Question about Cars & Trucks
Fan moter only works on high setting
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
It is on the passenger side, you have to remove the black plastic kick plate, below the glove box, to expose it (held in place with 2 latches and 1 push pin). The resistor is in front of the blower motor ( sandwiched between the motor housing and the firewall) it is tricky to get to, i think when i changed mine i didnt replace all the screws as they were difficult to remove and even harder to replace. Good Luck, Mike
Posted on Apr 20, 2009
Under the dashboard on the passenger side you will see the blower motor. Near the blower motor inside the air duct is the resistor. It should be held in place by two screws. Hope this helps. Good luck
Posted on Apr 28, 2009
It probably is the fan switch itself. They are around $30. for a new one. You can take it out and check to see if you have power to all the settings with a ohm meter or test light. They are not real hard to take out.
Posted on Jul 28, 2009
the resister is usually located in the air box above the passengers feet ,high indicates the resistor needs to be replaced
Posted on Sep 04, 2009
Testimonial: "Thank you for the help, you've saved me a ton of time and frustration."
SOURCE: the blower motor on 2005
The resistor block is normally located in the air box close to the blower motor for cooling.The fact you have no speeds on the blower indicates it might be a fuse. Have you checked them because this is where I would start first.Next step would be to check the blower motor itself.Remove it and give it 12 volts from the battery,it should want to twist out of your hand so hang on.Then I would pull the resistor block and check that.They are usually held in with two screws and if its done you should be able to see the burned out circuits with your eyes.Good luck
Posted on Oct 27, 2010
Tips for a great answer:
Jan 25, 2012 | 2001 Chevrolet Express
Aug 14, 2011 | 2001 Dodge Ram 2500 Truck
Mar 16, 2011 | 2001 Kia Sportage
Dec 28, 2010 | 2001 Dodge Ram 2500 Truck
Nov 22, 2010 | 2006 Chevrolet Colorado
May 18, 2010 | 2001 Dodge Ram 2500 Truck
Feb 27, 2010 | 2004 Dodge Dakota
Jul 28, 2009 | 2001 Chevrolet Silverado 1500
Jun 29, 2009 | 2004 Chevrolet TrailBlazer
25 people viewed this question
Usually answered in minutes!