Question about Ford Bronco

Open Question

1995 4X4 FORD BRONCO LEAKING TRANSMISSION FLUID

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

motor1258
  • 6674 Answers

SOURCE: how to replace transmission fluid on 1993 ford

Bottom pan has to come off. Grab a gasket , if none available, silicone designed specifically for that use, not just any old silicone. Do filter while your at it. Pay special attention to way filter comes off, so it goes back on same way.

Posted on Jul 12, 2009

  • 474 Answers

SOURCE: Transmission fluid leaking back, 1988 Ford Bronco

your output seal on the tranny or input seal on your transfer case is bad. you have to pull your transfer case to tell. this is a pretty straight forward job. block wheels. put transfer case in neutral. drop front and rear drive lines.diconnect transfer case shift linkage. there is a short commponent connecting the trans to the transfer case. the bolt on either end face each other. remove the bolts to the transmission. the transfer case is heavier than it looks, i suggest getting help. pull back on the transfer case until it will drop down. it will pull out a bit because of the trans output shaft. replace what will probibly turn out to be the tranny output shaft seal and reassemble in reverse order.

Posted on Nov 07, 2009

  • 196 Answers

SOURCE: how to add fluid

It goes in through the dipstick. Just use a small throat funnel, but take your time and keep checking the level. You don't want to over fill it. Check the fluid level while the engine is running, not off/cold.

Posted on Apr 30, 2010

Testimonial: "thank you very much, you're a lifesaver"

  • 130 Answers

SOURCE: Transmission is shifting hard in first gear. How

you will have to remove the trans pan to drain it and also the torque converter will have to be drained you could also adjust the band to help shifting.i would suggest that you chance the filter while your changing often neglected these inexpensine item will prolong the life of a transmission in changed at regular intervals also looks for leaky vacuum lines.make sure you follow correct procedures for refilling before restarting and the connection at the throttle body.  

Posted on Jul 12, 2010

  • 1 Answer

SOURCE: transmission leak in a 1991

I can't exceed 20 mph in my ford bronco. And my speedometer is going all over the place

Posted on Nov 04, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Leaking transmission fluid from top of transmission


that is your vent hole and it is over filled

Nov 13, 2012 | 1995 Ford Bronco

1 Answer

1989 ford bronco C6 transmission leaking fluid at manual shaft


I have a 1989 Ford Bronco 351 w with a C-6 Transmission. I just did a transmission service, replacing the gasket and filter. Now my transmission is leaking when the bronco sits for a few days.Help!!!

Aug 08, 2012 | Ford Bronco Cars & Trucks

2 Answers

Transmission leak in a 1991 ford bronco. trani fluid all over most of the engine. can't tell where it's coming from. Main puddle is under the radator.


I would say transmission cooling lines cracked or loose near or at the radiator, If so get the lines from any auto parts they should be 1/4, 5/16, or 3/8 screw the right one into the radiator tank and cut the lines to fit and use a compression union to put them together

Nov 23, 2010 | 1991 Ford Bronco

1 Answer

How to add fluid


It goes in through the dipstick. Just use a small throat funnel, but take your time and keep checking the level. You don't want to over fill it. Check the fluid level while the engine is running, not off/cold.

Apr 30, 2010 | 1986 Ford Bronco II

1 Answer

Transmission fluid leaking back, 1988 Ford Bronco


your output seal on the tranny or input seal on your transfer case is bad. you have to pull your transfer case to tell. this is a pretty straight forward job. block wheels. put transfer case in neutral. drop front and rear drive lines.diconnect transfer case shift linkage. there is a short commponent connecting the trans to the transfer case. the bolt on either end face each other. remove the bolts to the transmission. the transfer case is heavier than it looks, i suggest getting help. pull back on the transfer case until it will drop down. it will pull out a bit because of the trans output shaft. replace what will probibly turn out to be the tranny output shaft seal and reassemble in reverse order.

Nov 06, 2009 | 1988 Ford Bronco II

1 Answer

How to replace transmission fluid on 1993 ford Bronco XLT?


Bottom pan has to come off. Grab a gasket , if none available, silicone designed specifically for that use, not just any old silicone. Do filter while your at it. Pay special attention to way filter comes off, so it goes back on same way.

Jul 12, 2009 | 1993 Ford Bronco

1 Answer

Oil leaking from front of tranny 85 bronco II 4x4


Check the oil level in your transmission, I take it that it's a standard so your going to have to do it by removing the fill plug and felling for fluid. If it's low then you are losing transmission fluid though the front input shaft bearing and seal. Check the hydraulic clutch fluid, see if your losing some fluid there too, You may have a small leak bell housing.
Good luck and keep me posted.

May 29, 2009 | 1985 Ford Bronco II

1 Answer

Transmission does not shift at the proper RPM. The engine over revs before it shifts. Does Vacuum or electric shift these transmissions? If it is electric, does it have a relay?


At your Bronco's age, the vacuum hoses are suspect. The plastic ones break, the rubber ones crack and leak. There is a specific one to the transmission to control shifting, usually. Some vehicles have a modulator valve on the transmission; when it fails you will see white smoke at the tailpipe and you will lose trans fluid. Check all the vacuum lines, large and small. A vacuum gauge is a great tool, it will tell you a lot about an engine.

Apr 25, 2009 | 1992 Ford Bronco

3 Answers

Power steering leak on a 1988 full size bronco


The gear box is a common problem on this model. That would be the place I would start. A cheap, temporary fix is to go to your local parts store and ask for Lucas Power Steering Stop-Leak. It will buy you some time.

Apr 09, 2009 | 1988 Ford Bronco

1 Answer

Ford Bronco II standard tran. Has no 1st or 2nd gear.


Replace the transmission fluid. I think those used ATF, but check to be sure. (if you made the mistake of using 80/90w drain it...those transmissions were not designed for 80/90w. gear oil)

Dec 02, 2008 | 1989 Ford Bronco II

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

132 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5474 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...