Question about 2007 Jeep Wrangler Unlimited Rubicon 2 Doors
Test the alternator charging capability by connecting a volt meter to the battery terminals and starting the engine. The voltage should be at least 13 VDC.
If it's less it will not charge the battery enough.
Hope this helps.
Posted on Mar 29, 2015
By your description, it sounds like you may have a starter problem. The main wire from the battery may be loose on the starter end.as well. If you do any off roading this would be typical as well as corrosion. There is an ignition relay as well, and a fuse for the ignition. This I believe may be under the hood in a plastic box. I would check fuses first, then have a look at the starter and wires. Starters are known to go without warning. If this jeep is a manual transmission, I would try to start it by coasting and catching it in gear. If the jeep starts, it is in the starter,or wiring. Ground wire included. if not, the problem lies elsewhere. keep me posted
Posted on Jan 02, 2013
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
2003 4.0 lt jeep rubicon hit a big bump and it stalled cranks over fine but not firing checked all fuses, ok. fuel pump not on , connect direct and it works but not with key. starts for couple secs. when put fuel in throd body. any idea why not starting?
Posted on Aug 04, 2009
SOURCE: 2006 Jeep Wrangler won't start
First, make sure you can turn the engine by hand. If you can't then the starter can't turn it either. Have someone else turn the key and look for the source of the click...may be a relay. Go over the starting circuit with a volt meter. Check for power at the starter main terminal and then with the key turned to "start" check for power at the trigger terminal on the starter. Check battery voltage and check relay operation.
You have a neutral safety switch on the transmission if its an automatic and a clutch switch if it's a stick. Check them as well. Make sure battery grounding on fender and block are also clean and secure.
Posted on Oct 02, 2009
Testimonial: "Will try! Thanks!"
yes, sounds like the starter solinoid whent out, if it shorts out it can stay running, it must be replaced ,there is no quick fix, if its a manual trans you can push start it. i dont know of any internet tips.
Posted on Oct 15, 2009
Tips for a great answer:
Aug 06, 2014 | 2007 Jeep Wrangler 3.8
Sep 23, 2010 | 2007 Jeep Wrangler Unlimited Rubicon 2...
Aug 29, 2010 | 2007 Jeep Wrangler Unlimited Rubicon 2...
Jan 31, 2010 | 1990 Jeep Wrangler
Oct 04, 2009 | 2007 Jeep Wrangler Unlimited Rubicon 2...
Feb 25, 2009 | 1989 Jeep Wrangler
Jan 02, 2009 | 2007 Jeep Wrangler Unlimited Rubicon 2...
May 25, 2014 | 2007 Jeep Wrangler Unlimited Rubicon 2...
196 people viewed this question
Usually answered in minutes!