Question about 2001 Ford Explorer

Open Question

Sport trac Center console removal - 2001 Ford Explorer

Posted by Anonymous on

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

satitus
  • 273 Answers

SOURCE: how do i remove the top console where the compass

It is really easy to do. If you have a sunglasses holder (or a compartment overhead) open it and remove the 2 screws in the compartment. That should be it, from there just gently pull the assembly away from the roof, there are 2-4 clips holding the assembly in place. From there remove the main wiring harness and you are good to go. I have removal instructions with pics at www.autoclockrepair.com

Posted on Dec 02, 2010

jyackle5
  • 8197 Answers

SOURCE: The lid on the center

I once took every single piece of it apart before figuring out that it was indeed 4 bolts. Doh! The two little storage compartments, and the cup holders, just pop out. Two bolts go to the dash, behind the storage bins, and two are under the cup holders. You'll need an extension to get to them. After that it won't see like it'll budge, but there is a big metal clip that it slides into, at the back, on the floor under it. It rusts, so you gotta get low on the console and pull it STRAIGHT BACK.

Remove the package tray and cup holders by grasping and pulling out by hand. There is a wiring block located directly under the stereo with a bolt holding it in place. Loosen the bolt until you can unplug the harness. There are two gold colored bolts on either side of where the wiring block was, remove these. Now if you move back until you are at the front edge of the armrest and look straight down you will see two more bolts that are exactly the size and color of the first two, remove them (you may need to grab them with needle nose pliers after they are loose to get them completely out of there) . This is the tricky part. You have to get in the back seat and pull the console straight back and slightly upward to release the two metal "fingers" that are holding the rear of the console to the floor. These fingers slide into a plate that is bolted to the floor that has two slots in it. DO NOT be shy when you are pulling the console to release these. Trust me, it takes some effort. When you get that released, just pull the whole console out through the rear seat, wiring and all. When you replace the console just reverse this procedure but make sure you don't get hung up where those four bolts go in as you are sliding the console forward and back into place. Hope this helps. Good luck!

Posted on Apr 24, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What number on fuse box that controls center console insert phone cord 2010 sport trac


I believe ford calls that, { power point}, note the fuses. Not only check the fuses, check fuse circuit for voltage, hot all the time, use a test lite.
The battery junction box is under the hood, Hopefully the fuse box cover tells you which fuse is which. Your owners manual should have this info.

26339406-r1mlcvct4yh4cjvramhmn1q0-3-0.jpg

Nov 03, 2016 | Ford Explorer Sport Trac Cars & Trucks

1 Answer

Key code for 2001 explorer sport trac


Remove defrost vent cover on top of dash look in through windshield on passenger side towards the center and there is a label with some info on it part of that info includes a 5 digit number

Mar 11, 2015 | 2001 Ford Explorer Sport Trac

1 Answer

Heater core replacement on a 2003 ford sport trac


the complete climate control assembly unit is required to be removed in order to remove the heater core. The climate control assembly is attached by studs & nuts which are accessible at the firewall in the engine compartment. The R134 refrigerant will need to be evacuated and the a/c lines at the expansion valve removed in order to remove the climate unit. Hope this helps. :)

Jan 21, 2014 | 2003 Ford Explorer Sport Trac

1 Answer

DRIVESHAFT CENTER SUPPORT BEARING FORD explorer sport trac 2007 4x4


hi the rubber around the bearing almost gone developing vibration I need the centre bearing which one in diagram is it

Dec 25, 2012 | 2007 Ford Explorer Sport Trac

1 Answer

How do I remove the stereo from my 2007 Sport Trac?


  1. Lift the console lid.
  2. Take the two screws out from the front console cover. It is the cover that goes down around the shifter.
  3. Remove the cover by pulling up from the back.
  4. Next pull the front cover off from around the radio. This cover goes all the way down to the center console.
  5. Unlug all connections.
  6. Take the 4 screws out from around the radio that hold it in.
To install just repeat the steps in reverse.

http://www.ford-trucks.com/forums/867595-2009-sport-trac-radio-removal.html

Mar 14, 2011 | 2005 Ford Explorer Sport Trac

1 Answer

The overhead compass/temp gauge is not working. how can I fix it? I have a 2002 ford expedition sport trac. thanks


If the overhead lights are working but the console is not then it is a bad console. I offer a repair service in which I replace all of the faulty electronic components, and it includes a lifetime warranty. I have a bunch of tech info there; how to remove the console, etc. Check it out and drop me a note if you have any questions, thanks! www.autoclockrepair.com

Feb 22, 2011 | 2001 Ford Explorer Sport Trac

1 Answer

How do I reset the oil change indicator on my 2007 ford sport trac


in owner manual. go to motorcraft.com if you don't have one. Pro Center, then technical info

Oct 30, 2010 | 2007 Ford Explorer Sport Trac

1 Answer

How do i remove the top console where the compass is located in a 2003 ford sport trac


It is really easy to do. If you have a sunglasses holder (or a compartment overhead) open it and remove the 2 screws in the compartment. That should be it, from there just gently pull the assembly away from the roof, there are 2-4 clips holding the assembly in place. From there remove the main wiring harness and you are good to go. I have removal instructions with pics at www.autoclockrepair.com

Sep 25, 2010 | 2003 Ford Explorer Sport Trac

1 Answer

I have a 2007 sport trac with the overhead console and sun roof. i would like to change the map lights but after removing the lens it looks like i may have to remove the whole console just to replace the...


Looks like it is pretty easily removed.

Use a small screw driver and pry open the garage door opener storage bin. You will see 1 screw there that you will remove.
Pull the front of the overhead console down and remove the console from the console retaining clips.

Feb 22, 2009 | 2007 Ford Explorer Sport Trac

Not finding what you are looking for?
2001 Ford Explorer Logo

Related Topics:

648 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5474 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...