Question about 1991 Dodge Stealth

1 Answer

I put a used fuel pump and the float ,and the car was running good . about an hour later. the car start running like a bad miss fire. i change the old pump back, and put new spark plugs . change the distributor and rotor and ing coil and still.

Posted by on

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 153 Answers

TRY REPLACEING YOUR FUEL FILTER.

Posted on Jan 03, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

shaggyrat
  • 1224 Answers

SOURCE: 2003 dodge stratus multiple misfire

you hooked the wires up wrong the whole fuel injector wire assembly goes up to the fire wall then clips into main wires
the fuel injector track is one track with wires
when you replace wires you also want to replace the injectors to match
buy new engine wire harness this will solve the problem

Posted on Jun 13, 2008

  • 2 Answers

SOURCE: 1997 dodge ram 1500 v6,i have a misfire,ive changed plugs,wires,distributor cap,rotor cap,fuel pump,rollover valve,coil,still has a miss

you can try changing the ignition coil, I own a 97 Dodge 1500 and mine did the same and thats what i had to do.

Posted on Oct 08, 2008

  • 2 Answers

SOURCE: failed e-test

O2 sensor helped me but not enough to pass. Loosen your distributor bolts, one on each side, turn your distributor counter clock wise about 1/4 inch and tighten bolts. This will raise your CO but should reduce the NOX. When the vehicle is passed, undo the changes.

Posted on Nov 16, 2008

alicantecoli
  • 22156 Answers

SOURCE: 1985 Dodge W-150 4x4 5.9

got to be ignition module ,check for feed to it and if you have a feed then check the earths and if ok just change it ,these thing can just stop when you turn engine off ,never seen one go whilst being driven .

Posted on Dec 14, 2008

dennymulford
  • 1055 Answers

SOURCE: 86 dodge 250 v8-318 no fire at spark plug, will not start

did you change the main coil and coil wire?if so then check the ing resistor and then the computor box

Posted on Mar 20, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1995 ford contour 2.0 L turns over but wont start put in new fuel pump and filter and still wants to start but wont what should i check now ?


If the vehicle is equipped with a timing belt, make sure it hasn't jumped throwing the valve timing off.

May 02, 2015 | 1995 Ford Contour

1 Answer

I have a 1997 discovery v8 was running fine until a couple of days ago put new fuel filter on and it helped a little i then changed the spark plugs and it improved a lot i went out today it turned over a...


Hi justin, sounds like you have a headgasket problem are you going through any water? If not you may have a leaking fuel injector or faullty fuel pressure regulator. you either have fuel or water leaking into a cylinder causing it to miss fire on first start up.

Nov 23, 2012 | 1995 Land Rover Discovery

2 Answers

92 Ford F150 4.9L. starts good, idles rough, dies at slow speeds


4.9 litre ?? you having a laugh its a 10ton truck engine not a pick up -global warming machine,remove the pump/sender unit and check the gauze filter also look inside tank for a something floating around ,i think the idles is not a related problem to the vehicle losing power but their is a possibility you could have a problem with the little vac operated thing on the fuel injector line that allows the fuel through only when the engine is running

Mar 15, 2010 | Ford F-150 Cars & Trucks

1 Answer

88 chevy truck 5.7 engine not firing


WHAT I WOULD DO IS TEST THE FUEL PRESSURE SOME TIMES THE PUMP WILL PUMP ENOUGH FUEL TO GET TO THE TBI BUT NOT ENOUGH TO FIRE THE TRUCK. IF FUEL PRESSURE IS GOOD REMOVE THE DISTBURTOR CAP AND INSPECT THE CAP AND ROTOR, CHECK FOR CORROTION N EITHER ONE SOME TIMES IS BUILDS UP AND STOPS THE SPARK. GIVE THAT A TRY GOOD LUCK HOPE THIS HELPS.

Nov 27, 2009 | Chevrolet Silverado 1500 Cars & Trucks

1 Answer

1996 Jeep Grand Cheroke Laredo...Ran tank low on fuel. Then after filling up would not start, while at the pump. So changed fuel filter...no start. Then changed fuel pump. Now does start and run yea! ...


Likely you did a bad thing to the tank float when working on it If so, it will need to be taken down (again) and checked. First though check that the gauge is getting power at the attachment harness (pump and power side should have a voltage pulse and good tank grounding.)

Oct 20, 2009 | 1996 Jeep Grand Cherokee

1 Answer

1997 saturn sl did some errands, then wouldn't re-start


If it wouldn't start, you have to see if you are missing fuel or fire. Could be a bad sensor, or a bad fuel pump, or if the security light is blinking, a problem with the security system.

Jun 25, 2009 | 1984 Volvo 240 Series

2 Answers

My 4 cil. yj 1995 jeep wont start, and i need it to study


hi,seem you have problem in fuel or ignition system,try to start 3 to 4 times,remove your spake plug,determine if fuel or ignition is missing,if your plug is wet of fuel,look your ignition system,if no fuel is present,try to check your filter ,fuel line,fuel pump if working,ty

Apr 13, 2009 | 1995 Jeep Wrangler

1 Answer

I have 2000 xterra, bad fuel pump?


check manual for a fuel system reset switch .good luck

Mar 02, 2009 | 2001 Nissan Xterra

2 Answers

1985 conrvette


poss. is fuel pressure reg. problem. put a guage on the test port and check press. should be above 35psi. see if it stays running when you spray choke cleaner in the pcv valve steadily while starting. if the engine stays running after a few seconds of running on choke cleaner then probably a bad fuel pump relay cause the oil pressure switch will keep the pump on without the relay when it has good oil pressure.
let me know if ya can do this or if it helps.

Jul 04, 2008 | 1985 Chevrolet Corvette

Not finding what you are looking for?
1991 Dodge Stealth Logo

52 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8215 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...