Question about Honda Ballade

Open Question

How do i adjust the carb on my honda ballade encore 150 1995 model. revs are too high when choke kicks in and idle too low if enjin is hot

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 8 Answers

SOURCE: suzuki vitara 1991 model petrol

There is a module called "idle limiter". Sounds as if it is bad!

Posted on Oct 17, 2008

  • 82 Answers

SOURCE: 1989 honda prelude enigne idles high then low irratic

I had the same problem on a Rover. There was a leak in inlet manifold that was caussing the problem.
To verify, spray some sealant to temporarily seal the inlet manifold .and the eratic idling should disappear for some time.
If it does, you know there is leak in inlet manifold which you can take of and refit with a new gasket.

Posted on Oct 27, 2008

  • 43 Answers

SOURCE: 1968 Jaguar E type Carb problem

notorious for being very hard to time both carbs ..sim. probs.haunt many multi carb . set ups just ask any one with old triumphs .if carbs have never been rebuilt i think it might be time .if they have it might be time to replace .if replacing try finding ones with a fule management system.

Posted on Jan 06, 2009

roniecon
  • 6826 Answers

SOURCE: a/c blows hot air at idle

u have a trinary type switch on the high side somewhere on the high side,,,it may have 2 or more wires going to it and it is mounted on the high side line/or compressor,this is ur problem

Posted on Jul 09, 2009

csmock132
  • 4669 Answers

SOURCE: 92 honda accord surges or idles high

Have you install a timing belt recently? If you get it off a tooth it will idle high and surge

Posted on Aug 22, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Carburetor problem?


check the setting for the auto choke and adjust the linkage with it.. Adjusting screw on the throttle butterfly that runs on the fast idle cam of the auto choke.

Feb 18, 2014 | 1985 Nissan Pickup

1 Answer

Toyota tercel troubleshooting


honestly i dont know the second one but there is no way its for fuel regulation on high revs ,, maby for inceased idle speed when under loa ,,, ie aircon or all lights and heaters on ,,, to me it sounds as if main jet is blocked in carb ,,,, choke is feeding in fuel in place of main jet ,, ie fuel starvation ,,,,

Dec 01, 2013 | Cars & Trucks

1 Answer

I have a 1989 honda accord,it will start and idle high.but,when you kick down it will not idle,it has a 2brl carb. on it.


I ran into the same thing on my mom's 89 accord.... I thought it was the choke..... but I found out it was a vacuum leak on a vacuum line.... I found it by spraying carb cleaner on hoses lines with car running it don't take a lot just spray a little and if the engine revs up more you know where about the leak is and can inspect it.... check the intake around the carb and vac lines too...

Apr 22, 2011 | Honda Accord Cars & Trucks

1 Answer

My honda seems to rev up when i start it, I'm


with the egine running you can sray carb and choke cleaner around the intake . just a little at a time you will hear the idle jump if there is a leak

Feb 09, 2010 | 1993 Honda Accord

1 Answer

How to adjust choke on 87 honda accord


It might just need cleaning. Spray some PB Blaster around the throttle arm where the cable connects to at the base of the carb, and see if that frees up the flaps. And while spraying, fiddle with the throttle linkage.

Feb 06, 2010 | 1987 Honda Accord

2 Answers

Engine idles excesivly high after carb was rebuilt.


You need a new choke pull off. They are around $30 dollars.

Dec 09, 2009 | Ford F-250 Cars & Trucks

2 Answers

Just installed new carb in my 1989 honda. Used diagram to connect vacuum hoses back up, but car idle speed is too high - up to 2,000rpm. What could be wrong?


try turning down the idle via the idle adjust set screw (usually on the carburetor base). if the problem persists after the engine is warmed up, there may be an issue with the automatic choke. also check the throttle linkage by disconnecting it to see if it is holding the throttle open when connected. if this is the case, you may need to adjust it or find a slightly longer cable.

Oct 04, 2009 | 1989 Honda Accord 4 Door

1 Answer

1979 cj replased carb idles tohigh


Even with a rebuilt carb you have to make the adjustments. Check the choke adjustment and set the fast idle. If choke is to tight it will be hard to start and take a long time to idle down. The fast idle sounds like it is high also.

Oct 01, 2009 | 1983 Jeep CJ7

2 Answers

1995 Mitsubishi L300 Van 2ltr aspirated motor, Automatic choke revs extremely high on cold start, will not decelerate till engine is hot. How can I remedy this?


If it's carburetor & has automatic choke, then there is probably a screw at side of carb, by step cam that moves with choke . Back it of a little at a time until you get desired cold idle speed. Make sure you turn step cam to setting it would normally be when cold, and choke on, then turn screw out to lower rpm's. Look for a little rod from choke shaft, down to base or side of carb area, to step cam.

Jul 17, 2009 | 1988 Mitsubishi Pickup

1 Answer

Can anyone tell me how to fix this problem


if its a carb model you might need to strip and refurb the carb if not buy a second hand one they are pretty cheap or it could be a choke problem

Feb 14, 2009 | 1988 Honda Accord 4 Door

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

146 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...