SOURCE: Replacing headlight in 1996 Chrysler Sebring JXI
piece of cake....
take off the two "star" bolts, one toward the center of the engine above the light assembly and the other toward the fender (it is very long). when you remove them both the entier assembly falls off into your hands and makes changing the bulbs much easier.
SOURCE: replacing headlight bulbs on a 2006 chrysler sebring
Behind the headlight you should see a eletrical wires running to the headlight section. There will be a 2 inch round plastic ring. You grap the back of the bulb and turn it to the right which will release the bulb and the socket. You pull out the bulb and replace it the same way. If this doesnt help then get back to me.
SOURCE: replace air filter 2002 Chrysler Sebring convertible
you need to loosen the clamp on the throttle body and unplug the map sensor then there are two clips on the other end pull that out and you should be able to pull the filter out you don't need to take the box off.
SOURCE: REPLACE ALTERNATOR 1999 CHRYSLER SEBRING CONV
Did a 2001 Chrysler Seabring 2.7L Remove right hand lower splash shield under the vehicle. Loosen the belt tensioner which will be two 13mm bolts. Discharge the A/C system. disconnect wiring from alternator and remove the three bolts from the alternor. Once the alternator is disconnected from the engine remove the low side A/C line from the A/C compressor and the alternator will come out through the top. It will be tight but it will come out
143 views
Usually answered in minutes!
×