Question about 2005 Ford Focus

Open Question

2005 ford focus driver door latch schematic

I am looking for a ford focus door latch assembly schematic.

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 508 Answers

SOURCE: 1999 Ford Explorer looking for instructions for installing a door

There really aren't any directions. If it is the door latch remove the door panel. Remove the rod that connects it to the door latch assembly. Remove the nuts that attach the latch to the door and reverse the process to finish. You may have to raise or lower the window to get access to the door latch. Good luck.

Posted on Feb 18, 2009

Ad
polarcycle
  • 1392 Answers

SOURCE: 2005 ford escape assembly diagram for the front axle

If they are sealed bearings, you will need a press to get them out. If they are bolt in, just remove the brake pads/rotors, then the axle nut, then the bolts holding the wheel bearing in. Install in reverse order.

Posted on Mar 07, 2009

  • 1 Answer

SOURCE: 2000 ford windstar - rear driver power door latch stuck in shut/locked position; can't close the door since latch won't open to latch closed

put a screwdriver in the latch jaws and force it open

Posted on Jun 11, 2009

SOURCE: Just bought 2000 Ford Focus SE sedan.Neither rear

Look to see if there may be a child safety feature. Not allowing passengers to roll their own window down. The drivers window switch is the master switch that controls all others. For example, if drivers window switch was disconnected than none others would work. Some vehicles it is not necessary to remove door panel when removing the master control switch. I'm not sure if you are one of the ones that doesn't have to do that.. good luck.

Posted on Jul 11, 2010

elshaddai159
  • 1016 Answers

SOURCE: What are the steps to

Hi,

To remove the inside door handle:
1. Remove the door panel/trim
2. Pull the handle assembly towards you then slide to the left.
3. Set door latch to lock position.
4. With a thin blade screw driver, unclip the remote cable being careful not to damage the cable.
5. Installation is the exact opposite to removal.

To remove outside door handle:
1.With the door trim off, remove the grommet so that you can access a screw under it. This is in the top right area of the inside of the door.
2.Loosen the screw under this grommet, it doesn't have to be fully removed.
3. Then remove the outside door lock cover by just pulling it straight off.
4. Remove outside door handle by pulling it out then slide it to the left.

Hope this helped, let me know if you need more information.

Thanks

Jason

Posted on Aug 24, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Back near side door lock latch won't fully open preventing me from opening door from inside or outside on 2005 Ford focus possible causes


The most common cause for this is the door opening lever on the lock assembly is sitting slightly between the open and closed position and will not allow the lock arm to operate properly. I am not positive, but I think the lever is cable operated by the inside handle. You may be able to remove the inside handle assembly and access this cable and slide it in and out to see if the door lock will open

Jan 27, 2016 | Ford Cars & Trucks

1 Answer

I recently bought a 2005 ford focus sedan, I have central locking but the drivers side door wont lock :( ...every other door locks fine except for the drivers side...pleaassse help me! I live in a...


Replace the drivers side latch. It on the door jam. You have to remove the drivers side panel to get it out. Look for screws behind plastic plugs. Around the door handle and the arm rest. Sometimes around the perimeter of the door. then the panel will pop off. pop off the plastic mounts from the rods(look at them, you'll see how they come off). Three screws and two electrical plugs on the jam and pull the latch out

Nov 13, 2014 | 2005 Ford Focus

1 Answer

How to drivers door latch on 2011 Focus


Sounds like the clip that holds the rod to the latch has come apart or broken ..remove panel and inspect it

Sep 10, 2014 | 2011 Ford Focus

1 Answer

Ford explorer door lock


Pull panel off and have a look at the connection rod and latch assembly.
Rod should go from lock/handle to key hole, to latch assembly.

Could also end up being a bad lock solenoid. (the power lock itself)

Hope this helps

Mar 19, 2014 | 2000 Ford Explorer

1 Answer

I have a 2005 ford focus and the rear driver door will not close. This problem appeared seemingly out of nowhere and I can't figure out why. Any ideas?


check the latch in the door jam it should be up if it looks closed try lifting it with your finger if it doesnt go up try unlocking that door while you lift on it

Oct 06, 2013 | Cars & Trucks

1 Answer

The car is a 2005 Ford Focus ZXW. How do I cancel the child locks for the rear doors? I have looked at the small diagram on the door post, but am unable to find the "keyhole".


It is just a slot not realy a key hole. You could use a small screw driver too. Just look straight into the latch of the door and you will see a little slot, cream colored plastic I believe. Vertical is lock and horizontal is unlock. Try it and see what you can accomplish. I have a rear door that I can't get to lock which I am investigating right now.

Aug 18, 2010 | Ford Focus Cars & Trucks

1 Answer

Door handle is loose


I would reccommend sprying the latches that are mounted on the door itself. When the latches become dry they sometimes do not release. This should be done ever so often. Also the back doors may have child safety locks on them. If they do they will have a switch close to the latch assembly on the door that can be turned on or off. If this is on then the door will not open from the inside. Hope this helped you out, Roger

Feb 08, 2010 | 2000 Ford Focus

1 Answer

Front door won't close.. I presume that the mechanism is turned and needs righted. How do I do that?


If you look at the door where the latch is it is probably closed. You need to take a screwdriver and insert it in the closed part lift you're door handle and pull on the screw driver to reopen the latch.

Dec 29, 2009 | 2005 Ford Focus

1 Answer

The driver side door lock wont go all the way up.


The outside door handle spring is broke ,or the latch spring is broke. The only way to tell is remove the door panel and inspect the rod from the handle to latch. Look for broken spring on handle. I have installed an external spring from the handle rod to latch to keep the rod in the full up position.

Nov 18, 2009 | 1999 Ford Ranger SuperCab

Not finding what you are looking for?
2005 Ford Focus Logo

Related Topics:

148 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5522 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...