2001 chevy duramax losing fuel prime - Chevrolet Cars & Trucks

Search Results

images for Where is the fuel pump prime connector .
Fuel pump prime connector - CamaroZ28.Com Message Boardwww.camaroz28.com > ... > LT1 Based Engine TechFeb 16, 2008 - I would like to pump most of it out using the fuel pump and was wondering if ... '92 chevy k1500 4x4 dd ... 1996 Pontiac Firebird Trans Am WS6.Chevrolet C/K 1500 Questions - Fuel delivery - CarGuruswww.cargurus.com > Questions > Chevrolet > C/K 1500CarGurusApr 18, 2014 - I replaced the fuel pump relay as well as the 20 amp in line fuse. ... Also bad grounds and any connector ... when truck sits it loses fuel system prime. truck runs smooth, fuel delivery is constant at high speeds, terrible ... my 1996 chevy 1500 4x4 5.7 will not run, its firing but no gas. i replaced the fuel filter and ...location fuel pump prime connector 97 chevy k1500 ...

Chevrolet S-10 Questions - Fuel System Loses Pressure ...

www.cargurus.com > Questions > Chevrolet > S-10

CarGurusJul 28, 2012 - Fuel System Loses Pressure - I have a 2003 Chevy S-10 Pick Up with the 4 ... car a few times, what essentially you are doing is priming the fuel pressure. ... A dirty fuel filter will not cause the lines to lose pressure after the engine is shut off. ... I have a 98 s10 2.2 liter and it was driving fine all day then when ...

Chevrolet S-10 Questions - My 2001 S10 has a hard starting ...

www.cargurus.com > Questions > Chevrolet > S-10

CarGurusSep 16, 2012 - My 2001 S10 has a hard starting problem if the truck sits between 1 ... Vacuum leak, have you checked fuel pressure while it sits? ... Would the spider alsocause a misfire at low rpms? .... at an idle, or squeaking while driving and it gets faster as you go? ..... 1994 Chevrolet S-10 2 Dr STD Standard Cab LB.

Chevy S-10 Won't Start - Repalced Fuel Pump and Pressure ...

www.cartruckinfo.com/chevy-s10-wont-start.html

Chevrolet S-10 pickup won't run and has no fire unless I jumper the fuel pump relay. ... Once the truck starts and is running you can remove the jumper to the fuel pump ... Iwould get the fuel pressure checked to start with, because that's where the ... 93 gmc 4.3l FI runs but dies out loss of power after 5 mins of running then ...

Stalling S10: I Have a 1994 Chevy S10 2.2l It Stalls After 35 ...

6 6 Duramax Crank no start GM Chevy GMC Tech Tips Angry mechanic
Duramax LLY FICM Injector Trouble Misfire Part 1

suggest you look at a bunch of these youtube videos .

just had this problem it was the PDM ended up replacing the glow plugs
best price and life time warranty for both was at Auto Zone recommend if you buy the PDM get the extension cable and move the PDM to a cooler location

YOUR ELECTRIC FUEL PUMP IS THE DIESEL INJECTION PUMP.

cant lose prime...it gets primed everythime you turn the key off and back on for more than 10 seconds.

have you had the coil pack controller checked?

any Check engine light when its running?

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/sean_54c3a3dc48a7773c

fuel pump is obviouslynot working !
check it & its wiring!!!!!

replace the fuel filter open the valve and crak till you get furl and foam does not come out.

Well, one problem is, if its an 8.1, its not a diesel. The 8.1, or Vortec 8100, is a gas engine. The DuraMax is a 6.6 engine. There is usually not a priming system on a gas engine, because the fuel pumps will usually get it through the smaller filters used quick enough you dont need them. However, if it is a DuraMax engine, then right on top of the fitting where you mount your diesel filter, there is a primer pump and an air bleed valve. What you do is, open up that air bleed valve ( its a little black plastic octagon shaped thing on the top of the filter mount) then you pump the primer (the silver button looking thing) until you get diesel squiting out the air vent without too many air bubbles or gurgles.

if it dont have good compression it will not start check the comp and make sure there no water in oil if fuel pressure is low it will not pop the injector open try some starting fluid