Question about 2000 Honda Odyssey

Open Question

2000 honda odessy rough start and wont stay running

Recently aquired the mini van and the check engine light came on threw a po420 code so i replaced the egr valve tha van ran great for two weeks then i was leaving my local walmart and the van died in the middle of the intersection. it started after several attempts but idled extremely rough and every time i pushed the accelerator the van died imidiately i replaced the fuel pump and it has not improved the situation . any suggestions would be greatly appreciated

Posted by on

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 12 Answers

SOURCE: Check Engine Light on 2000 Honda Odyssey

The problem with an aftermarket catalytic convertor is the quality of the material that is in them. Used factory Honda convertors can be sold for 75 dollars. A used aftermarket catalytic convertor will sell for 5 dollars. If u truely want to fix this problem, you need to save up for a new Honda convertor and buy it.

Tom

Posted on Oct 24, 2009

  • 1374 Answers

SOURCE: 2000 v6 honda accord starting problems

Need to know what type of EGR valave you have (Negative Backpressure , Positive backpressure , Pulse wWdth Modulated or ported. You can use the shop manual and *** will tell you how to Diagnosis it or write me and I will. the diagnosis is pretty simple on any type and the repair is gonna be replacement , cleaning, or bad wiring or ECU problem. keep me posted

Posted on Mar 13, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2003 honda odessy and dash lights and tail light are not working! Please help?


Both are separate fuses, check them first. Dash lights are controlled threw the dimmer switch. Park lights threw the turn signal switch. If you have front marker lights, then the rear is a ground problem. Ground is at the body, in the back, on the drivers side. If no marker lights at all , replace the turn signal switch. If the fuse is good for the dash, replace the dimmer switch.

Jun 28, 2015 | Honda Cars & Trucks

1 Answer

The check engine light on my 2007 Dodge Magnum flashes 7 times,what's that mean?


Hello I have a 2007 Magnum 2.7L that has code p0302 cylinder#2 misfire seems to have coolant loss but can find no leaks. Recently had another code p0300, so both are active check engine light started flashing but stop and stayed solid. Not driving it. Replaced spark plugs should I replace coils? Any feedback please.

Jan 17, 2012 | 2007 Dodge Magnum SE

1 Answer

S2000 runs rough, has about half power and stalls at stops


your probably not firing on the #4 cylinder. Is there a CEL? (check engine light?

Take the car to any local mechanic and ask them to pull the check enginge light diagnostic codes for you using an obd scanner. It shoudl cost at most about 5 dollars.

They wil lgive you a list of the recent codes. and what they are. Then get yoru car to honda asap

Jun 04, 2011 | 2000 Honda S2000

1 Answer

2000 GMC Safari van v6 180,000 miles. 2 years running po420 code comes up and reset with a code reader. Works good for that. Slight miss at 60mph plus loaded and pulling, so I drive at 58mph. Then the...


P0101 is the MAF sensor and if it has even a tiny amountof crud on it, it can keep the dar from running. clean with ELECTRONICS cleaner not carb/brake spray.

P0300 is multiple misfire detected. Sound like it might need tune-up parts

P0420 is the catalyst system bank 1 low efficiency.

I would start with changing the plugs, wires, cap and rotor. And clean the MAF sensor with the proper cleaner. Then see if the car starts and idles. If it does then clear the codes. If it doesn't run right then I would suspect the MAF sensor is kaput. The P0420 code can be caused by a poorly running engine.

Dec 31, 2010 | GMC Safari Cars & Trucks

1 Answer

Replace side passenger mirror 2000 Honda Odessy Van EX


You need to remove the internal door panel, then you can see the screw to remove the side mirror. Sometime you need to remove the glass before you can reach the screw.

Mar 24, 2010 | 2000 Honda Odyssey

1 Answer

Honda civic 2000 problem code PO420


P0420: Calayst system efficiency below threshold (Bank no. 1)
You can clear the code by turning your engine off, locating fuse number 12 in your under hood fuse box (backup, radio 7.5A) and pulling that fuse for about 10 seconds. If the code comes back, it was not a glitch and I would have the code checked out (has to do with you catalytic converter, I believe).
Hope this helps you.

Nov 22, 2009 | 2000 Honda Civic

2 Answers

Check Engine Light on 2000 Honda Odyssey


what is the code that turned the light back on?????? if its a P0420, the cat is not good enough. you may need one good enough for California or a better quality converter.

Oct 22, 2009 | 2000 Honda Odyssey

Not finding what you are looking for?
2000 Honda Odyssey Logo

Related Topics:

30 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...