Question about 2010 Mazda CX-7

1 Answer

Mazda cx 7 battery problems

Two days ago I was going to start my mazda cx7 and come to find out it would not start so I had it jumped and it ran. So I took it up to firestone and asked them to take a look at my battery, Firestone told me that it was my battery and I had it replaced that day. I then drove over to my boyfriends house with no problem until the next morning I went to start up my car and it would not start up again.. DEAD! So I am just wondering what could cause a car to die when it hadn't even been started over night! Please helpful comments only!

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Mazda Master
  • 5,280 Answers

Check or have the battery's state of charge tested with a voltmeter. If the battery is low on charge, have it charged up. If all connections on battery and starter are clean and tight,, car should start. If you get it started and the alternator/battery light stays on with car running, there is a charging system malfunction. Have the alternator tested, in that case.

Posted on Jan 03, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

rcampsr
  • 90 Answers

SOURCE: 1991 Mazda 626 DX dies suddenly after running for 10 minutes.

Hello, It sounds like an engine ignition control module gone out or a coil. They get hot and quit working after a short period of time, cool off then work again till they get hot.
Is the ignition system pointless electronic or does it have points? Are you getting any fire at all now to the cylinders? Does the tach in the vehicle show any RPM's during cranking? Do you have voltage at the positive side of the ignition coil? Does the coil meet the ohm ratings for that years vehicle ignition? Does the vehicle have oil in it so the oil pressure sensor allows the engine to run, this may not be an option on your particular vehicle? You can check most of this out with a volt/ohm meter. Check your voltages before starting the vehicle, during running and after it quits to see where the loss is. Just don't get near the center tap of the coil or you will get a rude awakening and/or serious injury. Good luck, RAC

Posted on Apr 18, 2009

stormbrewin
  • 426 Answers

SOURCE: 2000 mazda MX-5 1.8l

Have you checked that you have power to the coil on cranking?You may also want to check wether you have a good strong spark at the spark plug.It could be an ignition module breaking down.If you have no power to the coil you may need to change the ignition relay.Its close to the battery.

Posted on Oct 26, 2008

SOURCE: 2004 Mazda RX-8 will not start

Start your car and unhook the battery if your car dies your alternator is bad.

Posted on Mar 20, 2009

  • 13 Answers

SOURCE: Randomly won't start, happened after jumping dead battery

Probably the battery. Take it the chain auto parts place and they will test it for you.

Posted on Aug 29, 2009

Gort007
  • 1187 Answers

SOURCE: Having problem with Mazda 6

#1 The negative battery cable is loose, corroded, damaged, or otherwise not making a good ground connection where it connects to the engine block.

#2 Another possibility, just as likely, is the positive cable not making a good connection to the starter solenoid.

#3 You might as well clean the battery clamps and battery posts (probably cleaned when new battery was installed)

Highly likely that all mechanical parts are ok. Do not change-out the starter.

Posted on Oct 23, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why is my 2008 Mazda cx7 just clicking I replaced battery and starter


check the ignition switch.i once had the same problem

Mar 29, 2015 | 2008 Mazda Cx 7

1 Answer

Replacing struts on Mazda CX7


There are 3 Nuts inside the Engine Compartment, There is one Bolt on the Lower Arm and you have to remove the ABS and Torsion Rod. You need a Spring Compressor to do this job.

Apr 15, 2013 | 2007 Mazda CX-7

1 Answer

TCS light logo stay on --2010 Mazda CX7


Best Manuals


for the best solution of your problem visit this site

Feb 25, 2013 | 2010 Mazda CX-7

1 Answer

2008 madz cx7.. will not start and it does not show a problem when they ran diagnostics on it


Sometimes a starter will develope a flat spot. You can tap the starter with a hammer to coax it into starting. Before tapping it verify the cables to the starter are in tact and if you have a volt meter you can verify if the ignition is providing power to it.

Jun 12, 2012 | 2008 Mazda Cx 7

2 Answers

Battery


Maybe starter, Why was the battery replaced Or you recived a bad battery

Dec 19, 2011 | 2007 Mazda CX-7 Grand Touring

1 Answer

Timing belt same clicking noise 2007 mazda cx7


vvt actuator and you are driven by timing chain not belt common problem in cx-7

Feb 11, 2011 | 2007 Mazda CX-7 Grand Touring

2 Answers

PROGRAMMING THE GARAGE OPENER ON MY REAR VIEW MIRROR ON A 2007 MAZDA CX7


GOTO HOMELINK.COM

THEY MAKE THE SYSTEM AND HAVE INSTRUCTIONS YOU CAN DOWNLOAD.

PLEASE NOTE: NOT ALL BRANDS/MODELS OF OPENER WILL WORK WITH THIS SYSTEM.

HOPE THIS HELPS

May 12, 2010 | 2007 Mazda CX-7 Grand Touring

1 Answer

I am trying to replace the low beam bulb on the passenger side of a 2007 Mazda CX7 . Can't seem to figure out how to get to it. Any help?


Open the 2007 CX-7 Owners Manual (here is you don't have one http://www.mazdausa.com/MusaWeb/pdf/manuals/2007CX7OM.pdf)
Go to page 8-35 (P. 331 in the pdf). Close the hood, you're in the wrong place. Remove the cover in the front of the wheel arch to expose the headlight assembly.

Jun 08, 2009 | 2007 Mazda CX-7 Grand Touring

Not finding what you are looking for?
2010 Mazda CX-7 Logo

1,623 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...