Question about 2006 Chrysler Town & Country

1 Answer

I have a 2006 town and country limited i bought a new tmps and got it programmed by the dealer it worked 20 min after i left the dealer and it came back on saying (1) tire low pressure i checked all the pressure in all the tires everything is 36 psi how can i reset the tmps from the overhead console or in general? pls advise

Posted by on

  • thomas yates Jan 03, 2013

    How do i go about doing so?



1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that hasĀ over 10 points.

    Welcome Back:

    Visited the website for 2 consecutive days.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 10 Answers

Try removing power from the computer

Posted on Jan 03, 2013

  • thomas yates Jan 03, 2013

    How do i go about doing so

  • Greg Raine
    Greg Raine Jan 03, 2013

    disconect the battery and leave it for several minutes.



5 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: resetting TPMS (Tire Pressure Monitoring System) visit yhis site it may help you

Posted on Oct 23, 2008

  • 4 Answers

SOURCE: how to retrain tpms after tire rotation?

I have a 2005 with tire pressure monitoring also and was surprised when I rotated the tires that the system continued to work O.K. The manual says the dealer must retrain the sensors to recognize the tires but so far mine seem to be working just fine.
Retraining probable requires digital readout box to reset the computer and unless you know someone who has one the dealer is probably your best bet.

Posted on Jan 10, 2009

  • 840 Answers

SOURCE: Service Tire Pressure System - Chrysler 300M 2002

try disconnecting the battery for 15-20 minutes then check again/ Please rate my response thank you very much

Posted on Feb 01, 2009

  • 1 Answer

SOURCE: tpms light on 2006 town and country

Same thing happened to my 2006 T&C when the weather turned cold. I found that the recommended tire pressure was 36 lbs/sq. in. When I inflated all 4 tires to this pressure, the light went out after driving a few miles.

Posted on Feb 10, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Pulls to left while hard acceleration pulls to the right after shift and rpm's drop off

Probly done wrong. Get it realined or havit inspected at a specialist not a dealer. Also send issue to

Sep 05, 2016 | 2006 Chrysler Town & Country

1 Answer

08 towwn and country keyfob stopped working ,replaced battery,battery shows 2.9 volts.also want to program 2 new fobs with one existing fob.any solutions ?

I had one go bad on a Buick of mine...After replacing the battery. A couple of times. Had to go to the dealer for a new one.....It also had to be programmed by the dealer....

Nov 30, 2014 | 2008 Chrysler Town & Country

1 Answer

How do you disable tmps on 2006 Chrysler town and country?

TPMS-tire pressure monitor system

Is required on most or all vehicles starting in 2008 on
& is a federal law that requires it be there

No way to disable

You can pull a fuse I guess ,but can not go thru
inspection like that

Jan 03, 2013 | 2006 Chrysler Town & Country

2 Answers

2006 Town and Country began whining noise up front, which kept pace with the motor; reved up moter, highr pitch whine. Power steering fluid is adequate, but circulating in resevoir. Is this normal?

ok the serpentine belt had to be replace every 20 000 to 25 000 miles the tensioner had a limit if it reach tha point the brlt is loose beter replace it

Dec 16, 2010 | 2007 Chrysler Town & Country LX New Cars

3 Answers

The power locks have stopped working, what can do to fix it?

I had the same problem with my 2005 Town & Country Limited, and the dealer didn't have a clue what was causing it. After doing some research, I found the fuse (20 amp) that's associated with the door locks and unplugged it for about 10 seconds, and then plugged it back in. The fuse was not bad, but seamed to reset the system. Give it a try. It's simple and free. Good luck.

Mar 19, 2010 | 2005 Chrysler Town & Country

1 Answer

Early wear on front brakes /rotors for 2008 Town and Country

I work for a brake repair shop and trust me you are not alone.Enterprise and alot of other people bought the same van and had the same trouble.I hate to say but it doesnt stop there.About every 14 to 15 thousand miles you have to replace the front pads.As of now they dont have an upgrade,for instance ceramic pads, but I am sure they will very soon

May 01, 2009 | 2008 Chrysler Town & Country

1 Answer

Program a transponder key

this must be done by the dealer.

Mar 21, 2009 | 2006 Chrysler Town & Country

Not finding what you are looking for?
2006 Chrysler Town & Country Logo

128 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts


Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8575 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides