Question about 1992 Oldsmobile Ninety Eight Regency

1 Answer

I just changed the blower motor in my ols regency elite and still no blower...just a fuse or what?

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.


    An expert that has over 500 points.


    An expert whose answer got voted for 20 times.

  • Expert
  • 196 Answers

Sounds like the blower motor resistor to me check the fuses and the see if you have any power to the resistor

Posted on Jan 18, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Hello. I have a 1990 oldsmobile 98 regency elite and I can't get the blower motor to work. I tested all the wires for currency and they good. I also changed out the resistor as well with both relays. I...

There have to be something you missed during your troubleshoot. If the switch to turn on the a/c is good, since it turns on the a/c compressor, then it must be a wire that it's not connecting, or (not sure if there is any in these vehicle) a sensor, which controls the speed of the a/c blower. I'm sharing this because I took apart my vehicle's a/c blower motor, and right at the firewall, there was a sensor. If that is damage, then the blower won't work.

Oct 10, 2014 | Cars & Trucks

1 Answer

Heat turns on - blower motor not working. 1997 olds regency

check fuses if they are still good change the blower motor instructions below not hard to do!
  • Disconnect the negative battery cable.
  • Disconnect the blower motor lead connector from the wiring harness connector.
  • Remove the blower motor cooling tube from the blower motor.
  • Remove the four retaining screws.
  • Turn the motor and the wheel assembly slightly to the right so that the bottom edge of the mounting plate follows the contour of the wheel well splash panel.
  • Lift up on the blower and remove it from the blower housing.
  • Installation the new blower motor by reversing the removal steps.
  • Connect the negative battery cable.
  • Dec 26, 2010 | 1997 Oldsmobile Regency

    1 Answer

    Blower motor stays on even with key out 1994 olds ninety eight with climate control

    You need a blower motor resistor. If you have automatic temp control be prepared to spend a few dollars getting one. They put the resistor under the fuse panel by the firewall.

    Aug 17, 2010 | 1994 Oldsmobile Ninety Eight Regency

    3 Answers

    1991 Olds 98 Elite heater blower motor continues to run with key off. Will change speeds with controls but will NOT shut off..

    if you haven't got your blower fan fixed yet, im sure it to be the same as mine, the blower motor relay which is out on the firewall under the big fuse block. take plastic cover off over the fuses and move the fuse block out of the way and you will see it staight under that. should be two screws holding it on.

    Mar 05, 2010 | 1991 Oldsmobile Ninety Eight Regency

    1 Answer

    No heat or air blowing out my blower have already changed the blower motor still nothing

    I would check the fuses to be sure no issue there, then... I would check the blower resistors next. This should be a module very near or mounted to the blower motor.

    Nov 15, 2009 | 1995 Oldsmobile Ninety Eight Regency

    1 Answer

    1991 olds 98 regncy elite blower motor not working

    There is a fusible link for the blower motor. Check that. Don't know where it is. Look up the wiring diagram at Also check the fuse in the fuse box. Could just be that.

    Feb 24, 2009 | 1991 Oldsmobile Ninety Eight Regency

    1 Answer

    Trunk lid closer will not work, fuse is good.

    prbably looking at replacing the motor and gear assembly, gm had lots of problems due to slamming of the lid too hard

    Nov 18, 2008 | 1992 Oldsmobile Ninety Eight Regency

    Not finding what you are looking for?
    Cars & Trucks Logo

    Related Topics:

    170 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Oldsmobile Experts


    Level 3 Expert

    77499 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22306 Answers

    Jeffrey Turcotte
    Jeffrey Turcotte

    Level 3 Expert

    8826 Answers

    Are you an Oldsmobile Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides