Question about Cars & Trucks

1 Answer

I'm trying to change my shift knob on my automatic

I'm trying to change my shift knob on my automatic 2001 Saturn Sc2. I can't figure out how to get the factory one off. I think there's one of the U shaped clips in a little **** on it, but I dug around in it with a small screwdriver and can't seem to get anywhere... Any help?

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

  • Contributor
  • 4 Answers

I GOT A 01 SATURN SC2 AND YES THERES SOME TYPE OF A CLIP OR SOMTHING HOLDING IT ON

Posted on Jan 14, 2013

Ad

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 73 Answers

SOURCE: 2001 saturn sc2 gets code 341&340 camshaft sensor

if you have high resistance in secondary ign. system (plug wires, ign.coil) this will cause this code to set. make sure you are using a high quality spark plug wire set. not from autozone!!! and denso non platinum tipped spark plugs. also use a diaelectric grease on plug wires to keep moisture out.

Posted on Mar 31, 2009

  • 543 Answers

SOURCE: My saturn was running fine. Then it would shift very hard

well if it shifts very hard into every gear that means the pressure control solenoid in the trans went bad and it causing the trans to go to max line pressure thats why it shifts so hard,,,it does that so you can still drive it even thou it broken,anyhow the PC solenoid is under the trans pan which is on the TOP of the trans under the battery,,,,not too hard a job to do, the parts are about $100 labor might be about $200,,,easy fix,,could be alot more,,,and if you dont fix it ,it will break other stuff in the trans and cost alot more,,,

Posted on Oct 12, 2009

Testimonial: "Thank you!! Very helpful!!"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The transmission startedwith a loud clunking noise when shiftinginto reverse. It progressively got worse until it no longer moved in reverse.The lady had her son change the fluid but did not mention if he...


yes, change the filter and use proper fluid and level. filter might not be a stocking item at parts store. After you changed, pull negative battery term overnight to reset trans logic memory. May also be servo pack if it has one (does it make a short buzzing sound when going into gear?) they get clogged too as in a Chrysler transmission.

Oct 19, 2010 | 1996 Saturn SC

1 Answer

1997 Saturn SC2 squeals very loud the first 3-5miles


Try replacing the belt tensioner. Comes out easily, once you figure out access to it. Remove inspection panel inside front passenger side wheel well. Tensioner is right there, two bolts. If the spring gets weak, the belt will squeak.

Feb 15, 2010 | 1997 Saturn SL

1 Answer

Chaged transmission on 1997 saturn now it will not


It sounds like you have the wrong transmission. If your car is a DOHC aka an SL2, SC2, or SW2 then you have an MP7 transmission. If you have a SOHC, aka a SL1, SC1, or SW1 then you have an MP6. You need the right transmission for the right motor...DOHC needs the MP7 while the SOHC needs the MP6.

On top of that, you need the correct gear ratios which changed over the years. Your '97 CANNOT use a '98-'02 transmission. It must be 1991-1997 if it is an MP7 or 1993-1997 if it is an MP6.

Otherwise the PCM will not shift the wrong transmission.

Feb 02, 2010 | 1997 Saturn SL

2 Answers

98 saturn won't shift out of park


There is a switch on the brake pedal,that activates a solenoid in the steering column,and the shifter,that releases them,either the switch,on the pedal,or the solenoid,are bad.

Jan 16, 2010 | 1998 Saturn SL

1 Answer

Transmission will not shift out of 1st gear.


Check your transmission fluid level. If the filter has never been changed, now is a good time to replace the fluid and filter.

Jul 11, 2009 | 1993 Saturn SC2

1 Answer

Neutral is drive.


Sounds like the gear linkage cable needs adjusting Simple job really

Jul 09, 2009 | 1998 Saturn SC

1 Answer

Slipping trans leaking fluid slams into reverse


Your tranny is shot. I had the same problem with a customers car came down to having to replace the tranny

Feb 06, 2009 | 1993 Saturn SC2

1 Answer

Transmission problem


its because your saturn motor is manual and your car is automatic i have the same problem thats whaat they told me

Nov 22, 2008 | 1993 Saturn SC2

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

69 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

77194 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...