Question about Cars & Trucks

Open Question

How can I fix a luggage wheel cannot get replacement

Call them they do not have replacement for this item

Posted by on

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Problem with rear Suspension IX35 Hylander

could be the rear shocks, but if you read the owners book. they don't suggest having heavy loads. 30kg does not seem like a lot. have you tried an 4 wheel alignment. first they can tell you if it needs one. second if there is a problem they should tell you what needs to be fix.

Jan 22, 2015 | Cars & Trucks

1 Answer

How do I change a wheel on a piece of rollon luggage?

if you have a rivet gun you might be able to change it out (pry the old rivets out and attach the new wheel). Remember though that handyman guns are lightweight and the new rivets will probably not be as strong as the originals.

Dec 19, 2014 | Cars & Trucks

1 Answer

How legal is it to remove a front passenger seat and replace it several months later?

it is illegal to carry unrestrained anything in the front of the car. If you need more space to carry luggage then get a van or small truck. It is not difficult to imagine what would happen to other motorists if you hit a pot hole and all that baggage fell on you and how you would loose control of the vehicle . Come on it is just common sense to restrain all items behind you . A car is designed to carry passengers --NOT FREIGHT.

Jul 15, 2014 | 2011 Citroen Berlingo 1.6

1 Answer

Sable 2000 location fuse box location on vechicle

There are five locations for fuses on your vehicle.

1. Battery Junction Box (Front center of engine compartment, behind radiator)

2. Central Junction Box (Under left side of dash)

3. In-Line Fuse (In luggage compartment above left rear wheel well)

4. Relay Center Box No.1 (Under left side of dash)

5. Relay Center Box No.2 (Under left side of dash)

What, exactly, are you trying to fix?

Please review this article:

Where's The Fuse?

Jul 06, 2011 | 2000 Mercury Sable

1 Answer

Hi. My Toyota Camry 1995 was failed in Rear Breaks test on breaks' capacity measuring machine by NZ Vehicle Testing despite replacing Break Drums and Break Pads with new ones. The cuase is adhered to...

The prop/valve is located near the rear of the car and is inbetween the front brakes and the rear brakes.It's job is to adjust the braking force between the front and rear wheels.If only one person is in the car,you get more braking force at the front wheels.If you have 4 people in the car and the boot is full of luggage,you will get more brake force directed to the rear brakes.What it prevents is the car from spinning out from a rear wheel lockup.
It will be located by looking at the rear suspension.A smallish metal rod will connect the suspension to the chassis of the car and it will be hooked up with the brake lines.As weight is loaded to the rear suspension,the rod will slightly move a small lever on the prop/valve.This is where you will see the adjustment.
Hope this helps you

Apr 15, 2011 | 1995 Toyota Camry

2 Answers

Luggage cover missing needed to purchase a new one as it went missing, where and how much would it be?

check this out....

Feb 04, 2010 | 2008 Hyundai Tucson

1 Answer

My 98 Cadillac DeVille rear air suspension system works great UNTIL I load weighted luggage in trunk and passengers in back seat. I then drive around for 15 to 45 minutes and thats when the rear end of the...

Common problem on all air suspension vehicles. It could be that there is a hairline crack in one of the shock bladders or that the pump is just too weak to pump up to it's intended pressure, a sensor or solenoid could also be bad.

Whenever I run into this problem I order a spring conversion kit for that vehicle, it is usually not worth spending $3000+ to repair the suspension. sells the best kits, $327.00 for the rear. It also comes with a resistor so that your suspension light is not on.

Sep 19, 2009 | 1998 Cadillac DeVille

1 Answer

Right rear signal light needs replacing

you need to remove the lamp assembly to replace the bulb. here is the procedure:

Rear Lamp Assembly —Sable Four Door Removal and Installation
  1. Remove the luggage compartment scuff plate.
  1. Pull back the luggage compartment carpet.
  1. Disconnect the rear lamp assembly electrical connector.
  1. Remove the nuts.
  1. Remove the rear lamp assembly.
    1. Pull the lamp assembly away from the body.
    1. Disconnect the rear lamp assembly bulb connectors.
    1. Remove the rear lamp assembly.
  1. s1h~us~en~file=ani_caut.gif~gen~ref.gif CAUTION: To prevent water from entering the luggage compartment, make sure the rubber grommet is fully seated.
    To install, reverse the removal procedure.

Jun 25, 2009 | 2001 Mercury Sable

3 Answers

Horn blows when steering wheel is turned. Is is a short?

this is caused by a defective/shorted rotating ribbon contact under the steering wheel called a clock spring, to replace this part u must disarm the airbag remove it and the steering wheel and then replace the clock spring, this is a dealer only part.

May 15, 2009 | 1999 Chrysler Cirrus

1 Answer

Luggage compartment release button

I had a silimar problem an strange as it sounds replacing the rubber gasket around the top of the trunk fixed it. I had a leak and had to replace the gasket and also the remote wouldn't pop the truck. Jag dealer wanted to replace the entire trunk release mechanism (surprise, usual rip off) for several hundred dollars. I didn't do it and, good surprise, replacing the leaking gasket fixed the trunck release problem.

Oct 29, 2008 | 2003 Jaguar S-Type

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides