Question about 2001 Chevrolet Malibu

Open Question

Remove starter on 1999 chevy malibu 3100 - 2001 Chevrolet Malibu

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
chiquititas
  • 1010 Answers

SOURCE: Chaning right wheel bearing on 1999 Chevy Malibu

It is much easier, and cheaper to find a steering knuckle or "hub assembly" in a salvage yard.
To begin, jack up the car and remove the wheel. Be certain the car is stable and will not roll off jack(s)!
Remove the spindle nut. Remove the brake caliper (hang on a wire). Remove the bolt for lower ball join. Remove the bolt that goes thru strut. Now, pull assembly off while prying to ease pressure from the lower control arm.
Depending on how many miles you have on the car, you might want to head-off some future trouble by replacing the half-axle while you have the front end disassembled.

Posted on Jun 25, 2008

Ad
  • 1 Answer

SOURCE: how to replace headlight bulbs 1999 chevy malibu

Thanks Pierre!

Merci beaucoup!

Everything worked as mentionned. Be carefull with the plastic in the winter. Make sure to use a flat screw driver and get it close to the slider and not on the edge. I cracked one of the tongues. Those L shaped slots are under the plastic cover with the two big plastic plugs that you also remove with the flat screw driver

Pierre Godin, Boissevain Manitoba.

Posted on Feb 10, 2009

csmock132
  • 4669 Answers

SOURCE: need firing order for a 1998 chevy malibu 3100 v6

The Firing order is 1-2-3-4-5-6. But the wires go on the coils in this order1-4-6-3-2-5

Posted on Mar 01, 2009

  • 1986 Answers

SOURCE: how remove rear door panel

You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door

Posted on Aug 14, 2009

  • 205 Answers

SOURCE: Are lifters a common problem on chevy malibu 3100

That depends on when was the last time the car was serviced and how many miles its done since the last service.

If its a high milage car then having the valves set should clear up the misfire and the lifter tick.

Posted on Nov 04, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I have a 1999 Chevy Malibu 3100 and the water is not circulating through the block


Overheating problems with Chevy Malibu '01 - YouTube

? 4:03
www.youtube.com/watch?v=Qvgy-nhWz_Q
Jul 20, 2012 - Uploaded by Zyberfunnyclips Update** Problem solved: After changing the head gasket, it ran ... Overheating problems with Chevy Malibu '01 .... Malibu 3100Intake Manifold Gasket Inexpensive Miracle Repair - Duration: 12:21. by Upub5 42,848 views.

Sep 18, 2015 | Cars & Trucks

1 Answer

I have a 1999 chevy malibu its 6 cylinders 3100 engine and i have the codes with me this aare the codes that i need 1.#p0420 2.#p0410 3.#p0305 4.#p0449


P0420 - Catalyst System Low Efficiency
P0410 - Secondary Air Injection (AIR) System
P0305 - Cylinder 5 Misfire Detected
P0449 - Evaporative Emission (EVAP) Vent Solenoid Control Circuit

Sep 05, 2011 | 1999 Chevrolet Malibu

1 Answer

1999 chevy Malibu... Battery is fine and dash lights are fine when key is turned on but starter will not even attempt to engage.


Remove the power wires to the starter, turn the key to start to check for power, should have 13.6 volts, or what the capacity of you batteery is at the time, check it with a volt meter. If got power, replace starter or unbolt it from engine, it may be stuck in the flywheel,you'll see it release if just stuck,then replace on car and try to start before buying a starter.

Oct 19, 2010 | 1999 Chevrolet Malibu

1 Answer

2000 Malibu: 2000 Chevy Malibu, 3100, Car won't crank though be...


the solinoid is on top of starter. the starter is in front of engine, from underneath you can see the starter. maybe the shield has to come off if you have one on that car. but it is in front on bottom on the 3.1,

May 10, 2010 | 2000 Chevrolet Malibu

1 Answer

HOW DO I FIX/REPLACE STARTER ON 1999 MALIBU?


Starter Solenoid needs to be replaced.
Remove starter and install new solenoid

May 05, 2010 | 1999 Chevrolet Malibu

2 Answers

Where is the starter located on a 1999 chevy


Follow the positive battery cable down to the starter.

Dec 27, 2009 | 1999 Chevrolet Malibu

1 Answer

Are lifters a common problem on chevy malibu 3100


That depends on when was the last time the car was serviced and how many miles its done since the last service.

If its a high milage car then having the valves set should clear up the misfire and the lifter tick.

Nov 04, 2009 | 1999 Chevrolet Malibu

1 Answer

Need firing order for a 1998 chevy malibu 3100 v6 with ignition coil pacs


The Firing order is 1-2-3-4-5-6. But the wires go on the coils in this order1-4-6-3-2-5

Mar 01, 2009 | 1999 Chevrolet Malibu

1 Answer

How do you replace the starter in 1998 chevy malibu


The starter is very simple to replace, 1st always disconnect the battery, the wires at the starter are hot with 12 volts always present, remove the 2 attaching bolts for the starter to the engine block, then remove the wiring, one heavy cable and a bunch of smaller wires, one of those goes to the starter solenoid, mark it, the others are what are called fuse links and provide power to the rest of the car, clean up everything and then re-install in reverse order.

Dec 01, 2008 | 1998 Chevrolet Malibu

Not finding what you are looking for?
2001 Chevrolet Malibu Logo

Related Topics:

24 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...