SOURCE: bought 2001 buick lasabre limited with no owner's manual
if you do not have an owners manual try
for owners manuals online: www.edmonds.com
SOURCE: How do I replace broken 2002 buick century passenger side mirror?
On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you can access the bolts that secure the mirror onto the door
SOURCE: fix 2002 buick rendezvous side view mirror
it sounds like the mounting bolts embedded in the mirros housing were pulled out somewhat.You will not know untill the mirror is removed. If the studs that hold this mirror housing to the door are pulled out take a heat gun to get the studs warm and twist them back in flush. them apply JB Weld to the studs lowest part to the mirror housing so they stay secured
SOURCE: I've got a broken driver side rear view mirror.
This is what you do take the door skin off of the inside of the door and at the top corner there will be i think three nuts and than your going to need door clips after your done in order to put the door panal back on
SOURCE: No power to right side
Inspect the fuse if they are all good other wise inspect the relay. If they all check out OK then you may have an issue with the wiring since they all are all found in one location.
Push the mirror lens upward so it faces the roof of your Buick LeSabre.
Place the eight-pointed star head of the Torx driver into the setscrew located in the base of the rearview mirror. Turn the Torx driver counterclockwise. This releases the clamping pressure on the mirror.
Slide the mirror upwards to remove it from its metal bracket.
Place the base of the replacement mirror against the windshield, directly above the metal bracket. Slide the mirror down into the bracket. The bracket has a groove on each side into which the mirror will slide.Secure the mirror to the bracket by tightening the setscrew clockwise with the Torx driver.
74 views
Usually answered in minutes!
×