Question about Cars & Trucks

Open Question

2005 chev taho air bag code b0101

What is the problum with code b0101

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 540 Answers

SOURCE: 2005 tahoe no air blowing

as long as all the fuses are good.. its probably the blower resistor/module... located next to the blower motor under the pass. side of the dash..

Posted on Oct 13, 2009

  • 3 Answers

SOURCE: air bag light

go to auto zone and ask them to check it with OBD 1. also , be very careful about touching any electrical connections in and around airbags (serious injuries can occur). R U the original owner ?? mybe some else disconnected the wires or could be a chop shop special ( as well as other wiring issues) otherwise take it to chev. dealer.

Posted on Nov 21, 2008

  • 56 Answers

SOURCE: malibu air bag module location

The module is under the passenger side seat,under the carpet.You will have to remove the seat to access it easier.Lift up the carpet and it will be mounted to the floor.

Posted on Mar 03, 2009

  • 16 Answers

SOURCE: Service air bag light is on in 2005 tahoe

the only light that matters on the dash for inspections is the check engine light for emissions purposeses, you can un hook the car battery for five minutes and let the codes reset in the computer, how ever i would wait till after u got the car inspected before you did this because it will reset the monitors as well, and that will fail you on the emissions test, if you havent completed the drive cycle yet. if it comes back on take it to an auto garage that has a snap-on modus scanner should be able to take car of it with that, and find out why it is coming on. let me know how it goes

Posted on May 08, 2009

  • 139 Answers

SOURCE: Where is the Air Bag computer modual located for

The air bag module or the inflatable restraint sensing and diagnostic module (SDM) as they call it is u91stt_21.jpgnder the left front seat.

Posted on Nov 18, 2010

Testimonial: "Thanks Now I have to figure out how to get to it with the power seat stuff in the way."

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Reset airbag light


Hey Earl, what's going on ? The air bag module is usually under the passenger seat or the center console ! The only way to turn off the light is with a up grade scan tool , not code reader. An the light is on for a reason , problem with the system ! If you don't know about this don't mess with it , you could deploy an air bag !
The AIR BAG indicator, located on the instrument panel cluster (IPC) is used to notify the driver of SIR system malfunctions and to verify that the SDM is communicating with the IPC. When the ignition is turned ON, the SDM is supplied with ignition 1 voltage and requests the IPC to flash the AIR BAG indicator 7 times. While flashing the indicator, the SDM conducts test on all SIR system components and circuits. If no malfunctions are detected the SDM will communicate with the IPC through the class 2 serial data circuit and request the IPC to turn the AIR BAG indicator OFF. The SDM provides continuous monitoring of the air bag circuits by conducting a sequence of checks. If a malfunction is detected the SDM will store a diagnostic trouble code (DTC) and request the IPC to turn the AIR BAG indicator ON. The presence of a SIR system malfunction could result in non-deployment of the air bags. The AIR BAG indicator will remain ON until the malfunction has been repaired.

Feb 06, 2015 | 2005 Chevrolet Tahoe

1 Answer

2002 chev. tahoe pulling 0442 code


Go here for codes and possible issues. http://engine-codes.com/p0442_chevrolet.html

Mar 10, 2014 | 2005 Cadillac Deville

1 Answer

Tundra 2005 air bag light on


Most parts stores have a scanner that can read the ABS codes for you.

Oct 31, 2013 | 2006 Chevrolet Tahoe

1 Answer

WHAT IS THE PROBLUM WITH AIR BAG CODE B0101


Try moving the driver's seat back and forth and see if the light will go off. If so the wiring under the seat could be loose and or broken.

Jan 03, 2013 | Cars & Trucks

1 Answer

Toyota camry B0101 code


DTC B0101/14 is recorded when an open is detected in the D squib circuit. Basically this means that there is a problem with the air bag or clock spring in the steering wheel. This needs to be serviced by a dealer.

Oct 14, 2012 | 2001 Toyota Camry

1 Answer

Service air bags comes on each time i start my tahoe


have this fault diagnosed and serviced by a qualified service tech, this is a safety feature and your safety is Paramount it can also be dangerous to service if you do not know exactly what you are doing OK

Mar 01, 2011 | 2005 Chevrolet Tahoe

1 Answer

Air bag light will not turn off on my 99 chev malibu


Hello, with the air bag light being, this indicates a problem with the system. the air bags may not work correctly until this has been repaired. there are several things that can cause this to happen. the first thing that needs to be done, is the air bag system will have to be scanned for trouble codes. once a trouble code has been pulled from the system, then a repair can be made

Dec 07, 2010 | 1999 Chevrolet Malibu

1 Answer

Where is the Air Bag computer modual located for the 2005 Tahoe Z71?


The air bag module or the inflatable restraint sensing and diagnostic module (SDM) as they call it is u91stt_21.jpgnder the left front seat.

Nov 18, 2010 | 2005 Chevrolet Tahoe

1 Answer

I have a 2005 Chev Tahoe and got a CD stuck in the factor installed player. When I hit the eject it just makes noise but won't eject the CD. Any advice. Greg


you will need to take the radio out, make sure you have the code, and then take it apart remove disk. hope this helps Tim

Oct 16, 2010 | 2004 Chevrolet Tahoe

1 Answer

97 chev tahoe service engine light is on and it wont start


P0300 is random multiple misfire. If its been more then 3years since the last tune-up, do one. Usually it is caused by debris inside the distributor cap but could also be plugs wires, fuel and air filter.

Apr 28, 2009 | 1997 Chevrolet Tahoe

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

361 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...