Question about Toyota Cars & Trucks
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: I have a 2004 Toyota
You have to remove the rear door inside panel.First thing is to remove the top and side interior trim panels,they just pop out by prying them away after they are out the metal retaining clips sometimes stay in the door,pull them out and put them on the plastic panel before reinstalling.Then the strap that you use to close it has a cover on it that you have to push up to get off then remove the 10 mm bolt that holds the strap.Then pry the panel away from the door I think that the bottom has two hooks on it which means that the top needs come off first so you can lift the panel hooks out of the slots.Once the panel is off you will see the bulbs they twist out and you have to pull the bulbs out.Good luck
Posted on Nov 29, 2008
SOURCE: License plate bulb replacement
you have to carefully pry the bulb holder out and remove the bulb by turning it counterclockwise while pushing in. Replace the new lightbulb the reverse mode.
Posted on Nov 30, 2008
SOURCE: 2002 license plate bulbs
its real simple look at the license plates then look up you will see 2 screw per lamp / unscrew them and slide remove its a 194 bulb so get some ready then replace and put back / Please rate my response thank you very much
Posted on Feb 02, 2009
OK>>> it is very cold here, but nonetheless..I went outside to check on my Oldsmobile for your benefit....On mine (I can't guarantee it is the same for all of the vehicles listed above). If you are looking at the license plate, LOOK UP and you should see the bulb and whatever encasing is there. Mine is in a tube and it is attached with (2) mini bolts that will need to come out first, then it just looks like a simple matter of disconnecting the electrical plug, taking out the old bulb and putting the new one in. I hope this helps someone....
Posted on Feb 23, 2009
LICENSE PLATE LAMP BULB
Posted on Oct 08, 2009
Tips for a great answer:
Jan 24, 2016 | Cars & Trucks
Feb 02, 2013 | 1993 Toyota Corolla
Jun 01, 2011 | 2006 Toyota Corolla
Apr 14, 2011 | 2003 Toyota Corolla
Mar 22, 2011 | 2005 Toyota Corolla
the Steps on how to replace license plate light on your car.
Open the trunk and locate the trunk liner retainer clips.Use the
Phillips head screwdriver to loosen the center plastic screw of the
retainer clip about 1/4 turn, just enough to raise the head of the
screw from the base of the clip. Pull the screw up, and lift the
clip out of the liner. Use a flathead screwdriver to help pry it
out. Remove enough of the clips to allow access to the license plate
light sockets. Pull the liner back.
Remove the emergency trunk release handle by popping off the top
cover of the handle. Use the needle nose pliers to gently squeeze
the prongs on the shaft, while removing the handle.
Unplug the wire harness from the license plate light bulb socket the
release clip on the side of the outlet.Twist the license plate light
bulb socket 1/4 turn counterclockwise, using the needle nose pliers
again. Do not apply too much pressure to the pliers; you may damage
Remove the bulb from the socket, and replace it with a new one.
Replace the socket into the socket assembly, and plug the wire
harness back in. Test the bulb by turning on the lights of the
Corolla, then turn them off again.
Replace the trunk emergency release handle, and replace the hood
liner and the retainer clips. Remove the old bulb and tools, and
close the trunk.
Dec 22, 2010 | 1995 Toyota Corolla
May 21, 2010 | 1994 Toyota Corolla
Jan 13, 2010 | 1992 Honda Accord
Apr 08, 2009 | 2004 Toyota Corolla
Dec 11, 2017 | Toyota Cars & Trucks
26 people viewed this question
Usually answered in minutes!