Question about 1994 Nissan Maxima
The windshield washer pump stopped working
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
First check the fuse, then the power window switch, then the power window motor. More than likely it's the power window switch.
Posted on May 11, 2009
hello, i believe the pump is down beside the resivor, where you put the water in, you might be able to see it if you pull driver side wheele off, look right under the frame on the inside, should be bolted on the side of frame or even hooked to the resivor, passenger side
Posted on Feb 06, 2010
The washer pump has 12v constant when the key is on. The washer works on a ground, when you pull the
switch it grounds the pump to complete the circuit.
To test for power, locate the green wire that go's down to the pump. With a test light check it for 12v+.
If there's no power, check fuse #25 a 20amp fuse in the fuse block. If you have power, locate the wht/grn
wire to the pump. Clip the test light wire to a pos+
contact and have somone pull the washer switch and
use the probe end of the test light to check the
wht/grn wire if it lights, you have power and ground.
may have to access the washer bottle and pump
from under the car. Hope this helps.
Posted on Feb 14, 2010
On the drivers side of the vehicle just behind the front bumper is the washer fluid reservoir. The washer pumps (2 - one for the back and one for the front) are located ont the face of the reservoir.
1) Drain the resevoir. (You can reuse this fluid, so put it in a clean container)
2) Disconnect the wiring harness for the problem pump.
3) Remove the sprayer line.
4) Remove the pump. It is held in by being snapped into a channel on the resevoir and by the rubber grommet. This may take some elbow grease.
5) Remove the old grommet.(If your new pump came with a new grommet)
Installation is reverse. Usually new pumps come with new grommets. If not, it is ok to reuse the old one.
Posted on Mar 14, 2010
Tips for a great answer:
Aug 19, 2017 | Nissan Cars & Trucks
on Mar 23, 2012 | 2006 Nissan Maxima
Jan 11, 2016 | 2009 Nissan Rogue SL
Feb 23, 2015 | 2004 Nissan Maxima
Jan 04, 2013 | 2009 Nissan Frontier
Aug 17, 2011 | Nissan Maxima Cars & Trucks
Sep 09, 2009 | 1994 Mercury Villager
Jan 03, 2009 | 1999 Nissan Maxima
Nov 23, 2008 | 1999 Ford Explorer
23 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: