Question about 2005 Nissan Pickup Navara
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: removal of stereo
there are 2 screws down at climate controls remove them and whole panel pops off, stereo is held in with 4 screws facing you. but it looks bad with a generic stereo fitted nissan have a cd changer that fits in above the stereo where the cup holder is and hooks up to stereo and looks good, not overly flashy,
Posted on May 05, 2009
SOURCE: my nissan navara D22
Hi james, you might have air in your injection system. ussually this air pocket could be corrected by bleeding the system; or, your fuel filter is clogged. First the filter, if your fuel filter is directly attached to a hand pump, and your filter has a sendimentary bleed port at its bottom, drain this first. Then, after its drained, close the drain plug. Next is to look for the fuel return bolt on the injection pump(usually it has a "out" word etched on it) and usually uses a 17mm hexagonal head. Loosen the bolt and slowly remove it. Take care, and watch orientation of the two copper washers that are used for gasket. You might also find a filter screen attached to the bolt on some injection pumps. Anyways, if there is no filter screen, re-screw in the bolt(remember the copper washers) but do not tighten it just let it loose for a while. Now for the sweaty part, using the hand pump, pump the fuel in until the return bolt spits out fuel. You will see bubbles on the first few pumps but do not stop until it bellows out pure and clear fuel w/o bubbles. If you attained the goal, stop pumping and screw the bolt shut. Wipe-off excess fuel from the injection pump. Try starting the engine. when the engine turns over let it warm up for a while the with, again, with your no. 17mm open wrench, try loosening the injector feedline one at a time(while the engine is running).Watch out for squirting fuel, your engine might rattle a little but it will be fine, just let the fuel flow a few seconds then re-tighten the nut. Do this on all 4 injectors. Let the engine run a few minutes then shut it down. Let it completely cool down then re-start it. Also try checking glow plug(or heater plug) condition. If one glow plug is busted replace all 4 at the same time with the same brand. this would help to keep the engine attain a 1-click engine run.
Hope this helps.
Posted on Sep 29, 2009
Remember, what is heard as turbocharger noise may not be caused by a noisy
turbocharger. Before replacing a turbocharger perform the following diagnosis.
A. If a loud whine or whistle is heard during acceleration and increases or decreases with rpm and load. This condition is most often the result of a loose clamp/hose at the turbocharger compressor outlet, charge air cooler inlet, outlet or at the intake manifold.
1. With the engine running at idle and the transmission in Park or Neutral with the parking brake set, feel for boost air escaping at each connection between the turbocharger compressor outlet and intake manifold. For limited access areas, spray soapy water on those connectors and look for bubbles.
2. Check the exhaust manifold and exhaust system for leaks.
I hope this helped.
Posted on May 16, 2010
Tips for a great answer:
Mar 29, 2016 | 2005 Nissan Pickup Navara
Jan 13, 2016 | Nissan Cars & Trucks
Apr 23, 2012 | Nissan Navara Cars & Trucks
Apr 10, 2012 | 2006 Nissan Navara 2.5
Sep 15, 2011 | Nissan Pickup Cars & Trucks
Sep 03, 2011 | Nissan Pickup Cars & Trucks
May 09, 2009 | 1997 Nissan Pickup
Aug 26, 2008 | 2005 Nissan King Cab
264 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: