Question about 1999 Mercury Cougar

1 Answer

How to replace left control arm on 99 mercury cougar

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Mercury Master
  • 946 Answers

Here's what I found on Yahoo answers:
For the driver's side: yes, you will have to raise the motor.
On all models, remove the front motor mount, Mark the position of the right engine mount, remove 3 right engine to mount bolts. remove one right engine mount to body nut. On all models hold the strut shaft with an 8 mm allen wrench, loosen top retaining nut 5 turns. Raise vehicle, remove ball joint to steering knuckle pinch bolt. seperate control arm ball joints from steering knuckle. Do NOT damage ball joint seal. Remove pinch bolt attaching steering knuckle to strut. Slide steering knuckle up on strut, Move transaxle to gain access to control arm nuts and bolts. remove 2 nuts and bolts and attaching control arm to subframe. Lifting up control arm remove.
Now this to mark the motor mount because you are supposed to use a powertrain alignment guage when putting back together. if not you can bind the motor in the unibody and make for a shaky ride.
that drivers side lower control arm calls for 4.3 hours where as the passenger side calls for 1.3 hours. So you can see what your in for.
BTW these instructions are taken straight from the Ford repair manual.

Source(s):

http://mysite.verizon.net/t2bedlam/fr.jp...

Posted on Jan 09, 2013

  • don-ohio Jan 09, 2013

    BTW,this answer and website shown is from 5 yrs. ago.don-ohio (:^)

×

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

chuck943
  • 783 Answers

SOURCE: vehicle speed sensor

You will have to get to it probably from under the car it will be located just to the right of the driver's side axle

Posted on Feb 01, 2009

  • 1 Answer

SOURCE: o2 sensors on a 99 mercury cougar v6

I just got done replacing the O2 sensors in my 99 Cougar due to throwing a P0135 malfunction code. There's 3. Facing the engine there's one in the front coming off of the front header, which is easy to get to. Another more tricky one if between the engine and the fire wall on the rear header pipe. The third is under the vehicle behind the transmission pan on top of the exhaust. In order to replace the O2 sensor near the fire wall you will need to remove the 4 retaining bolts for the ECM module and move it out of the way. Additionally you will need to remove the 2 retaining nuts for a wiring harness that is seated below the ECM module. Pay close attention to the connectors because the front and under vehicle O2 sensors have round connectors the one near the firewall has a squared connector. I was able to replace all 3 by myself in approximately 35 minutes. If your throwing a O2 heater malfunction code it is most likely going to be the sensor near the firewall. make sure that you know someone with a code reader so the code can be cleared. If you're do for an emmissions inspection be sure to put at least 40 miles on the new O2 sensor with different types of driving (e.g. highway, coasting, decellerated turns and rapid acceleration). Gotta love project cars for your kids!!

Posted on Apr 04, 2009

johnjohn2
  • 5763 Answers

SOURCE: what is the firing order of a 99 Mercury Cougar

i was try to send a diagram to you but having computer problems,even better go to this website it will show you a diagram, i know the firing order is 1342. go to www.autozone.com. hope this helps.

Posted on Jan 26, 2010

  • 1 Answer

SOURCE: MY 99 MERCURY COUGAR WILL NOT TURN OVER . I

its pats

Posted on Mar 28, 2010

  • 181 Answers

SOURCE: Where would i find the starter relay in a 99

right below fuse 15 in the battery junction box/ fuse box under the hood.

Posted on May 17, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

99 mercury cougar radio wiring diagram


1999 Mercury Cougar Car Stereo Wiring Diagram
Car Radio Battery Constant 12v+ Wire: Orange/Black
Car Radio Accessory Switched 12v+ Wire: Yellow/Green
Car Radio Ground Wire: Black/Green
Car Stereo Dimmer Wire: White/Green
Left Front Speaker Positive Wire (+): White/Black
Left Front Speaker Negative Wire (-): Gray/Black
Right Front Speaker Positive Wire (+): White/Red
Right Front Speaker Negative Wire (-): Gray/Red
Car Audio Rear Speakers Location: Side Panels
Left Rear Speaker Positive Wire (+): White/Purple
Left Rear Speaker Negative Wire (-): Gray/White
Right Rear Speaker Positive Wire (+): White
Right Rear Speaker Negative Wire (-): Gray

1999 Mercury Cougar Car Stereo Wiring Diagram ModifiedLife com

Feb 08, 2017 | Mercury Cougar Cars & Trucks

1 Answer

The motor stalls when the heating direction knob is turned on


2002 Mercury Cougar V6 2.5L problem - YouTube

? 2:28
https://www.youtube.com/watch?v=zUu256ADwJA
Jun 2, 2012 - Uploaded by 1chrisrg
U know how to adjust idle speed manually on 2000 mercury cougar? ... You may drive and the hole is too small and the coug will stall. .... I replaced the IAC and now if sounds like my engineis in a race ... I just bought a 99 Cougar. ... new edge cougar owners forums and I believe there are directions on ...

How to replace heater control panel switch knobs remove ...

? 5:01
https://www.youtube.com/watch?v=abBINs_zWh8
Jul 12, 2013 - Uploaded by kirk colombo
02 explorer - remove dash panel and replace heater and air conditioning control switch knobs. Can also ...Missing: cougar ‎stalls

A/C & Heater Controls for Mercury ' eBay




Dec 13, 2015 | 1999 Mercury Cougar

1 Answer

Im changeing a lower control arm on a 99 mercury cougar . I loosened both motor mounts an jacked up the transmission. The control arm is bent having trouble getting it off . So do i need to jack up to


sounds like the antiroll bar is causing your problem have both side of the vehicle jacked up with stands underneath to take the weight transfer off the suspension .

Sep 21, 2015 | Mercury Cars & Trucks

1 Answer

What new hardware do you replace when replaceing upper controler arm on a 1996 Mercury Couger


Borrow a repair manual from the libarry to guide you though the repair,

Nov 29, 2012 | 1996 Mercury Cougar XR7

1 Answer

How to change lower ball joint on 95 mercury cougar...do you have to take lower countrol arm off to get ball joint out?


i would replace the whole control arm because the bushing are probably worn out too and it's easier than pressing out the ball joints. make sure you have a spring compressor tool when you do this or you could get seriously injured

Nov 16, 2009 | 1995 Mercury Cougar

2 Answers

1997 mercury cougar pulls to the left when braking. i put on new tires new brake new rotors, and new calipers. thank you, tim


this car needs the lower ball joints checked for excessive play, when pressing the brake pedal the excess play is transferred to the weakest point. the ball joint can be pressed out of the lower control arm or purchased new as a new control arm.

Jul 31, 2009 | 1997 Mercury Cougar XR7

1 Answer

Blower motor fuse is located 99 mercury cougar


SECTION 412-04: Control Components 1999 Cougar Workshop Manual REMOVAL AND INSTALLATION Blower Motor Resistor Removal
  1. Remove the upper footwell trim panel (passenger side).
    • Remove the pushpins.
  1. Disconnect the blower motor resistor electrical connector.
  1. Remove the blower motor resistor.
-------------------------------------------------------------------------
f9d16f6.gif

May 06, 2009 | 1999 Mercury Cougar

Not finding what you are looking for?
1999 Mercury Cougar Logo

532 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

fordexpert

Level 3 Expert

5470 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...