Question about 1988 Toyota Camry

Open Question

Cannot locate where the map sensor is for 88 toyota camry 4 cyl? help

Trouble with car in that it surges at high speeds and cuts off at will, think it has something to do with the map sensor, but don't know where it is?

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

motor1258
  • 6674 Answers

SOURCE: Correct Firing Order for 1994 Toyota Camry 2.2L 4 cyl.

1-3-4-2

Posted on Jan 21, 2009

  • 101 Answers

SOURCE: I HAVE A TOYOTA TERCEL THAT SURGES AT AN IDLE, I

Try replacing that sensor or continue looking for a vacume leak

Posted on Sep 09, 2009

  • 299 Answers

SOURCE: Where is the coolant temperature sensor located on

it is located where the lower rad hose connects there are two sensors there so make sure you have the correct one

Posted on Sep 30, 2009

  • 1206 Answers

SOURCE: 2004 Toyota Camry 4 cyl automatic. What mileage 85000

80 thousand miles is the best, any more you are risking damage to your engine.

Posted on Jan 26, 2010

Testimonial: "Fast answer. Thanks"

  • 3 Answers

SOURCE: heater works only on high speed on a 1999 toyota

I just fixed this problem on my 99 Camry. The fan only worked on high. It was the resistor. Bought it for $29.99. It is under the dash on the passenger side. Just above where the passengers left foot would be. You DO NOT need to take out the glove box. The resistor is located just above where the carpet ends. It is held in place by a plug with about 6 wires. It has two phillips head screws. Get a short elbowed phillips head and switch it out.

Posted on Feb 03, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the camshaft sensor on a 2012 camry


check if new engine is same old engine in all components,
if your engine is an 2az ,2.4L , the camshaft sensor its located on rear engine head , near the refrigerant outlet

May 12, 2017 | 2012 Toyota Camry L Sedan 2.5L 4-cyl....

1 Answer

2000 toyota camry 4 cyl at stop idling speedometer bounces aronnd 20 up to 40 and when i accelerate it hesitates drops to zero thea goes


could be a short in the vehicle speed sensor or a faulty cluster, the speed sensor on the transmission is the first thing to check and the cheapest.

Sep 30, 2012 | 2000 Toyota Camry

2 Answers

I have a 1995 Toyota Camry 2.2 4 cyl with 5 speed manual that has been running rich, and has lost most of its power when I try to take off it feels as though its trying to do a 3rd gear take off. I have...


Firstly I have to mention, is the check engine light lit on the instrument panel? This means a trouble code is stored in the main computer, which will tell you the location of the fault.
There is a host of possible reasons
- ignition timing incorrect- distributor fault, oil in there, cracked cap- fuel injection fault- fuel pressure high or low, relief valve failed- brakes binding- emissions system fault, vacuum leaks, blocked valve

Apr 23, 2012 | 1995 Toyota Camry

1 Answer

Sluggish transmission engagement. Traveling at


changing your VSS is easy , the hardest part is finding it...look around the housing near your CV axles..the differential in there near there is a 8 or 10mm bolt holding it in witha wire connector on the end...if you pull it out you will see a plastic gear on the end of the sensor.... YOU CAN DO IT!!!!

Jun 10, 2010 | 2002 Toyota Camry

2 Answers

I can't find the MAF sensor in my 4 cyl 1998 camry. Is it possible that it does not have one. I've looked between the airbox and throttle body but it's not there. My codes are p1130, p1133, p0125 and...


The 4 cylinder Camry uses a MAP sensor or Manifold Air Pressure sensor instead of a air mass flow sensor which is in the 6 cylinder model. It is located just under the top of the hood in the center of the bay closest to the windscreen.
The computer is programmed to meter fuel and spark timing from manifold absolute pressure (MAP), engine temperature, air temperature, and throttle position only.

The MAP sensor is responsible for the codes you are facing with.

Nov 24, 2009 | 1998 Toyota Camry

1 Answer

Where is the coolant temperature sensor located on a 1995 toyota camry 4 cyl. 5 speed


it is located where the lower rad hose connects there are two sensors there so make sure you have the correct one

Sep 30, 2009 | 1995 Toyota Camry

1 Answer

91 camry surging


is there a hissing sound when depressing the brake pedal.

Nov 23, 2008 | 1991 Toyota Camry

1 Answer

91 Camry surging


You maybe need to adjust the idle speed, on top of the intake manifold, near where it says EFI, there a small black rubber plug, pull it out, turn off everything in the car, then turn the screw in where the plug was to change the idle speed. Or it could be that you need a new Idle Control Valve

Nov 23, 2008 | 1991 Toyota Camry

Not finding what you are looking for?
1988 Toyota Camry Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...