Question about 2007 Ford Sport Trac Limited

Open Question

How do i remove the door panel of a 2007 ford sport trac

I want to replace the stock speaker

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 41 Answers

SOURCE: replace speakers on Ford Explorer Sport Trac

The front and rear door panels must be removed. The interior door handle will have to be removed, and the power window switch will also have be removed. This is held in by metal clips that secure it to the door panel. Do not be afraid to use a little force to get under the switch panel, and pry it from the door panel. Once you have all accessories off of the door panel, look for what may appear to be "plugs" in the door panel. These may conceal the presence of a screw. Also, check around the interior door pull for screws or "plugs". When this is done, use a medium to large screwdriver, or a trim removal tool, and start prying the door panel away from the door. Start at the bottom, and work your way around the door, until you get about 2-3 inches from the top of the panel where it meets the window. When you are at this point front and rear, simply lift up on the door panel, and it should come off easily. Once the panel is removed, you will easily find the speakers.

Posted on Nov 11, 2008

  • 43 Answers

SOURCE: door panel removal

carefully start at bottom of panel & pry away with door open ,but make sure you take any screws out holding on most are in handle area, along with any wire harness connections should be held to door with button rivets (small plastic pressure rings)once all are lose inside panel should lift up off door.

Posted on Jan 06, 2009

  • 840 Answers

SOURCE: 2005 ford sport trac

Well their should be screws under little caps take those out and a cap near the mirror. and then you should be able to slide upward and get the trim panel off

Posted on Jan 24, 2009

michigan man
  • 3533 Answers

SOURCE: changing outside door handle drivers door

first disconnect the negative side of battery and then open the door and start looking for small black screws or nuts then remove you find some hidden behind what look like little doors that you will need to remove with a screw driver becareful not to pry the plastic completely out of the door panel itself because if this happens you will have to figure out a way to repair so the panel will stay on the door get a thin pry bar to this job or a butter knife

Posted on Jan 05, 2009

chuck943
  • 783 Answers

SOURCE: 2007 FORD EXPLORER SPORT TRAC 4X4 Change oil light on

Press and hold the SELECT/RESET
control switch to select SYSTEM
CHECK when “SYSTEM CHECK /
HOLD RESET” is displayed in the
message center. Selecting this
function from the SETUP MENU
causes the message center to cycle through each of the systems being
monitored. For each of the monitored systems, the message center will
indicate either an OK message or a warning message for two seconds.
Pressing the SELECT/RESET control switch cycles the message center
through each of the systems being monitored.

The sequence of the system check report and how it appears in the
message center is as follows:
1. OIL LIFE RESET
2. CHARGING SYSTEM
3. WASHER FLUID
4. DOOR AJAR
5. EXTERIOR LAMP
6. BRAKE SYSTEM
7. PARK BRAKE
8. MILES TO EMPTY
9. FUEL LEVEL LOW (will only display if 50 miles or less to empty)
To reset the oil monitoring system to 100% after each oil change
[approximately 5,000 miles (8,000 km) or 180 days] perform the
following:
1. Enter SYSTEM CHECK to display
“OIL XXX% RESET IF NEW”.
2. Press SELECT/RESET control
switch to display “HOLD RESET IF
NEW OIL”.
3. Press and hold the
SELECT/RESET control switch for
more than 2 seconds. Oil life is set
to 100% and “OIL CHANGE SET TO
100%” is displayed.

Posted on Apr 02, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to replace headlight bulb on 2007 ford explorer sport trac


How To Install Replace Headlight Ford Explorer Sport Trac ...

? 4:28
https://www.youtube.com/watch?v=NzMVcCsZ860
May 11, 2010 - Uploaded by 1A Auto Parts
How To Install Replace Headlight Ford Explorer Sport Trac 01-05 1AAuto. .... We offer the replacement headlights on our website for your truck.

Jan 11, 2016 | 2007 Ford Explorer Sport Trac

2 Answers

On a 2007 ford explorer sport trac how to change the fuel pump


The "quick disconnect" fittings for the fuel lines are usually problematic to disconnect unless you use this tip. The fittings get full of dirt over time. First, use compressed air to blow out the dirt. Then spray the connection with penetrating oil. Now insert your disconnect tool and it will come apart much easier. It's also easier to disconnect all the hoses & electrical connectors after dropping the tank down about 6 to 12 inches. Below is a video which shows how to do this job. Do yourself a favor. When you re-install the tank, apply anti seize compound to the threads of the mounting bolts. That way, if you ever have to remove it again in the future, those bolts will come out easily.


Fuel pump replacement Ford Explorer 2005 2010 Install Remove Replace...

Feb 04, 2011 | 2007 Ford Explorer Sport Trac

1 Answer

Remove inner panel drivers door on sport trac


Take out the screws around the inner handle. Gently pry around the edges of the door panel to remove the plastic clips. Lift up slightly to get the upper edge loose. Pull out slowly to reveal the plug leading to the back of the power master switch (door locks and windows controls)

Feb 25, 2010 | 2002 Ford Explorer Sport Trac

1 Answer

My drivers side electric window stop working 2002 ford sport trac. how do you change the motor


To remove the door panel, phillips head door screws should be removed, and the panel should slide up. Next, unbolt the window from the regulator and remove the window from the door. Then unbolt the regulator. The regulator and the motor have to be removed together. The motor will be mounted to the door on the inside. There should be three screws or nuts (10mm) holding the motor in. Remove motor and regulator. Reverse to reinstall.

Jul 11, 2009 | 2002 Ford Explorer Sport Trac

1 Answer

AUDIO ISSUES !!


you have probably blown a few speakers... all of the speakers are in the door panels. the easiest way to test them is to hook a known good speaker up to that connector, if the good speaker works you have a blown speaker. you should check to see if someone hasn't adjusted the fade or balance in the stereo settings first, the door panels can be a pain to get off and break very easily...hope this helps good luck!

May 20, 2009 | 2003 Ford Explorer Sport Trac

1 Answer

I have a 2007 sport trac with the overhead console and sun roof. i would like to change the map lights but after removing the lens it looks like i may have to remove the whole console just to replace the...


Looks like it is pretty easily removed.

Use a small screw driver and pry open the garage door opener storage bin. You will see 1 screw there that you will remove.
Pull the front of the overhead console down and remove the console from the console retaining clips.

Feb 22, 2009 | 2007 Ford Explorer Sport Trac

1 Answer

Door panel removal


carefully start at bottom of panel & pry away with door open ,but make sure you take any screws out holding on most are in handle area, along with any wire harness connections should be held to door with button rivets (small plastic pressure rings)once all are lose inside panel should lift up off door.

Jan 06, 2009 | 2002 Ford Explorer Sport Trac

1 Answer

Replace speakers on Ford Explorer Sport Trac


The front and rear door panels must be removed. The interior door handle will have to be removed, and the power window switch will also have be removed. This is held in by metal clips that secure it to the door panel. Do not be afraid to use a little force to get under the switch panel, and pry it from the door panel. Once you have all accessories off of the door panel, look for what may appear to be "plugs" in the door panel. These may conceal the presence of a screw. Also, check around the interior door pull for screws or "plugs". When this is done, use a medium to large screwdriver, or a trim removal tool, and start prying the door panel away from the door. Start at the bottom, and work your way around the door, until you get about 2-3 inches from the top of the panel where it meets the window. When you are at this point front and rear, simply lift up on the door panel, and it should come off easily. Once the panel is removed, you will easily find the speakers.

Nov 11, 2008 | 2005 Ford Explorer Sport Trac

Not finding what you are looking for?
2007 Ford Sport Trac Limited Logo

76 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5467 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...