gearbox. See picture below.
08ff7a8.png

Posted on Dec 09, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 BMW 323ci 2.5l 6cylinder manaul transmisson 1st gear wont stay in gear. pops out and grinds so i just avoid 1st gear and take off in 2nd. What is causeing 1st gear to do that?


possible explanation is a failing bearing on the input shaft or counter shaft
possible alignment problem between bell housing and motor
( uneven tension of mounting bolts )
check drain plug magnet for metal bits

May 08, 2017 | BMW Cars & Trucks

1 Answer

How do i add transmission fluid? Why won't it stay in reverse gear?


VWVortex.com - 1997 MK3 Jetta 2.0L 8v 5spd Reverse Gear Problem ...

forums.vwvortex.com > ... > Golf III & Jetta III
Dec 8, 2006 - 25 posts - ‎18 authors Hello, I have a 1997 MK3 Jetta 2.0L 8v 5spd my reverse gear is ... car in reverse- always, not even a little rolling, i have found that vw trannys r .... Member MKIII_96'sAvatar .... misalignment and problems with the transmission staying in gear. .... You can ask a hundred ways, but it won't change the answer/s. Won't go into 5th gear.
25 posts
Apr 17, 2009
1996 Jetta 2.0 5spd - No Reverse
10 posts
Jan 5, 2009
Car won't go into REVERSE!!! WTF? Any ideas?
25 posts
Nov 14, 2008
Transmission Shift Lever Stuck in Park - or, Key ...
25 posts
Nov 13, 2005
More results from forums.vwvortex.com

Volkswagen Cabrio Questions - pops out of reverse ...

www.cargurus.com > Questions > Volkswagen > Cabrio
CarGurusMar 26, 2012 - My 96 Cabrio pops out of reverse then makes grinding noise. ... worse case is the reverse gear has a few teeth missing which is a common problem in 97 and older ... Won't stay in reverse 1 answer ... 1991 Volkswagen Passat.

Oct 27, 2015 | 1996 Volkswagen Jetta

1 Answer

Why is it grinding and won't go into park or pull after changing cv boot?


sounds like spline not seated in coupling recheck shaft connection into trans

Aug 02, 2015 | 2002 Nissan Maxima

1 Answer

1989 Ford F 150 lariat 4x4 pick up pops out of reverse and makes a terrible grinding noise until it's put back in noise is coming from transfer case fluids have been checked and changed no shavings also...


You must have a manual transmission. Rebuild it. synchronizers are bad. The reason for grinding. Then you have worn shift forks. Reason for popping out of gear. Also replace any worn bearings or just get the bearing kit and replace them all, with the races.

Sep 30, 2014 | 1989 Ford F 150

1 Answer

Manual transmission reverse is blocked


Hi Mitch, If when engaging first gear you have a grinding and clunk try pumping the clutch pedal before engaging reverse. My reason for saying that is that if the pedal takes low to the floor you may have a defective hydrolic clutch line. If it doesn't work I think I would suspect a bent selector rod. Regards John

Jun 24, 2012 | 1990 Chevrolet K1500

1 Answer

1997 jetta with manual transmission. for some reason it wont stay in reverse. It will pop out and grind. all other gears seem fine. Any ideas?


Check up and adjust the transmission cable, shift rod, and selector fork of gearbox. See picture below.
08ff7a8.png

Dec 09, 2009 | 1997 Volkswagen Jetta

2 Answers

Engine runs vehicle wont move Possible ring gear? 84 Topaz


Is it a metal shaft? When you put it in drive does it make any noise? Does the speedometer move? Does it make a loud clicking sound when you put it back in Park?

May 23, 2009 | 2002 Ford Explorer

1 Answer

Possible Tranny problem...


I am sorry to have to tell you this but it sounds to me like your transmission is shot and will need a rebuild. If you can get it to a transmission shop they will tell you 100% what wrong with it. .

Apr 06, 2009 | 1998 Dodge Grand Caravan

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

13 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...