Question about 2007 Saturn Relay-1 FWD

Open Question

Abs, traction control light is on 2007 saturn relay

Abs, traction control and stability warning is on

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 87 Answers

SOURCE: '98 SL2 Saturn Traction Control

traction control is for wet or slippery conditions it can either be turned off or on

Posted on Mar 09, 2009

Ad
ewashmidas
  • 362 Answers

SOURCE: '98 SL2 Saturn Traction Control

Traction control helps limit tire slip in acceleration on slippery surfaces. In the past you had to feather the gas pedal to prevent the drive wheels from spinning wildly on slippery pavement. Many of today's vehicles employ electronic controls to limit power delivery for the driver, eliminating wheel slip and helping the driver accelerate under control. Don't turn it off.

Posted on Mar 10, 2009

emissionwiz
  • 76682 Answers

SOURCE: how to reset the abs warning light?

there is no reset, the light will remain on until whatever fault that turned it on is fixed, then it turns itself off.

Posted on May 21, 2010

  • 28 Answers

SOURCE: 2007 Saturn brake lights stay on go off when brakes are applied

My first suggestion to try for this car is to disconnect the battery, take and pull the access panel on the fuse box on the passenger side of the vehicle. Buy a pack of dilectric grease at autozone or another part store the small packets (usualy 1.27 or something) then unbolt the ground wires which are located in the fuse access towards front put grease on it and tighten down bolts again. Making sure they go completly flush on my car there was a burr in the middle of the threads and this fixed my issues. I was having random service esc, and airbag light on and various other gremlins at diffreent times. It Fixed mine it's worth a try.The factory claims diletric grease is the fix i just think they didn't tighten down the bolt under the dash but I would use it all the same.

Posted on Dec 06, 2011

  • 51 Answers

SOURCE: saturn vue 2004 intermittent abs and traction control comes on and after restarting shuts off?

Has this happened after you replaced the sensors for the abs. if so they have to be set at a gap close to the rotor sensor to read correctly. The other thing maybe if the new sensors area slightly different to the original ones the abs might be having trouble identifying them.
The last one maybe, could the new brake pads be causing flexing or pushing against something resulting in this intermittent problem.

Posted on Jun 13, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Electronic stability control & abs & brake assist warning indicator lights are coming on after an accident. How serious are they?


You have damage to the front area brake system. It could be very serious but if car stops OK most likely not that serious you just won't have abs or traction control. The damage is most likely a speed sensor or something similar. I said it could be serious that is only worst case.
Here is a breakdown of what lights mean
ABS keeps your breaks from locking up
BREAK ASSIST helps your breaks
Traction control if you one wheels spin more than others system adjust wheel spiN

Dec 19, 2015 | Cars & Trucks

1 Answer

My traction & stability control warning keeps coming on, not all the time but occaisionally


You have a problem with the abs an there is a code stored in the EBCM - electronic brake control module . It could be any number of thing's from a wheel speed sensor to a wiring problem or the control module or the modulation pump . As long as the light is on the ABS is deactivated . I would take it a qualified ASE certified repair shop that knows ABS systems

Apr 28, 2015 | Cars & Trucks

1 Answer

Just got my oil changed and the day after my vsc lights come on- any connection?


Whenever this warning light or any other stays on in the dash it is indicating that the systems control module (or the system sensor in the case of lights like low oil pressure, door open indicators etc.) has detected a fault, it then disables the system (this applies to ABS,TCS, TCM, SRS and BCM faults and others) as long as the light is on. You must now have the dealer hook up a special electronic diagnostic tool and "scan" the system for the fault code that is stored for the problem(s)

Legend of Abbreviations. ABS Antilock brake system.TCS Traction control system, TCM Transmission control module, SRS Supplemental restraint system, BCM Body control module

Oct 22, 2012 | 2007 Toyota Camry

1 Answer

I have a 2002 VW New Beetle. The ABS light has come on and there is a chiming beep and the ABS light flickers. What could be the problem?


ABS - Anti-lock Brake System.
If the ABS lights on the dashboard permanently the ABS system is faulty. You must access the ABS Electronic Control Unit (ECU) memory for pull out all DTC (Diagnostic Trouble Codes), using diagnostic equipment connected to the data link connector of the car. Then you will be full informed about bad pieces (e.g.: front right wheel abs sensor interrupted, ...). After bad pieces replacement you will be able to erase all faults memored by ABS ECU, in other words reset the ABS system and turn off the warning lamp on dashboard.
ASR - Acceleration Skid Control system.
When ASR warning light blinking the system is activated itself for car acceleration skid control.

For today's typical high-torque engines, traction control (ASR) can increase both comfort and safety, particularly when driving on slippery roads or surfaces offering differing levels of grip. Traction control permits smooth starting and acceleration through the full speed range without wheel-spin or fishtailing.
tdisline_703.jpg


ASR only operates in conjunction with the electronic accelerator (E-gas) and uses components of the anti-lock braking system (ABS). If one wheel suddenly begins to rotate faster than the others (slip), ASR intervenes in the engine management system and reduces power until the wheel stops spinning.
The ASR system represents a further contribution to active safety as it maintains vehicle traction and directional stability throughout the acceleration phase at any speed. In addition, it reduces tyre wear. Activation of the ASR system is indicated by a flashing indicator lamp in the instrument cluster.
The ESP system means the Electronic Stability Program. ESP system includes the ABS system.


Jun 30, 2011 | 2000 Volkswagen Beetle

1 Answer

What does it mean when 1999 Ford Explorer ABS warning light on dashboard comes on?


That means that the EBTCM has detected a problem within the system.The message indicates that a malfunction exists in the stability enhancement feature.

EBTCM (Electronic Brake and Traction Control Module) is an electronic control module that controls and operates the Anti-Lock brake system, Traction Control System and Stability system. If this module detects a problem, it "asks" the cluster to inform you by displaying a warning message.


You should have your car scanned for trouble codes with a scan tool, the Tech2 scan tool is preferred because other scan tools may not communicate with the EBTCM modules.

Hope helps (remember to rate this answer).

Jun 02, 2011 | 1999 Ford Explorer

1 Answer

My traction and stability controll failure lights along with my ABS warning light are constantly on


i believe they are related to a abs problem. the car uses the abs to control the stability (braking on certain wheels when nessisary) there is probably a malfunction in the abs system that's why the light is on constantly. this would need to be looked at by a professional repair facility.

Mar 14, 2011 | 1998 Jaguar XJ8L

Not finding what you are looking for?
2007 Saturn Relay-1 FWD Logo

Related Topics:

370 people viewed this question

Ask a Question

Usually answered in minutes!

Top Saturn Experts

yadayada
yadayada

Level 3 Expert

76673 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Saturn Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...