Question about Chrysler PT Cruiser

Open Question

I HAVE A 2006 pt cruiser the front driver side window will not go up, all the other Windows work fine, I do not here the motor. what could it be?

This has happened to this window before when the vehicle was under warranty and I don't know what they replaced.

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 82 Answers

SOURCE: power windows

First off does the window switch on the passenger side? if it does then you may just need the drivers side window switch. The front and the back windows work seperate from each other.

Posted on Jan 03, 2009

Ad
  • 1 Answer

SOURCE: pt cruiser power window problem

Yes I had the same problem , the battery died, and I needed to jump start the car.
When I went to open the windows the windows where not working and the power top would not come down. The smart windows got a glitch, no you may not need to go to the dealer for them to reset it.
This is what I did with some experimenting.
1) First charge your battery in the car,
2) disconnect the battery lead to the battery
3) while waiting 5 minutes clean your terminals on battery
4) check your fluids, tire pressure and filter Just for the heck of it
5) reconnect terminals on your battery
6) get in car and gently close the door, the window as you know will be up to high, but this will trick your smart windows to think its in normal position with the door close
7) start your car and hopefully it as booted up to normal.
I did find the first time I did disconnect the battery for a few seconds , this did not work,
it did not clear the memory out of the system.
The other thing was the when I waited 5 minutes the radio station memory was not lost.
Don't rush it,
Good luck and please give me some feed back.




Posted on Jan 04, 2009

  • 512 Answers

SOURCE: 01 PT Cruiser window won't go up Can hear motor

sounds like he broke the regulator and it will need replaced

Posted on Jan 05, 2009

highspeedsan
  • 61 Answers

SOURCE: 2006 chrysler PT Cruiser front wipers stopped working

Sounds like the wiper motor has died.

Posted on Apr 26, 2009

  • 1 Answer

SOURCE: 2001 PT Cruiser - blower and power windows stopped

Haven.t fixed it yet, but there is a bad wire or loose connection in a group of wires located behind the fuse panel. In the group of wires one of them is apparently the problem. When I move the wires the blower motor and power windows work, but they eventually stop again. I haven't had time to find and fix the exact wire that's the problem yet, it's not an area that I can easily get to!

RW

Posted on Jul 05, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My driver side window wont go up after i had to get a jump on my 2006 pt cruiser


If the other windows all work then you either have a switch issue or a window lift motor issue most likely. The system can be scanned for faults to verify the BCM control module is ok, it could have been damaged by improper battery jump starting.

Dec 27, 2016 | 2006 Chrysler PT Cruiser

1 Answer

Electric window will not work driver front side


And you want to know what ?

Obviously you need to do some testing

I never approach any vehicle without wiring
diagrams & window issues, usually involve removing
the inner door panel, to test switches,motor & checking
for a broken window regulator assy

Sep 26, 2014 | 2006 Chrysler PT Cruiser

1 Answer

How do i fix 2006 Pt cruiser elect window driver side front


You need to figure out if it is a bad switch, wire, supply voltage, or motor. Then replace the bad part.

Sep 26, 2014 | 2006 Chrysler PT Cruiser

1 Answer

Drivers door window does not roll up


you will more than likely have to change out the window regulator . these are gable drive and bind up in the motor area .
to test remove door panel and use a battery charger . There is 2 wires that goto the window motor . touch negative to one side and positive to other side . It will either go up or down . reverse the cables it will go the opposite way.

If it goes up and down fine then its your window Switch.
If it doesn't its your Regulator

Mar 24, 2014 | 2006 Chrysler PT Cruiser

1 Answer

My 2005 PT Crusier driver side windows won't work, front and back...passenger side both fine.??????


This sounds like the window motor is bad, try holding the switch in the up or down postion and bang on the inside of the door panel and if the window moves then you will know its the motor, the motor is the most common problem but testing would be nice to make sure, you would need to remove the door panel and with a test light test at the connector that plugs into motor,

Jan 03, 2011 | 2005 Chrysler PT Cruiser

1 Answer

2006 pt cruiser on drivers side rear turn signal


The turn signals flash depends on each and every bulb working correctly. When one bulb fails, you will notice a change in the flash frequency, as you describe.

Replace or repair the bulb that is not working, and you should be good to go.

Doc

Sep 14, 2009 | 2006 Chrysler PT Cruiser

2 Answers

Front windows don't roll down


Yes, the power window switch is often faulty, because there is some sensitive electronic making that "auto rolled down". The 4x-switch is quite expensive, 260EUR =( So, I make some new connection. The faulty electronic is only for front windows, so now I connect wires so that I can use front windows with read window switch. (Rear windows is still working by those 2xback window switch) which is located between seats. Here is the conncection, at one's own risk. That 4x-window switch has 14-pins connector: Connect the back windows wires 8(blue/white), 9(red/black), 1 (grey/blac ), 2 t(green/white) to the ground wire 4 (black). Front windows wires 14(blue)->8 13(white)->9 3(white/violet)->2 7(black/blue)->1 If the manufacturer didn't use that "auto rolled down" function, there is no worries of power windows. Also illumination of 4x-switch goes down quite soon, leds will be better. Here is a photo if you like replace bulbs to leds: http://www.ptcruiser.fi/ptgalleria/albums/userpics/10010/PT-Cruiser%20Power%20Window%20Switch%20-Lamp%20Replace.jpg

May 30, 2009 | 2002 Chrysler PT Cruiser

2 Answers

Power windows


First off does the window switch on the passenger side? if it does then you may just need the drivers side window switch. The front and the back windows work seperate from each other.

Dec 31, 2008 | 2002 Chrysler PT Cruiser

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

142 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8269 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...