Question about 2005 Honda Accord

Open Question

2005 Honda odyssey P2647 code on meter check

Car running erratic, plus VSC light on along with check engine light

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 279 Answers

SOURCE: Question regarding a honda odyssey 1999 check engine light codes.

Ramon
P0420 relates to the catalytic converter. The computer sees little or no improvement in the exhaust before and after going through the converter. Either your oxygen sensors need replacement (3 total) or you need a new catalytic converter.
What is the mileage on the vehicle? Does it run well? Oxygen sensors generally start to fail after 70,000 miles. Catalytic converters usually fail because the engine is runnig rich and the owner ignores that fault for months. This causes the catalytic converter to overheat and fail.

P1456 relates to the evaporative emission system. This system holds the gas fumes in the system so they are not vented to the atmosphere. The most common cause of this code being set is failing to properly tighten the gas cap after refueling. Take the cap off and clean the sealing O-ring. Put it back on and tighten till it clicks 3 times. Make sure you have the correct gray colored gas cap. Clear the code and see if it resets within a few days. If it does, try replacing the gas cap.
Charlie

Posted on Jun 26, 2008

professio101
  • 158 Answers

SOURCE: Our 2005 Honda Odyssey had a check engine light / misfire

When a cylinder mis-fires there is a reason. The dealer should have told you that. Most likely you have a fouled out spark plug. Which means you need new spark plugs and maybe wires. All this would be covered in a standard tune up. Once the bad spark plug is replaced, the computer will quit registering a mis-fire. Please give good ratings, they meen a lot to us.... Thank you

Posted on Aug 01, 2009

  • 1 Answer

SOURCE: tcs light and engine check light on my 2000 honda odyssey

I had the same code/symptoms a few weeks ago. Dealer did a nice job checking through all the details. Replaced the egr too, but no improvement. Finally found one cylinder not firing correctly (not the same pressure as the other cylinders.) Dealer did a value clean/adjustment, for about $250, and the problem has been gone for about a month now. We are also getting about 15% better mileage.

Hope this helps.

Posted on Sep 09, 2009

  • 3640 Answers

SOURCE: check engine light on on

p2647 is rocker arm actuator A- bank 1 stuck on--- to fix it should be the VTEC oil pressure switch. That switch will be on the cylinder head. Towards the windshield and passenger's side (I think).

Go to www . hondapartsdeals . com {remove the spaces when typing}

Go to parts, enter your car's info. System: Engine Component Vtec Oil control valve. That diagram should help a lot.

Good Luck.

Posted on Jan 27, 2011

skychief2001
  • 21873 Answers

SOURCE: 2005 Honda Odyssey Engine check engine light is on, ECO light is not working. What could be wrong? How much can the damages be?

You'll need to have someone check the computer for trouble codes to proceed. Once you have the codes you can research the causes.

Posted on Aug 22, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

P2647 on Honda accord 2003 what is and where is located in the engine?


The code is for the VTEC(variable timed exhaust camshaft) oil pressure solenoid. If it is a 4 cylinder engine, the solenoid is located on the back of the cylinder head near the fuel injector rail. Most of the time you can simply clean the screen on the solenoid to cure the problem. Also, too heavy weight of oil can cause the system to malfunction. Make sure to use a 5w30 engine oil,Honda prefers Castrol.

Feb 24, 2015 | 2000 Honda Accord

2 Answers

What does it mean when the vsa indicator and the engine emblem appears at the same time with code p2647?


I am not sure why they would both come on at the same time but the code P2647 means - Rocker Arm Oil Pressure Switch (VTEC Oil Pressure Switch) Circuit High Voltage.

So first thing first in diagnosing this code is to check the oil level.
Have the engine run for a bit and get warm to build up proper oil pressure. Then turn engine off and let the vehicle sit for a minute or two. Have the vehicle on level ground and check the oil level and condition.
If the level is low then top up till it is at the full line. When the engine oil level is low it may not have enough oil pressure to control and activate the VTEC system thus causing this code.
If the oil is super dark and black then you may be due for an oil change. (should be done around every 5000km.)

Sep 27, 2014 | 2006 Honda Odyssey EX

1 Answer

VSC Light TRAC OFF Check engine


well not sure, lights indicate a problem, if he reset lights, and they come back, then there might be another problem,

May 20, 2013 | 2005 Scion xB

1 Answer

Check engine light on on 2005 honda accord coupe. 4cylinder. code is p2647 said trouble shooting do all repairs on vehicles but do not know that code.


p2647 is rocker arm actuator A- bank 1 stuck on--- to fix it should be the VTEC oil pressure switch. That switch will be on the cylinder head. Towards the windshield and passenger's side (I think).

Go to www . hondapartsdeals . com {remove the spaces when typing}

Go to parts, enter your car's info. System: Engine Component Vtec Oil control valve. That diagram should help a lot.

Good Luck.

Jan 27, 2011 | 2005 Honda Accord

1 Answer

I recently got my (Honda Odyssey 2006) oil changed by a non Honda tech and now i need the service maintainence signal -code A14 reset so that i can be notified when the next oil change is due.


  • Lets get started. Place the key in the ignition and turn as if to start your minivan - but do not actually start your Odyssey.

  • 2) Locate and click the black odometer button located near the bottom of the instrument panel until "Oil Life" along with a percentage value appears.
  • 3) Release your finger from the button, then press and hold the button for ten (10) seconds.
  • 4) Once again, release your finger from the button, then press and hold the button for five (5) more seconds. Lets count: one Mississippi, two Mississippi, etc. all the way to five.
  • 5) Your Honda Odyssey's display panel should read "Oil Life 100%." You are done!



  • Read more: How to reset the oil life indicator light on a 2005 Honda Odyssey ' eHow.com http://www.ehow.com/how_5297874_reset-light-2005-honda-odyssey.html#ixzz1C47PKfr7

    Jan 25, 2011 | 2005 Honda Odyssey

    1 Answer

    Check engine light on, did not reset after driving 500 plus miles and tightening gas cap, car was just in for 112K service 3 days before light came on, dealer said it would take a few days bc it is cold...


    Well the check engine light should be off at the time they finished their on it . because all you do is erase the code and the light goes off. Good luck

    Dec 26, 2010 | 2005 Honda Odyssey

    1 Answer

    My Honda avs light comes on along with check engine light, them the engine runs rough? What does this mean?


    When there is a code present in the PGM-FI system the check engine light comes on. The VSA system see's this code and stores a code for power-train system failure and turns on its light too. If the engine is running rough you should get it diagnosed ASAP. Some repair shops pull codes for free or you can get a code reader at your local parts store for the do-it-yourself-er. Find out what codes are present and I can help you more if you want to diag it yourself. lmk

    Mar 08, 2010 | 2005 Honda Odyssey

    2 Answers

    Our 2005 Honda Odyssey had a check engine light / misfire


    When a cylinder mis-fires there is a reason. The dealer should have told you that. Most likely you have a fouled out spark plug. Which means you need new spark plugs and maybe wires. All this would be covered in a standard tune up. Once the bad spark plug is replaced, the computer will quit registering a mis-fire. Please give good ratings, they meen a lot to us.... Thank you

    Aug 01, 2009 | 2005 Honda Odyssey

    Not finding what you are looking for?
    2005 Honda Accord Logo

    Related Topics:

    141 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Honda Experts

    yadayada
    yadayada

    Level 3 Expert

    75117 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22095 Answers

    Jeff Turcotte
    Jeff Turcotte

    Level 3 Expert

    7772 Answers

    Are you a Honda Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...