Question about 1995 Chrysler LHS

1 Answer

1995 Chrysler starts up fine but after driving it and shutting off ignition, it will not restart until it has set for about an hour I have replaced the water pump, upper intake gasket, front left injector, spark plugs and the coil pack. It is still doing the same thing

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 4 Answers

Does it happen when its damp outside? I have that problem and I had a friend hotwire the computer with a small roach clip. My car will actually die while it is running if damp and not even start with a jump..with the roach clip thing, you just have someone touch the positive and boom, starts right up!!! Super gerry rig, but it works, every time.

Posted on Jan 31, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: Lebaron won't start

I had a similar problem with my 90 LeBaron. It turned out to be the computer.

Posted on Mar 08, 2009

  • 40 Answers

SOURCE: 95 chrysler lebaron gtc 3.0 starts for a second and then stalls out

What is the fuel pressure reading at the fuel rail?

Posted on Mar 19, 2009

1fastbob
  • 301 Answers

SOURCE: 2003 chrysler 3.8 #1 cylinder misfire

Just wondering if you did a compression test both dry and wet (Squirt of oil in cylinder). You seem to have covered things pretty well. If compression test is okay I would look for something electrical such as crank or cam position sensor that is intermittant or has corrosion at a wiring connector.

Another thought...are there any vacuum lines near the #1 intake manifold port? It may be as simple as a vacuum leak.

Posted on Nov 07, 2009

BLAZZ81
  • 281 Answers

SOURCE: 99, chrysler ,300m..1 month ago changed timing

check the timing belt!! may have been put on to loose or to tight,

Posted on Mar 12, 2010

  • 1 Answer

SOURCE: The car cranks but won't start. There is no spark,

If you remove the fuel line and crank the engine and get fuel then you could be assured that the crank sensor works but if there is no fuel while cranking then the crank sensor is most likely the fault. If the crank sensor is not the problem then it is most likely in the coil or distributor which the 97 is notorious for.

Posted on Sep 15, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

04 pt cruiser auto. start engine put in gear and drive shifts fine. eng light is on from time of start.


Visit the on-line store, know as reliable-store, they have the repair manuals. I'm sure you will get the solution of your problem.
Best Manuals

Jan 06, 2017 | Chrysler PT Cruiser Cars & Trucks

1 Answer

I have 84 ramcharger started fine used for about 1/2 hour plowwing driveway shut off would not restart until cooled off 2nd time it has done this?


Sounds as if the ignition control module is getting hot and not allowing it to restart. Had the same issue with a Dodge b-250 van, except for the plowing part. It would run for about an hour and start sputtering and shut off. After it cooled down, van would start and run great for the same length of time and do it again.

Feb 22, 2015 | Dodge Ramcharger Cars & Trucks

1 Answer

Car runs and drives but after about 20 mjn it shuts down and wont start again for hour or two some times longer


try this.. when your ingition module gets hot it shuts down until cooled off..replace the ignition module and see if the condition goes away..take it where they can read any codes on the car for free(usually autozone or maaco) then see what may be up with it..

Dec 08, 2013 | 2004 Chrysler Sebring

1 Answer

1995 jeep wrangler just stops running without warning.


A bad crank sensor will shut the jeep off suddenly, while driving down the road, then restart later and it repeats over and over until you replace it.

Oct 12, 2012 | 1995 Jeep Wrangler

1 Answer

1995 ford escort will not restart after driving on hot days until you wait 4 hours


You may want to replace your crankshaft position sensor. They tend to "open" the circuit when they get heated after they have begun to wear out.

Aug 16, 2012 | 1995 Ford Escort

1 Answer

94 chrysler con.3.3 eng.runs for about 15 min. shuts down,engine


suggest change crank sensor-rear of engine pas side

Oct 05, 2009 | 1994 Chrysler LHS

1 Answer

I HAVE 95 JEEP GRAND CHEROKEE. AFTER DRIVING CAR FOR SHORT DISTANCE WILL NOT START. LET SET COUPLE HOURS IT WILL START. MAY GO 5OR 6 DAYS NO PROBLEM THEN AGAIN WILL NOT START. HAD TWO GUY CHECK IT wE...


Had similar problem with 96 Jeep 4.0L engine. Tracked it down to the connector for the distributor pickup. Spliced in another connector and hasn't stalled since. Also, have you had any codes? Easy way to check on Chrysler products: turn key on, off, on, off, on (not starting) and watch the 'engine light' on the dash. It will flash off/on. Count the flashes with short pauses between and longer pauses between code. When you get a 5 count and 5 count, that is the end. This may also help

Aug 10, 2009 | 1995 Jeep Grand Cherokee

1 Answer

1987 LeBaron won't start unless I pour gas into


Check you injector seals,you may be losing pressure in the fuel lines

Jul 16, 2009 | 1987 Chrysler LeBaron

1 Answer

Truck dies


TRY CHANGING IGNITION COIL

Dec 04, 2008 | 1989 Dodge Raider

Not finding what you are looking for?
1995 Chrysler LHS Logo

73 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8582 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...