Question about 2008 GMC Sierra 1500

Open Question

08 gmc sierra cruse control fuse located - 2008 GMC Sierra 1500

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

mrgreenz
  • 962 Answers

SOURCE: 1998 GMC Sierra Signal Fuse Blowing

it seems you have a short in either one of the lights or interlock. all are connected to the same fuse. trace the wiring from the fuse box back to the component. Using a test light test in between the wires. check for any obvious breaks in the wiring.

Posted on Dec 06, 2008

  • 10 Answers

SOURCE: fuel pump fuse located on 1997 gmc sierra

The fuse is actually a Relay Switch and its located in the Fuse Relay Center on the driverside of the engine compartment. The Black Box is labled Fuse Relay Center, the diagram on the cap displays which Relay is the Fuel Pump relay...the Relay switch is usually $8-$15 depending on where you shop

Posted on Jul 28, 2009

  • 523 Answers

SOURCE: replace neutral safety switch on a 1988 gmc sierra

Typically the Neutral Safety Switches are located with the gear selector, either in the column or the floor.

Hope this helps,
Tom

Posted on Aug 21, 2009

  • 6 Answers

SOURCE: 2000 gmc sierra 1500 5.3 v8. a/c heater control problem

your heat/cool and vent selection options are controlled by engine vacuum through small clear tubes attached to the rear of your climate control interface. Other vehicles have small steel pull wires that operate the desired changes. You might try removing the trim and any fasteners affiliated with the interface/console. GENTLY pull outward and look to see if any of these tubes are pulled off or cut/damaged. Did anyone recently install a new stereo in the vehicle? If so, the vacuum tubing and or pull wires that change your outlets could have been damaged when the stereo unit was pushed into place. Hope this helps

Posted on Sep 09, 2009

Testimonial: "Very good information. THANKS!"

  • 1509 Answers

SOURCE: 2004 gmc 1500 sierra heater control stuck on

Defrost is the default position. Is the control a autyomatic temperture control unit? ( you set the temp and select automatic) if it is the system is completely electronic. You push the buttons and the control still says defrost or can you select something else and the control shows it but it just keeps coming out the defrost? If the control changes and the air comes out the defrost anyway and the cheack engine light isn't on, then the problem can be blown fuses or an air door actoater not working. Does the dash emit a clicking sound? if it does with the covers off the bottom of the dash reach around touching the different pieces till you touch the idem that is clicking. this is an acutor motor, or blend door motor. they have gears in them that wear out and break the motors aren't repairable and you just replace the ofending motor. the door that is moves can be stuck. and may have to be freed up with blaster, WD40, or other rust buster till it moves easy. maybe after getting the door to move smoothly you can get the old motor to move the door wiithout having to install a new one.

Posted on Jan 06, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Locate fuses for dash lights for 2007 GMC Sierra


could be. most fuse boxes have a chart of what fuses control what on the back side of the cover. try that.

Jan 09, 2016 | 2007 GMC Sierra 1500

1 Answer

Where is the back speaker fuse located on an '08 GMC Sierra truck


I don't think your speakers are fused.If your neither of your back speakers are working, you probably have a problem with your stereo itself.

May 26, 2014 | Cars & Trucks

1 Answer

Cruse control will not turn on


check both the relays & fuses for the cruise control, also if fitted exchange the circuit breakers.

Sep 13, 2012 | 2006 GMC Sierra

2 Answers

I own a 2003 GMC Sierra 1500. While I was working on the stereo today, my RPM gauge and speedometer stopped working. Also, my Gas meter, cruse control light, as well as my mileage gauge. What's...


im not certain, but i believe that the gauges are electronic. and when you were working on the radio you may have accidentally touched the wrong wires together shorting out the console. i would check the fuse cor the console.

Aug 21, 2011 | 2004 GMC Sierra

1 Answer

Need to find the fuse for the cruise control in a 2000 gmc seirra


Hello and welcome.Please refer to owners manual for fuse block and fuse location.Look in back of book and look up FUSES (fuses and Circuit breakers).Now locate CRUISE.This is the fuse for cruise control steering column control. I hope this answered your question.

Jun 15, 2011 | 2000 GMC Sierra

1 Answer

1994 GMC P/U's cruse control no longer works. Appears no power. Checked fuses in panel but no fuse by name of ''cruse'' and all fuses OK. Need diagram or schematic and/or help troubleshooting.


Does your turn signals, high headlight beam work? Also, does the AC function through the dash vents and not the defrost vents?

My cruise control quit and I found it was the vacuum lines running to the servo.

Aug 28, 2009 | 1994 GMC Safari

1 Answer

My head lights are stuck on high beams, and the turn signal lever will not click them of.so I need to see the inside of the stearing collum, if you have the blue prints of the collum for a GMC Sierra with...


after removing str wheel you'll need str wheel puller ( can rent one at parts store ) remove the leads that connect to cam plate. reverse for installation

shack

Apr 18, 2009 | 1994 GMC Sierra

1 Answer

Can't find Nav fuse


I have a 2008 GMC Sierra 2500HD Duramax and use the HyperTech software also. I assume you are talking about the installation instructions for HyperTech where it tells you to remove the ONStar and Radio fuse. Look in the owners manual for the fuse box layout under the hood. On mine, it's in the Duramax book and the only fuse that applies is the one listed for the Audio System. You will need to reset your clock when finished.

Sep 02, 2008 | 2008 GMC Sierra 2500HD 2WD

Not finding what you are looking for?
2008 GMC Sierra 1500 Logo

Related Topics:

103 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...