Question about 1997 Ford F150 Regular Cab

1 Answer

Ford f150 v8 petrol 1997 where is the crankshaft sensor located ?

4600cc petrol

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

The crankshaft position sensor is located on the lower right side if the engine block,to the rear of the timing cover.

Posted on Jan 30, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1990 FORD F150; 351 WINDSOR 5.8 V8 ENGINE; HAS NEW DISTRIBUTOR COIL AND IGNITION CONTROL MODULE STILL WONT START


crankshaft position sensor is bad. it uses this sensor to tell the computer when to make each plug fire. no signal no fire.

Nov 21, 2013 | 1990 Ford F150

1 Answer

2006 ford f150 4x4 crew cab 5.4 v8 has fuel odor in cab


Other than a fuel leak, the most likely cause is the filter pad in the charcoal evaporative canister, which is usually located in front of the engine near the radiator.

Oct 02, 2013 | 1997 Ford F150 Regular Cab

1 Answer

1994 ford f150 oxygen sensor location


An Oxygen Sensor (O 2 S) or heated Oxygen Sensor (HO 2 S) is used on all engines. The sensor is mounted in the right side exhaust manifold on some V8 engines, while other V8 engines use a sensor in both right and left manifolds.

Heated oxygen sensors are located in the exhaust pipes below the exhaust manifolds. The sensors react with the oxygen in the exhaust gasses and generates a voltage based on this reaction. A low voltage indicates too much oxygen or a lean condition. Where as a high voltage indicates not enough oxygen or a rich condition.

Disconnect the Oxygen Sensor (O 2 S). Measure resistance between PWR and GND (heater) terminals of the sensor. If the reading is about 6 ohms at 68°F (20°C). the sensor's heater element is okay.

Hope this helps (remember to rating this free answer).

Oct 13, 2011 | 1994 Ford F150 Styleside Supercab

1 Answer

We have a 1997 f150 that just stoppped going around the corner. we replaced the crankshaft sensor and checked all connections and the fuel pump has low voltage


run anounther power to the pump then check it if voltage is still low then replace the pump she should fire right up hope this helps

Jul 04, 2011 | 1997 Ford F150 Regular Cab

1 Answer

1996 ford f150 no spark to coil


Yes there is a crankshaft position sensor on this truck. I had the same issue with my 96. I changed the ICM, crankshaft sensor, and the coil. Then I found out the distributor was defective. I recommend replacing the distributor with a new one and that will correct your issue.

Feb 21, 2011 | 1997 Ford F150 Regular Cab

1 Answer

Where is bank 1 sensor 2 on f150 4.6 Eng. .


Diagram: Ford Explorer and V8 O2 (Oxygen) Sensor Locations

Ford Explorer and V8 O2 Sensor Locations diagram. This shows the location of Ford oxygen sensors on Bank 1 and Bank 2. If you want to know where your O2 sensors are, this diagram is your guide.

zjlimited_192.gif

Hope helps.

Feb 14, 2011 | 1997 Ford F150 Regular Cab

1 Answer

Where is the MAF sensor located on a 2004 F150 V8 5.4L?


It is located in your air box. Here is a link for you with pictures.

Thank you for using fixya and good luck.

http://www.fordf150.net/howto/clean-maf-mass-airflow-sensor.php

Apr 10, 2010 | 2004 Ford F150

Not finding what you are looking for?
1997 Ford F150 Regular Cab Logo

Related Topics:

140 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

70346 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Ron Lankford

Level 3 Expert

5386 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...