Question about 2005 Honda CR-V

Open Question

2005 Honda CR-V gauge cluster stopped working

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 113 Answers

SOURCE: Gauge Cluster

YES ITS JUST A COUPLE OF PLUGS AND SOME DASH TRIM,

Posted on Jun 12, 2008

EnginEar
  • 57 Answers

SOURCE: honda cr-v stopped working after battery replacement

I bet a vacuum hose got knocked off during the battery swap. Look for any small hoses disconnected. Check near the back of the engine, too. there should be a hose that goes from your brake's master cyclinder to the back of the engine. I suspect that one.

Posted on Apr 26, 2009

  • 31 Answers

SOURCE: 1995 Honda Civic fuel gauge stuck onfull.

the fuel level sensor in the gas tank needs to be replaced easy way is a new fuel pump assembly

Posted on Oct 19, 2009

  • 5 Answers

SOURCE: why do only half the cluster lights work and the

this is most likely a short in your electrical system, on a newer Honda it can get expensive, i recommend taking your car to a foreign car doctor and have them analyze the problem

Good Luck...

Posted on Apr 13, 2010

johnf1aresti
  • 1098 Answers

SOURCE: where is water temp sensor location on a honda integra ZXI 89

should be on the rear side of the cylinder head,above the gear box side.

Posted on Sep 26, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have CRV 2005 Temp gauge goes to H and Fuel gauge goes to E when I turn the car on. Why?


Two different systems/areas. Would need to see it on a scanner. Could be both sensors are bad. Most likely though the instrument panel has a bad ground internally. If it was external, all the gauges would be affected.

Aug 04, 2016 | 2005 Honda CR-V

1 Answer

Where do I find the ground unit for the gas gauge on a 95 Honda passport. I went and changed the dash board lights and the gas gauge started tripping and stopped working need help


If the fuel guage worked prior to changing the bulbs the ground should be ok. The only thing disturbed was the cluster assembly when you removed it. Recheck the connections at the back of the cluster again for tight connections and making sure there are no bent pins. You can also try tapping on the cluster near the fuel guage area to see if that helps

Jul 12, 2015 | Honda Cars & Trucks

2 Answers

My cluster on my 05 Impala isn't working, the gas gauge and temp gauge is not where they are suppose to be the speedometer works. How can I reset it without buying another cluster?


You need to test your fuses. Go through with a tester and test each one. Verify you haven't lost your ground straps running from the back of your block to the firewall.

Sep 15, 2014 | 2005 Chevrolet Impala

1 Answer

How to change dash board light


You need to remove the instrument cluster by removing the two screws on the top of the cluster. and then pulling out the lower rim to undo a couple of clips along the that border.

Jun 05, 2014 | 2003 Honda CR-V

1 Answer

07 Honda CR-V, Dash lights out, speedo inop, warning lights staying on, car runs and drives with no other problems.


hi i would take a look at the inside fuse panel in case a multiplexer box is clipped on the back of int fuse panel u r cluster is missing power or ground in u honda manual under fuses it should give u description of function and a fuse number should point u in the right direction danny

Mar 21, 2014 | 2007 Honda CR-V

1 Answer

Gauges stop working


GM had gauge cluster problems from 2000-2005. Bad stepper motors. On those units you have to replace the cluster or rebuild it with new stepper motors. Dealership fixed mine for $150.00

Jan 29, 2011 | 2005 Chevrolet Monte Carlo

1 Answer

How do i replace d4 gear indicator light inmy 1998 honda cr-v


I have a 99 CRV and I would think it would be the same. Sitting in the drivers seat remove the two screws at the top of the gauge cluster. Pull out on the top of the cover with some force and the clips that hold the bottom of the cover will release. Now remove the screws holding the gauge cluster, two top and two bottom. Pull straight out a few inches so you can turn to the side and remove the wire plugs on the back, be careful not to damage the wires. With the cluster removed there is a white box on the back that needs a small flat blade to remove. Once removed the small lamps can be replaced. Tools needed are a Philips and a small flat blade screwdriver

Jan 24, 2011 | 1998 Honda CR-V

1 Answer

I have a 2005 Trailblazer and the speedometer was working I stopped at a stoplight & it stopped working. Doesn't move at all.


Hi,

Pretty common issue with the 03-06 Trailblazers. What happens is the motor behind the gauge wears out over time, eventually more gauges will stop working or start acting crazy.

Check out this page for more details on Trailblazer instrument cluster repair.

Oct 19, 2010 | 2005 Chevrolet TrailBlazer

1 Answer

Why do only half the cluster lights work and the


this is most likely a short in your electrical system, on a newer Honda it can get expensive, i recommend taking your car to a foreign car doctor and have them analyze the problem

Good Luck...

Apr 13, 2010 | 2005 Honda Civic

2 Answers

Lights on gas gauge not lighting on 2006 Honda CR-V. Help! Thanks.


You can replace the instrument cluster bulb with a regular halogen bulb like Sierra said, or use T5 led bulbs that come in a variety of colors (white, blue, etc.) They are inexpensive and will last a lot longer than the regular halogen bulbs.

Replacing the faulty bulbs isn't too hard for DIY.
For help: Moonlight Driving lights-gas-gauge-not-lighting-2006-honda-zp00lepaloflvda1hbduq5xd-2-1.jpg lights-gas-gauge-not-lighting-2006-honda-zp00lepaloflvda1hbduq5xd-2-3.jpg lights-gas-gauge-not-lighting-2006-honda-zp00lepaloflvda1hbduq5xd-2-6.jpg

Nov 28, 2009 | 2006 Honda CR-V

Not finding what you are looking for?
2005 Honda CR-V Logo

Related Topics:

132 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7711 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...