Question about Toyota 4Runner
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Diagram is unnecessry.
Pull both front wheels
Work one at a time leaving the other for reference
Find the retention spring ... its a paperclip thickness wire spring... dislodge center retention loop and undo from both ends which engage brake pad retention rods.
Pull the rods out
Pull the old pads out... laying everything on the ground
Use scrap wooden wedges to pry between the rotor and the caliper ...inside and out until the calipers are fully withdrawn. Use the new pads to measure if they are far enough back.
Note... the brake fluid will have dropped in the master cylinder over many months of wear... do not fill it. When the calipers are pushed back they will fill the reservoir again... one wheel at a time.
Be sure to identify the correct pad based on what you took out and what is on the other side (if you screwed up the layout)
Make sure to take the old antisqueek backing plate from the old pad and place it on the new pad. They don't use lubricant on these anymore.
Replace the pads... the retention rods... then the retention spring
Do the other side
Then progressively step on the brake peddle until full tension is felt
Check the master cylinder reservoir... probably needs no additional fluid.
New pads will register in existing ridges in each disc in no time at all.
You should check the discs to see if they need to be replaced during this operation...using some calipers
Posted on Mar 25, 2009
I have to find out how to send you a picture, I can't do it on here for some reason. if you want give me your e-mail address and I'll send it to you.
Posted on Jan 05, 2010
1st coil goes to 2nd plug on lh side
2nd coil goes to 3rd plug on lh side
3rd coil goes to 1st plug on lh side
Posted on Feb 07, 2010
Testimonial: "Exactly what I needed, thanks"
Tips for a great answer:
Jul 31, 2012 | 1995 Toyota 4Runner
Feb 10, 2011 | Toyota 4Runner Cars & Trucks
Apr 12, 2010 | 1999 Toyota Tacoma PreRunner
Mar 15, 2010 | 1997 Toyota 4Runner
Nov 09, 2009 | 1998 Toyota 4Runner
Sep 30, 2009 | 1997 Toyota 4Runner
Jun 23, 2009 | 1998 Toyota 4Runner
Apr 14, 2009 | 1993 Toyota 4Runner
Feb 07, 2009 | 1998 Toyota 4Runner
72 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: