Question about 1998 Ford Expedition

Open Question

Pcv valve hose on 1998 ford expediton - 1998 Ford Expedition

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 92 Answers

SOURCE: 1998 Ford Explorer sport 4.0L 4x2 PCV Valve Location

the pcv is located on the rear(firewall) of the drivers side valve cover.turn counterclockwise and pull to remove be careful there are 2 small tabs inside the pcv hole in the valve cover(can feel with small finger) this is to hold valve in place so it wont leak.if you have a oil leak at the pcv a quick fix is to put a small amount of silicone around the pcv o-ring and install.wait hours for silicone to set up.

Posted on Oct 21, 2008

Ad
  • 3 Answers

SOURCE: PCV valve location

if i know what you are asking, look at where you put your oil in. on the valve cover to the top right should be a plug with a tubeing runs to your air clear tube where the air mass sensor and carb is located. i think that is what you are looking for.

Posted on Nov 07, 2008

davesmith_37
  • 94 Answers

SOURCE: where is the pcv valve located on a 2003 ford ranger

  • The PCV valve can be located in several places. The most common location is in a rubber grommet in the valve cover. It can be installed in the middle of the hose connections, as well as installed directly in the intake manifold.
  • Once the PCV valve is located, make sure all the PCV system hoses are properly connected and that they have no breaks or cracks.
  • Remove the air cleaner and inspect the air and crankcase filters. Crankcase blowby can clog these with oil. Clean or replace such filters.
  • Oil in the air cleaner assembly indicates that the PCV valve or hoses are plugged.
  • Make sure you check these and replace the valve and clean the hoses and air cleaner assembly.
  • When the PCV valve and hose are in satisfactory condition and there is oil in the air cleaner assembly, perform a cylinder compression test to check for worn cylinders and piston rings.
  • Posted on Feb 27, 2009

    mitchbtu
    • 121 Answers

    SOURCE: Where is pcv valve located on 2005 taurus

    It is below the egr valve close to the intake manifold below the intake air sensor, there is a tube running to it from the engine to recirculate exhaust air with fresh air, there is a clamp holding it to the air intake that you need pliers to remove, then you need to turn counter-clockwise 90 degrees to remove, do the reverse to install. to make it easier to access remove the upper intake. The pcv valve is not visible, however, you can identify it by the 3" inch long rubber hose that connects to the steel line running into the bottom of the intake. I have the part and am going to replace it soon, although Ford really makes it difficult to remove it -
    pcv valve is located just under the throttle body. remove air cleaner assembly from throttle body and you will see a u shaped hose running horizontally.

    Posted on Jan 27, 2010

    ZX2Fast
    • 547 Answers

    SOURCE: pcv valve replacement on 2003 ford escort

    The valve is located under the thermostat housing facing the front of the car. There is very little room to work with here. You'll have to pull the hose up from the valve then pull the valve out.

    Posted on Mar 05, 2010

    Add Your Answer

    Uploading: 0%

    my-video-file.mp4

    Complete. Click "Add" to insert your video. Add

    ×

    Loading...
    Loading...

    Related Questions:

    1 Answer

    I have a 1998 ford Taurus and it backfires and


    you might need a tune up but also check the pcv valve and its upper u-shaped hose directly under the throttle body.

    Oct 21, 2014 | 1998 Ford Taurus

    1 Answer

    Where is pvc hose located on 1998 taurus


    Look up pcv valve and locate the hose and valve from there, good luck and god bless

    Aug 20, 2014 | 1998 Ford Taurus

    1 Answer

    WHERE IS THE PCV VALVE LOCATED,I'VE SEARCHED AND STILL CANT FIND IT


    PCV Valve is located in front of the engine on valve cover gasket under the rubber hose that goes from valve cover to intake manifold

    Oct 08, 2013 | 1998 Ford Windstar

    1 Answer

    Burn oil after a long trip


    engine burning oil could have worn piston rings.worn valve stem seals or engine oil return holes stopped up.could have faulty pcv valve.make sure pcv getting vacuum remove pcv while engine running should feel vacuum if not pcv faulty or pcv vacuum hose disconnect or broken.check where you park your vechicle if you see oil spots engine has leaking pan gasket,valve cover gaskets could be leaking oil and the front crankshaft seal or rear main seal could be leaking oil.check make sure oil filter hand tight and check oil pan drain plug make sure its tight.

    Dec 28, 2012 | 1998 Ford Windstar

    1 Answer

    I have a 1998 Ford Escort ZX2 that we just bought. Had to change the head gasket. It started and ran just fine for a few minutes and then died. It starts and idles very rough then dies as if it...


    recheck your cam timing belt, sounds like it jumped on you. PCV valves generally plug into the valve cover and you would have had to seen it when you pulled the head. not all cars have them

    Jun 27, 2011 | 1998 Ford Escort

    1 Answer

    Where is the pcv located on 1998 6cy


    Hello! Here is a diagram of PCV location and access/change procedure...Guru...Saailer

    e6bdf77.gif




    Remove the air cleaner housing to intake/throttle housing. Remove the shield over the throttle springs. Disconnect the cruise control and accelerator cables. Remove the throttle cable mounting bracket, push wiring harness out of your way. Disconnect the PCV hose at the intake manifold and remove the PCV valve.

    Oct 18, 2010 | 1998 Ford Taurus

    1 Answer

    Where is the pcv valve located in a 1998 ford taurus


    The PCV valve is located on top of the valve cover, on the front of the engine. There will be a rubber hose connected to it about as big around as your thumb. It is really easy to change, just pull the old one straight up and it will come out. Just remove the rubber hose, attach the hose to your new PCV valve, and push it back into the hole. Hope this helps!

    Sep 04, 2010 | Ford Taurus Cars & Trucks

    1 Answer

    1998 ford exp. where is pvc valve located?


    The PCV valve is located on the passenger side of the engine, in a grommet in the middle of the valve cover, with a hose connected to it.

    Mar 11, 2010 | 2000 Ford Expedition

    3 Answers

    Where can I find the pcv valve location


    please rate as fixed if this helps.

    4 cylinder

    SECTION 303-08: Engine Emission Control 2003 Escape Workshop Manual
    REMOVAL AND INSTALLATION Positive Crankcase Ventilation (PCV) Valve —2.0L Zetec Removal and Installation
    1. Remove the PCV valve.
      • Remove the crankcase ventilation hose from the PCV valve.
      • Remove the PCV valve from the grommet by turning the valve counter-clockwise
    f21fec7.gif
    ------------------------------

    Apr 12, 2009 | 2005 Ford Escape

    1 Answer

    1998 Ford Explorer sport 4.0L 4x2 PCV Valve Location


    the pcv is located on the rear(firewall) of the drivers side valve cover.turn counterclockwise and pull to remove be careful there are 2 small tabs inside the pcv hole in the valve cover(can feel with small finger) this is to hold valve in place so it wont leak.if you have a oil leak at the pcv a quick fix is to put a small amount of silicone around the pcv o-ring and install.wait hours for silicone to set up.

    Sep 25, 2008 | 1998 Ford Explorer

    Not finding what you are looking for?
    1998 Ford Expedition Logo

    Related Topics:

    79 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Ford Experts

    yadayada
    yadayada

    Level 3 Expert

    76846 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22246 Answers

    fordexpert

    Level 3 Expert

    5546 Answers

    Are you a Ford Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...