Question about 1994 Isuzu Rodeo

Open Question

Where is the thermostat located in a 1994 isuzu rodeo

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 3 Answers

SOURCE: 1994 isuzu holden rodeo injection timing adjustment

try u-pull our patrs

Posted on Sep 12, 2008

Ad
  • 15 Answers

SOURCE: 1998 isuzu rodeo thermostat location

0eafb73.gif
Hope this will help...

Posted on May 07, 2009

brandyspoile
  • 61 Answers

SOURCE: Crank Sensor in 94 Isuzu Rodeo

it's on the bottom of the motor, towards the back on the passenger side. It has a small clip of wires and one screw holding it on. You may want to pull it up on ramps- if it'll run- otherwise, get under the Rodeo, it's up a little higher than the oil pan, and to the passenger side. (it's right on top of the two lines that run to the bottom of the radiator.) You will need a 10mm socket to remove it. I have added a few pics showing the location (i just completed this task myself)
bfcf016.jpg61ae995.jpgdeffbd6.jpgdd2e415.jpg

Posted on Jul 24, 2009

  • 50 Answers

SOURCE: Isuzu rodeo leaking coolant from engine

with my experiance on these engines it's usually the upper outlet hoses running from the heads into a t then into the upper radiator hose they are pain to replace but 3 out of 3 of my v6 isuzu's have had the same problem you'll have to pull off the theromstat and the coil pack the hoses are very small and run from the end of the heads one on each into a t then into the radiator hose just under the housing

Posted on Dec 26, 2009

  • 1 Answer

SOURCE: replace water pump 1994 isuzu

I am replacing my water pump on a 1994 Isuzu pick up truck with a 3.2 L engine (V6). (VIN ENGINE I.D. LG6) I am a little timid about replacing the water pump because of the removal and installation of the timing belt. I an afraid about disturbing the valve timing. Could you described fully the process involved with this part of my project?

HWW

Posted on Feb 08, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I locate the power window circuit breaker on 1994 Isuzu Rodeo


its in the fuse box under the left side of the steering wheel .open the little door of the fuse box and its on the bottom left side its about 1" long with a little red button in the middle

Oct 17, 2014 | 1994 Isuzu Rodeo

1 Answer

Where is located cooler temp sensor


you mean the temperature sensor will be around top of engine in cylinder head or thermostat housing

Sep 09, 2011 | 1994 Isuzu Rodeo

1 Answer

Where is the diagnostic plug located in a 1994 isuzu rodeo?


It should be located within 1 foot of the steering wheel. Have a look underneath where the drivers feet go in that area. It is a fairly large plug and should be pretty noticeable

Dec 01, 2010 | 1994 Isuzu Rodeo

1 Answer

No Heat!!!!!!!! My 94 Rodeo is cold. The coolant level is good, it gradually got colder, then no heat. I need some help locating the heater core and the heater control valve. thanks


I'd check the thermostat first. Down here in FL, our thermostats never close, because it never gets cold enough, or is it the other way round?? either way, if it sticks open, you can wrap the radiator in cardboard and still not get any heat. Check it out.

Jan 02, 2010 | 1994 Isuzu Rodeo

1 Answer

Where is the oil pressure switch on the 1994 isuzu rodeo V6


IT IS LOCATED ON THE OIL FILTER. ITS ROUND WITH A WIRE ON 1 END

Dec 18, 2009 | 1994 Isuzu Rodeo

2 Answers

Crank Sensor in 94 Isuzu Rodeo


it's on the bottom of the motor, towards the back on the passenger side. It has a small clip of wires and one screw holding it on. You may want to pull it up on ramps- if it'll run- otherwise, get under the Rodeo, it's up a little higher than the oil pan, and to the passenger side. (it's right on top of the two lines that run to the bottom of the radiator.) You will need a 10mm socket to remove it. I have added a few pics showing the location (i just completed this task myself)
bfcf016.jpg61ae995.jpgdeffbd6.jpgdd2e415.jpg

Jul 13, 2009 | 1994 Isuzu Rodeo

Not finding what you are looking for?
1994 Isuzu Rodeo Logo

Related Topics:

84 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14381 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...