Question about 2001 Mitsubishi Galant

Open Question

2001 mitsubishi galant that has no heat

I changed the thermasat and it still blows cold air

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: 2003 Mitsubishi Eclipse GS blows cold air in heat mode.

ok here we go and you aren't going to believe it...
I replaced the thermostat step one

I noticed that I had a small leak at the engine side of upper hose fixed that by taking it off and cleaning it and putting the hose back on Step two

then while refilling the reservoir with coolant i found that the hose that was supposed to be in the fluid was curled up on top and not sticking down in the fluid where it should be.
played with the hose until i got it to fall down in the reservoir where it should be Step 3

I started the car with the radiator cap off and let it run until it got to normal operating temp. and keep filling the radiator with fluid until the level stayed constant. Then put the cap back on and test drove. Everything worked fine haven't had that much heat in awhile and it kept blowing hot even when i stopped and let it idle for ten min.during test drive. Checked reservoir when I got home and had to add a small amount of coolant but not much.

I really think that the hose in the reservoir not being in the right place and pulling air into the system instead of coolant is the real culprit of this drama, but i replaced the thermostat to be safe.

Posted on Feb 21, 2009

Ad
  • 718 Answers

SOURCE: need to know about changing the timing belt on my 2001 mitsubishi

This will take about 3-4 hours. If you look at the drive belts, they will all have to be taken off to get to the timing belt. The engine crankshaft has to be positioned for marks to line-up. The crankshaft will have to be prevented from turning so you can take off its drive pulley. Rotate until the alignment cylinder is near TDC, remove sparkplug, then packing a small rope on top of the piston prevents the engine from turning.. Once you change one timing belt, you will never buy another car with a timing belt again. You can get a manual on eBay.

Posted on Mar 27, 2009

  • 1 Answer

SOURCE: where is the fuel filter located in the 2001 mitsubishi galant?

can you tell me where the fuel filter is located on a 01 mitsubishi galant?

Posted on Mar 27, 2009

  • 1 Answer

SOURCE: 2004 Mitsubishi Galant A/C Light Blinking on Control Switch

Just had same problem with mine. Turned out the condenser was bad.

Posted on Jun 19, 2009

SOURCE: Mitsubishi Eclipse Ac and heater problem

cold air on passenger side of car and warm on drivers, why

Posted on Oct 14, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My mitsubishi galant temp control lever won't switch to heat


that happened to me the heater core went out ive read alot of different things about 03 galants most of them have the same problem it started with a grinding noise turning the temp contol, its actually the heater control motor value it causes the heater core to go out

Dec 27, 2012 | 2003 Mitsubishi Galant

1 Answer

2001 mitsubishi galant heter dont work blows cold replaced thermostat and radaitor still cold


There is probably some kind of damper that opens and closes under the dash that allows the air from the blower to be blow across the heater core under the dash. Sometimes these are controlled electronically or by vacuum tubes. Look underneath the dash and look for small vacuum hoses that might be dangling loose or possible little wire cables that might have come off the sides.
Possibly check Haynes Manuals (www.haynes.com) to learn how to change a Heater Control Valve.

Dec 15, 2011 | 2001 Mitsubishi Galant

1 Answer

2001 dodge status rt 3.0 engine will blow out cold air sometimes. It doesnt seem to be overheating. Do I need to change the therostat.


Thats a very inexpensive route to start with. It blows out cold air when you put your heat on?If so it could also be in the heating unit itself. If your car makes a clicking noise when you switch your heat over from the AC, it could be your temperature contol unit. My wifes car had that issue, and hers is a a mits Galant, but is set up the same as some stratus's.

Nov 15, 2010 | 2001 Dodge Stratus

1 Answer

2003 galant not heating properly cold air will blow but no heat


make sure first you check your anti-freeze level. one simple procedure to do is to see if both radiator hoses are the same temp after the car is warm up. if not suspect faulty thermostat.

Oct 07, 2010 | 2003 Mitsubishi Galant

1 Answer

No heat or cold air will come out of my2004 Mitsubishi Galant. I took off the dash panel behind the glove box to get to the Blend Door Motor, but after turning the air from hot to cold at various speeds,...


Does the air blows through the dash board vents. Does the selector is functional, that means you can force the air stream through wind shield, or vents or down to the legs. If these things are OKthen check CONTROL PANEL.
Remove the trim plate surrounding the center instrument panel. Detach the electrical connectors and remove the control panel.

Read more: How to Troubleshoot the Air Conditioning in a Mitsubishi Galant | eHow.com http://www.ehow.com/how_4520422_troubleshoot-air-conditioning-mitsubishi-galant.html#ixzz0yf04FfuE

Sep 05, 2010 | 2004 Mitsubishi Galant

1 Answer

The heater blows cold air and the anitfreeze is leakig


the clamp is definitely not tight... tighten it first and see if there is a change in heat also refill what you lost in antifreeze also see it the hose itself is not leaking if so replace both to be sure and possible flush the heater core while your at that point .

Oct 15, 2009 | 2003 Mitsubishi Galant

2 Answers

A/C promblem


try driving around for almost 4 months and the damn thing wont blow cold. try spending thousands of dollars and it still being broken. and trying driving in florida in upwards 115 degrees with no cold ac everyday. you only have to wait 30 minutes? count yourself lucky!

Jun 19, 2009 | 2001 Mitsubishi Galant

1 Answer

Overheating Mistu Galant


before u add water in ur radiator make sure u start ur engine and remove ur radiator cap and pour water to it when u see there is no more air in ur radiator u can close it and it will work good

Dec 27, 2008 | 2001 Mitsubishi Galant

Not finding what you are looking for?
2001 Mitsubishi Galant Logo

Related Topics:

83 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...