Question about Cars & Trucks

1 Answer

I have a passat Yr 2000. 1.8l 4 cylinders 20v turbo. When I switch the headlights on there is a beeping sound for a while and it stops. Also the Abs lights come on while am driving but the breaks a

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 3,103 Answers

Get the charging system checked for load capability when running..the regulator may be bad and the operating voltage may be too low..this will cause alarms to sound on some cars.. good luck..repost findings..

Posted on Jan 23, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

bunnydawg
  • 5158 Answers

SOURCE: VW T4 1.9td: annoying beeping sound on dashboard?

have the oil pressure checked...

Posted on Feb 26, 2009

  • 102 Answers

SOURCE: Warning Lights on dash: ABS, BRAKE,STOP,CHECK MANUAL

your abs unit is failing and needs replaced ...the procedure for testing is to backprobe green wire in abs connector and watch voltage wave pattern on a scope ....it will show voltage does not go from 0 to 12 but only 4 to 12 volts that verifies problem is abs controller.

Posted on Mar 22, 2009

  • 91 Answers

SOURCE: 2003 VW Passat "Oil Press, Turn Off Engine" and "STOP" Light

I would check the oil pressure sensor and the oil pump itself. You can take the sensor out and use a mechanical gauge to check the oil pressure. If the oil pressure is within specs, you need a new sensor, if not, you need a new pump.

Posted on Apr 13, 2009

  • 7 Answers

SOURCE: Passat 200, intermittently break/ABS/ASR/STOP lights come ON

Try carefully topping up the brake fluid, this can happen when the level falls as the pads wear down especially when cornering

Posted on Feb 21, 2010

  • 12104 Answers

SOURCE: ABS problem with GMC 2002 Sierra

its a low speed abs activation the problem is in the front sensors they need to be cleaned or replaced they [or one] probably has some corrosion on the sensor --[the 99 chevy tahoes had a limited recall over this issue and the fix was to remove and clean the abs sensor or if to corroded replace ] this problem doesnt set off an abs code or trouble light also sometimes the abs will activate by itself at under 4 mph without even touching brake

Posted on May 15, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2005 vw passat Headlights broken?


Sounds like the plastic parts of the aiming screws aren't functioning. A trip to the dealer will tell you for sure

Oct 01, 2014 | 2005 Volkswagen Passat

1 Answer

Timing belt diagram passat 1.8 turbo 20v 1999 eng. code apu


The timing belt diagram for VW Passat 1.8 turbo 20v 1999, engine code apu

f394e4f.png

Oct 06, 2010 | Volkswagen Passat Cars & Trucks

1 Answer

Will a 1.8 20v gearbox off a passat fit on a 1.8 20v turbo automatic to make it manual?


yes but you would need to alighn a manual linkage and parts of the loom would need to be replaced as well as ecu etc so its not worth the trouble and then the clutch pedal should have studs and fixing positions on the chassis already but the plate to allow the hydraulic clutch pipe through might need cutting.The flywheel will need replacing and the clutch plate etc.

Feb 15, 2010 | 1999 Volkswagen Passat

1 Answer

My 1.8 20v turbo has no power but builds up


Check fuel system. Leaks,Dirty filter can cause this
condition. You could have gotten a tank full of bad fuel. If this is the case ,you must drain all fuel and dispose of it properly. Change the fuel filter AGAIN.
This should keep you busy this weekend.

OH, by the way you may have to replace the Turbo!!

Dec 30, 2009 | 1999 Volkswagen Passat

1 Answer

Hi i have a 20 passat 20v turbo ,runs good,dont


good likely hood that your oil cooler is leaking oil into coolant this is something you want to replace as soon as possible. you will have to flush your coolant system several times to get as much of the oil out as possible. if you wait you will have severe temp issues as well as not heat due to a clogged heater core. and that is very hard to replace. To flush system hook garden hose to the larger hose of the coolant reservoir get car up to temp. keep idle up a little. get large bucket from the smaller hose that goes into the reservoir hook small hose to it and let it empty into bucket keep hose running thru all the time. before that though replace oil cooler. also replace coolant reservoir as well. or oil will contaminate new coolant. good luck

Sep 01, 2009 | 2003 Volkswagen Passat

1 Answer

My vw 2000 1.8t passat has trouble idling. Anyone?


It "might" be your throttle position sensor, look for some electronic's going into your or near your throttle body and clean them with disc brake cleaner, something that won't leave a film on it.
This was the problem with my chevy, I know it not the same car but it's worth a try, cheaper that replacing it.

Apr 22, 2009 | 1998 Volkswagen Passat

3 Answers

2003 VW Passat "Oil Press, Turn Off Engine" and "STOP" Light


I would check the oil pressure sensor and the oil pump itself. You can take the sensor out and use a mechanical gauge to check the oil pressure. If the oil pressure is within specs, you need a new sensor, if not, you need a new pump.

Apr 13, 2009 | 2003 Volkswagen Passat

1 Answer

98 passat manual shifting problem


check the clutch slave cylinder fluid level.if its low it could be leaking,may need checked and replaced. clutch also could be bad.

Jan 12, 2009 | 1998 Volkswagen Passat

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

26 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...