They are indeed accessible from the back of the trunk. In your model year there are two or three plastic pins holding the carpet to the metal so you will not see the bulb and wires. Pull the pins out with pliers (might use a bit of force) and you shall uncover the secrete wires leading to the bulbs. Screw the bad one out and you can get a replacement from a parts store.
An expert who has achieved level 2 by getting 100 points
An expert that got 10 achievements.
An expert that got 5 achievements.
An expert whose answer got voted for 100 times.
Re: 1994 Toyota Camry Tailight Out
Tail lights on most newer cars are accessible by opening the trunk and locating the rear of the tail light then just grabbing and twisting the plastic bulge (bulb assembly) where the wire goes, allowing you to remove the bulb assembly and replace the bulb! Good Luck!
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
If you have a beebing noise every time you press on the brake, it is because a tail light is burnt out. There are two filaments in each brake light. Therefore, when you turn on your hazards, it will appear that both tail lights work properly. The beebing warning sound is actually a feature that Dodge put in the Rams so drivers would know their tale light is out. Just replace the tail light bulb, and the beebing will automatically cease. To get the tail light housing out, you will need a torex screw driver. Also, you twist the bulb housing out as opposed to pulling it out. There are three prongs that twist out.
I had this same symptom after I pulled a trailer that had light "issues". I tried wiggling the trailer light connector around until the trailer lights begin working. Next think I know they were not working again and now my left tail light was out. I thought it odd that is wasn't both lights out being on the same fuse, but checked wiring etc with no problems found. Mine turned out to be the "left tail light fuse" in the engine compartment fuse box. All of the parking and tail lights as independently fuse, You can tell which one it is by the guide on the fuse box lid. You will be looking for a 10 amp (red) fuse near the center of the fuse box.