Question about 1990 Toyota 4Runner

Open Question

My automatic handle shifter is loose in my 1990 toyota 4 Runner

My automatic transmission shifter handle is loose in my 1990 toyota 4 Runner

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 247 Answers

SOURCE: Transmission not engaging

is it manual or automatic transmission?

Posted on Dec 18, 2008

  • 1 Answer

SOURCE: 1990 Toyota Cressida Engine Swap

what is required to put a 6mge engine in a 1986 cressida?

Posted on Mar 20, 2009

  • 10 Answers

SOURCE: 1990 toyota 4runner 4x4 wont lock in front wheels

your drive shaft thats turning is mabe broke or your automatic 4x4 lockers could be bad

Posted on Apr 10, 2009

  • 27 Answers

SOURCE: 2007 Toyota 4 runner transmission filter and fluid change??

at 50,000 miles there is really no need. i would wait and save up that money and do a transmission flush 7- 10 quarts of toyota f-type fluid can be costly but a flush removes all of the fluid and garnish along with any fine shavings (normal wear and tear) out of the tranny and replaces it with new clean fluid. normal intervals would be at about 80-100,000 miles. you should be able to find preventative maintenance schedules in your owners manual. if not any repair facility would have it on their computer.

Posted on May 30, 2009

  • 1509 Answers

SOURCE: fuel pump relay location for toyota 1990 4 runner

90 4 runner fuel pump relay? with the 3.0 engine. It's on the right side of the engine bay ( sitting in the drivers seat) it's lables EFI main relay. It's marked non the cover and theres fuses too in the same box.

Posted on Dec 02, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Car will roll while off and in gear


I am assuming this is an automatic transmission? It is possible your shifter cable or linkage got knocked out of adjustment but most likely the "Park "pawl has either come loose or is broken. It is a lever with a hook like shape that engages into a slotted ring at the output of the transmission.

Heavy duty trucks with Allison automatic transmissions do not have Park on the shifter because the "park pawl" couldn't handle the stress from the heavy loads twisting the driveshaft. Always set your park brake, even on level ground on all cars & trucks with automatic transmissions.

I hope it is just a shifter adjustment otherwise the transmission will have to be removed, disassembled, park pawl replaced.

Mar 26, 2014 | 1990 Ford Mustang

1 Answer

On a toyota 1990 four runner 4 wheel drive automatic is the transfer case attached to the transmission and have to come out all as one peice.


YES THE TRANSFER CASE IS JOIN TO THE TRANSMISSION IT CAN BE REMOVED BUT ITS MUCH EASIER TO REMOVE IT AS ONE UNIT THEN SEPERATE IT ON THE BENCH

Jul 21, 2011 | 1990 Toyota 4Runner

1 Answer

Starter removal on a 1990 toyota 4 runner. Where


it is not fun w/o lift look behind passenger wheel you will need to raise front end remove wheel ,remove skid pan,and of course battery ends if 4wd I highly reccomend a lift good luck and please rate this

May 05, 2010 | 1990 Toyota 4Runner

1 Answer

Removing gas tank on a 1990 toyota 4-runner. is it hard to remove?


thr hardest thing about removing the tank is getting the hoses loose. Try also to have as little of gas so tank will be easier to handle

Mar 14, 2010 | 1990 Toyota 4Runner

1 Answer

My 1990 toyota 4 Runner has a v low rpm while in


on the cable of the accelerator,there is an adjuster to its an,so you can adjust it here to rev it a little ,at 750 rpm,

Aug 19, 2009 | 1990 Toyota 4Runner

1 Answer

1990 toyota 4runner 4x4 wont lock in front wheels


your drive shaft thats turning is mabe broke or your automatic 4x4 lockers could be bad

Feb 24, 2009 | 1990 Toyota 4Runner

2 Answers

Transmission not engaging


is it manual or automatic transmission?

Dec 18, 2008 | 1990 Toyota 4Runner

1 Answer

1992 toyota 4 runner 4wd v6


There is an electronic module called ECT under the dash that controls the transmission ( a small computer), however if you had your vehicle serviced in the recent past the wiring connector (a 3 Pin connector) under the Drivers side (LHD) just before the T/case could have become loose or the wires broken, check this connector out.

Sep 01, 2008 | 1992 Toyota 4Runner

Not finding what you are looking for?
1990 Toyota 4Runner Logo

Related Topics:

85 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...