Question about 2004 Dodge Durango
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Here is a diagram of you vehicle. Good Luck please leave a FIX YA comment if I fixed ya. http://www.2carpros.com/car_repair_information/tec_info/2004/dodge/durango/2004_dodge_durango_drive_belt_routing_diagram.htm
Posted on Dec 27, 2008
the crank sensor is located passenger side back of the engine were the trans and engine come together .there are 2 - 13mm.bolts that bolt to top of the engine.
Posted on Feb 22, 2009
Its in different locations depending on if its 2wd or 4wd. For 2wd its in front of the drice shaft or for 4wd its in the tranfer case, just look for a white shape like box with wires plugged into it and you need a socket to remove it, iam not sure how much it is to replace as the cost varies at different shops.
Posted on Jun 19, 2009
There are 2. One is located above the catalytic converter most likely near the exhaust manifold where it attaches to the head. the second and most common one I have found to go bad is the down flow sensor located after the catalytic converter before the muffler on the underside.
Posted on Oct 19, 2009
SOURCE: where are the o2 sensors
I believe you may have three (3) O2 sensor, (2) of the sensor is on ether side of the exhaust down pipe and some times called up stream O2 sensor, the third O2 sensor know to some as the down stream O2 and is after the Catalytic converter.
The up stream O2 monitors the left and right side banks and sends signals to the ECM to make the adjustments to the injectors to keep the proper air/fuel ratio.
The down stream O2 monitors the catalytic converter and sends signal to the ECM if the catalytic converter has gone bad.
Good luck and hope this helps. If you get it scanned at Auto Zone, they should be able to let you know which O2 has gone bad so as to not change all three. You could always check the wire harness to the down stream O2 for corrosion.
Posted on Jan 29, 2011
Tips for a great answer:
Dec 08, 2015 | 2006 Dodge Durango SXT
May 06, 2010 | 2006 Dodge Durango
Nov 05, 2009 | 2006 Dodge Durango
Jul 02, 2008 | 2006 Dodge Durango
70 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: