Question about 1997 Subaru Outback

Open Question

Check engine light 1997 subaru legacy outback p0303, p0304

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: 1997 subaru outback legacy overheating

I've had the same problem all year. I've had four different mechanics look at this car - 97 legacy with 2.5. I've had the coolant seals replaced, the radiator cap, the thermostat, the water pump - all to no avail. I've realized now that it only overheats shortly after running sustained high rpm's. Recently the last mechanic mentioned the bleeder valve (I didn't know it had one and think maybe he didn't know either - not a subaru mechanic). Recently it overheated again (again sustained high rpm's - apparently more prone to produce air in the system), I sat the vehicle on an incline (raising the bleeder valve to be the highest point) and let the car warm up and run for half an hour. Now 300 miles and no overheat. I went through alot with this car to get to this point. Unbelievable.

Posted on Dec 26, 2008

Ad
mcgyver468
  • 710 Answers

SOURCE: Cause of noise in front differential of 1997 Subaru Legacy Outback.

there is a plug on the shaft-side of the differential. Using a ratchet remove the plug and with the engine OFF, stick your finger inside the hole and you should get fluid just below the threads of where the plug goes in.

Posted on Apr 24, 2009

gordanddar
  • 477 Answers

SOURCE: I have a 1997 Subaru Legacy Outback AWD. The

when you replaced the plugs , was one of them (cylinder 1 ) dirty and fouled ?
I'm thinking that bad rings in cylinder would give you low compression , and eventualy cause the missfire by fouling up the plug.
There is an inexpensive product that will help with the compression by filling up scratches in the cylinder walls. It is called Restore , and it is one of the only products of its type that I have used , and feel actually works.
Unfortunately , if your rings are broken , or badly worn , nothing in a bottle will fix them.

If your car had a distributor cap and rotor , I would change them too.

Posted on May 13, 2009

mx5turbo92
  • 545 Answers

SOURCE: i have a subaru legacy outback, abs light comes on

one of your abs sensor is bad or the abs motor,go to local shop to diagnose which sensor,shop usually charge $ 60 to diagnose abs system,good luck, let me know ..

Posted on Jun 04, 2009

  • 14036 Answers

SOURCE: Check engine light on. P0325, P0420 2000 Subaru

CODE PO420 CATALYST SYSTEM EFFICIENCY BELOW THRESHOLD BANK I * CODE PO325 KNOCK SENSOR NO.1 CIRCUIT MALFUNCTION BANK NO.1 OR SINGLE SENSOR

Posted on Nov 14, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Is a rear diff from a 1997 subaru legacy wagen with a 2.2l inter changeable with a 1997 subaru legacy outback with a 2.5l ?


the only way you can do this is if you can identify the gear ratios from both cars with the transmission codes found on the strut tower plate.
see this list to check for matches, read it carefully its a ton of info
subarugears narod ru

Aug 09, 2014 | 1997 Subaru Legacy

1 Answer

Can you switch a rear diff from a 1997 subaru legacy wagen with a 2.2l inter changeable with a 1997 subaru legacy outback with a 2.5l ?


the biggest draw back that you will have to check first is the ratio of the diffs you want to change. If they are not the same but will fit then you will destroy the 3rd diff in the transmission from excessive use.

Aug 09, 2014 | 1997 Subaru Legacy

2 Answers

P0303 p0304


You'll have to get someone to check the spark and injector on cylinders 3 and 4.
Code 303 is for loss of power on cylinder 3 and code 304 is the same for cylinder 4. The most common causes are lack of spark or fuel.
Once the problems are fixed the codes will need to be erased with a scanner or code reader.

Jun 11, 2013 | Subaru Cars & Trucks

3 Answers

Timing belt broke and need timing marks diagram 2.2 subaru


the timing marks are on the camshaft pulleys and there are 2 notches on each pulley> they line up with 2 marks on the engine block for each pulley> and the crankshaft has a notch that lines up with a mark on the engine block aswell> pluss the new timing belt will have white marks on it that will line up with all of the marks on the pulleys when they are in the right place so its nearly impossable to do it wrong

Apr 07, 2010 | 1997 Subaru Legacy

1 Answer

97 subaru outback 2.5- just checked the trouble codes after check engine light went on. what could be causing radiator fan problem?


Faulty cooling fan relay, faulty coolant temperature sensor, or the fan assembly itself is defective.

Feb 23, 2010 | 1997 Subaru Legacy

1 Answer

How do I reset the ''check engine'' light on my 1997 Subaru Legacy Outback wagon?


the check engine light comes on if there is a problem with thecomputer system related to the emmision, when this is is repaired the light on can only be turned off with a monitor,code reader. some of these are quite inexpensive.over the web or at a part store.

Feb 19, 2010 | 1997 Subaru Legacy

1 Answer

1998 Subaru Legacy Outback--Rough Idle


I have the same problem!Running on three.I have checked compression,wires,plugs.Changed injecters,plugs.
3 mech.cant figuire it out???

Nov 21, 2009 | 1998 Subaru Legacy

1 Answer

1997 subaru outback "check engine light" on for 6 months


try disconnecting the + positive terminal for a few minutes and see if it goes out most likely the 02 sensor needs replacing ...however low fluid levels may also contribute to this oil,brake fluid etc.

Sep 12, 2009 | 1997 Subaru Outback

1 Answer

Cause of noise in front differential of 1997 Subaru Legacy Outback.


there is a plug on the shaft-side of the differential. Using a ratchet remove the plug and with the engine OFF, stick your finger inside the hole and you should get fluid just below the threads of where the plug goes in.

Apr 24, 2009 | Subaru Outback Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

173 people viewed this question

Ask a Question

Usually answered in minutes!

Top Subaru Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6910 Answers

Are you a Subaru Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...