Question about Suzuki Cars & Trucks

Open Question

HOW TO REMOVE REAR AXLE ON A SUZUKI MULTICAB - Suzuki Cars & Trucks

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2 Answers

SOURCE: rear differential axle removal

remove the 'locking bolt', once the pin is out the c-clips shoud fall out unless this is a floating axle in which the axles are attached at the hub.

Posted on Sep 12, 2008

techbuster
  • 5081 Answers

SOURCE: how to remove rear axle 03 chevy silverado

You will have to remove the rear end plate off of the back of the rear end. Then turn the carrier untill you see a big silver pin that goes through the spider gears. Those will be 4 small gears in the rear end carrier. If you look at the right side of the carrier were the pin goes through it you will see a small bolt head, That bolt goes through the carrier and holds the pin in place. Remove that bolt then reach up in the rear end housing and push the pin towards you untill it comes out. ( DO NOT TURN ANYTHING AFTER YOU REMOVE THE PIN) are the spider gears will fall out.


Now get someone to push the axel in while you are looking at the 4 small gears in the housing, when they push the axel in a C-clip will fall off the end of the axel and into the rear end, You will see it fall out. Then just pull the axel out.



When you put the axel back in, push it all the way in then slide the c-clip over the end of the axel and then pull out on axel and that will hold the clip in place untill you put the big long pin back in the carrier. I hope you understand, just watch what you are doing. GOOD LUCK.

Posted on Oct 09, 2009

  • 125 Answers

SOURCE: repair rear wheel bearing 2004 suzuki grand vitara

I have never changed it by myself.

Just trying to help you during X mass period please consult the following internet site and see if you 'recognise your installation.

www.izook.com/tech/samurai/drivetrain/rearaxlebrg.htm

Sorry If can't do more over
Dan

Posted on Dec 28, 2009

  • 14036 Answers

SOURCE: how to remove rear axle to replace axle seal?

YOU NEED A HAYNES OR CHILTON REPAIR MANUAL.TO REMOVE REAR AXLE YOU HAVE TO REMOVE REAR DIFFERENTIAL COVER AND GASKET.YOUR DIFFERENTIAL HAS EITHER PINION SHAFT LOCKING SCREWS OR C - LOCKS.THEY HAVE TO REMOVED BEFORE AXLE SHAFT WILL COME OUT.

Posted on Mar 04, 2010

  • 1 Answer

SOURCE: my suzuki F6 multicab emits black smoke what is

If not fix after tune up... ask the mechanics for the condition of the piston rings? the smoke might be an oil mix up on the fuel due to piston rings problems...

This what had happened to my multicab recenlty...

Posted on Jun 28, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Suzuki multicab diagram 3 cylinder distributor firing order installation draw


older post. then hygh-jacked, Christy post, why do that?
what country"w
we are USA< no such car way ask us?
no year car,
no ENGINE stated.
4 banger is 1,3,4,2 firing order, but you must be distributor savvy to know how to use that fact, (TDC firing, #1 0degrees) rotor points to #1 firing, wire, next time mark parts, so no guessing?
A multicab is a small light truck in the Philippines

Feb 14, 2017 | Suzuki Cars & Trucks

1 Answer

How can I locate the thermostat of my suzuki multicab


amazing, no year, stated and what is multicab.?
http://www.multicab.webs.com/Photo-0295.jpg
not sold here, in uSA, and this IS a USA forum..... but.....

well you can do this 3 ways.
1: That rad hose that gets hot first (bighose) goes to the unstated engine by you, thermostat housing....
2: suzuki.com read the parts list for YOUR engine. bingo.
3: alldata.com , log in read. USA cars only, so.......
4: look and find the housing in what 2min.flat?
5: ask any repair shop on earth to show you... (or they laugh and say grease my palm first>????)
6: if in usa , have 17yo kid at autozoned point to wrong part?
7: Go to Suzuki, walk to parts counter and ask for the FSM.
that official suzuki factory service manual.... buy one. and read it?

May 28, 2015 | Suzuki Cars & Trucks

1 Answer

How do you remove the cover of the rear differential on a 2004 Suzuki XL-7 all wheel drive


anon post. and posted at least 2 times now.
and all posts lack important facts
what are you doing? we dont know? rear Diff. something,
my guess, is you think a cover needs to be off (no it dont i bet)
the car has and FSM with all steps there, for each job, , the job
unstated by you, and my guess you are working book free. with no steps,to follow,?
(each axle on most cars have their own, methods. many there are)

ill post a rear axle photo
now a wild guess, the rear inboard axles flanges , you want off>? the DIFF? (note the clear, statement)
here are the FSM steps , all for that , do tell where you get lost

  1. Before servicing the vehicle, refer to the Precautions section.
  2. Raise vehicle and remove wheels.
  3. Drain front axle, or install catch pan under work area.
  4. Remove halfshaft wheel nut.
  5. Remove halfshaft flange nuts.
  6. Remove halfshaft assembly.
  7. Install slide hammer to axle flange and remove.
  8. Remove axle seal with seal removal tool.
  9. Remove snap ring.
  10. Install slide hammer with bearing removal adapter and remove axle bearing.
Im guessing step 10 is an issue, working with no slide hammer are you, a key tool in any shop.?
there is a great Utube vid, with a DIY (hillbilly) with a brick tied
to a rope, and using that as a real tool?




25444330-ojy4jbcchjvgbf2ww1qvc1nl-5-0.jpg get the FSM from suzuki, (suzukipitstopplus)
or alldata.com
its all there all steps and tools needed. (ask if a tool needs to subs)

login and read

http://www.scantool.net/software/alldata-diy-1-month-subscription.html

Feb 18, 2015 | 2004 Suzuki XL-7

1 Answer

Basic maintenance ng Suzuki double-cab multicab


please post a question, HOW TO?
the operators guide covers that. lost that in the glove box.
yes, then ask suzuki for one,
Tuneups,? belts? , hoses, fluids.
and no engine stated, so cant answer....
what engine, what country.
and what car. more specifically
the suzuki CARRY? 2wd or 4wd?

read the wiki and see how complex this is. see gen 10?
is that it? DA52w, F6A, or DA62 or the K6a chain cam...
open hood see chassis tag, see that, post photo of it and car.
http://en.wikipedia.org/wiki/Suzuki_Carry

which one , and with engine.?
this?
https://samalbahaykubo.files.wordpress.com/2010/08/dsc05903.jpg


what country, is it in.? cant guess that either,

Dec 06, 2014 | Suzuki Cars & Trucks

2 Answers

Chassis number location multicab


hi vincent
The easiest place to find the VIN on your vehicle is right on the lower left corner of your dashboard. You should be able to read the number by looking through your windshield on the driver's side of your car. Check the driver's side door. The VIN might also belocated in the driver's side doorjamb or on the doorpost.
chassis-number-location-multicab-z2ykn2kml2ixnwlc1uxsgcz5-4-0.gif

chassis-number-location-multicab-z2ykn2kml2ixnwlc1uxsgcz5-4-1.jpg

Sep 02, 2013 | Suzuki Cars & Trucks

2 Answers

My suzuki F6 multicab emits black smoke what is the possible problems? It consumes more fuel than before.


If not fix after tune up... ask the mechanics for the condition of the piston rings? the smoke might be an oil mix up on the fuel due to piston rings problems...

This what had happened to my multicab recenlty...

May 08, 2011 | 1993 Suzuki Samurai

1 Answer

How to find engine number of multicab?


how to find and where exact location of engine number of 12valve van type multicab reply

Nov 11, 2010 | 1999 Suzuki Vitara

1 Answer

How do i change the rear axle seal on a 1999 grand vitara


how do i remove the axle seals on a 1999 suzuki grand vitara

Mar 02, 2010 | 1999 Suzuki Grand Vitara

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

219 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Boyet Soriano
Boyet Soriano

Level 2 Expert

293 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...